Summary of the content on the page No. 1
USER'S GUIDE
59M5 SERIES 220-240V
2
Thank You
3
Safety Instructions
4
Product View
5
Assembly
6-9
Operations
10-12
Maintenance and Care
13
Troubleshooting
14
Replacement Parts
15
Warranty
16
Consumer Services
Summary of the content on the page No. 2
Thanks for buying a BISSELL Cleanview™ Pet Ultimate We’re glad you purchased a BISSELL bagged cylinder vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your BISSELL bagged cylinder vacuum is well made, and we back it with a limited one year warranty. We also stand behind it with a knowledgeable, dedicated Consumer Services department, so, should you ever have a problem, you’ll receive fast, considerate assis
Summary of the content on the page No. 3
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, ■ Young children should be supervised to ensure basic precautions should be observed, that they do not play with the appliance. including the following: ■ Remove plug from electrical outlet before cleaning or maintaining the appliance. REAd ALL ■ If the supply cord is damaged, it must be replaced by the manufacturer or its service INSTRUCTIONS agent in order to avoid a hazard. BEFORE USINg YOUR ■ Do not pick up toxic
Summary of the content on the page No. 4
Product view Handle Air Flow Regulator Flex Hose CAUTION: Do not plug in your vacuum cleaner until you are familiar with all instructions and operating procedures. Swivel Hose Telescoping Extension Wand Variable Suction Power Control Power Button Automatic Cord n Rewind Butto Brush Switch Bag Change Indicator Carry Handle Multi-Surface Pet Hair Lifter Post-Motor Floor Nozzle HEPA Media Filter* ™ Pet Pet Tool Pet Contour Tool Combination Accessory Bag ™ TurboBrush Adaptor Crevice
Summary of the content on the page No. 5
Assembly Assembling your vacuum 1. Connect swivel hose by squeezing both WARNING: Plastic film can be dangerous. To locking buttons and inserting it into the avoid danger of suffocation, keep suction opening on the canister. Once away from babies and children. the swivel hose is inserted in the suction opening, release the locking buttons. 1. 2. 2. Connect telescoping extension wand to the handle end of the flex hose. Twist slightly to tighten. 3. Attach the tool holder to the telesc
Summary of the content on the page No. 6
Operations Power cord The power cord is located at the rear of the vacuum. Gently pull out the power cord, watching for the yellow line. Stop pulling the power cord once the yellow line is visible. There is also a red line, which indi- cates the end of the usable cord. Automatic Do not pull the power cord out Cord beyond the red line. Rewind Button Automatic cord rewind Your vacuum is equipped with an automatic cord rewind. When cleaning is finished, press the power button OFF and
Summary of the content on the page No. 7
Operations Your BISSELL Cleanview Pet Ultimate Tip is not only a powerful carpet and rug Before cleaning under vacuum cleaner, it’s also a versatile low furniture, check above floor vacuum cleaner when area first for objects you select one of the special tools. that might harm the unit or block the hose. Pet Tool Adapter: The Pet Tool Adapter must be attached to the handle end of the flex hose to use the Pet Contour Tool and the Wide Pet TurboBrush. The narrow end of the adapter atta
Summary of the content on the page No. 8
Operations Pet Hair Eraser Floor Nozzle Use to pick up pet hair from rugs and carpeted surfaces. Just vacuum like Notice: These tools are designed to remove you normally would. The Pet Hair pet hair from upholstered or carpeted Lifter will grab pet hair when you pull surfaces. They should not be used on pets. back and it will release the hair and suction it up when you push forward. NOTE: Turn the vacuum off before you flip up or flip down the Pet 1. Brush Up Hair Lifter. 1. To vacuum
Summary of the content on the page No. 9
Operations Variable suction power control The variable suction power control is located on the top of the vacuum. Slide the control toward the larger dots for maximum suction. Slide the control toward the smaller dots to minimize suction for lightly soiled areas or delicate fabrics. Air flow regulator Open the air flow regulator by sliding the regulator back towards the handle to an open position to reduce suction for delicate fabrics. Close the air flow regulator by sliding the regu
Summary of the content on the page No. 10
Maintenance and care Dust bag replacement 1. Unplug the vacuum from electrical outlet. 2. Open the dust bag compartment by 2. lifting up on the latch on the door on the front of the vacuum. 3. Lift out the dust bag holder and dust bag. 4. Release the dust bag from the holder by pressing the dust bag holder clip 3. and pulling the dust bag out of the holder. Discard the used dust bag. 5. Slide the new dust bag into the holder by inserting the dust bag into the tabs located at the bott
Summary of the content on the page No. 11
Maintenance and care Cleaning the pre-motor filter NOTICE: The pre-motor filter protects the This product is intended for house- motor from dirt and dust particles. hold use only and not for commercial 1. Unplug the vacuum from electrical outlet. or industrial use. Vacuuming of dust from products like plaster, concrete 2. Open the dust bag compartment by or ashes will damage the motor and void the warranty. lifting up on the latch on the door at the front of the vacuum. Lift out the
Summary of the content on the page No. 12
Maintenance and care Replacing the post-motor HEPA media filter* The post-motor filter is a H13 HEPA media filter* which assists in the filtration process to return clean air to the room. 2. 1. Unplug the vacuum from electrical outlet. 2. Remove the filter door (located on the rear of the vacuum) by pulling up on the filter door latch. 3. Remove the post-motor filter by grasping the lip of the filter frame and pulling up. 4. Replace the post-motor filter with a 3. new filter. NOTE: Th
Summary of the content on the page No. 13
Troubleshooting WARNING: To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting. Vacuum cleaner won’t run Possible causes Remedies 1. Vacuum cleaner is not plugged in 1. Check electrical plug 2. Power button is not pressed down 2. Press power button down Vacuum cleaner won’t pick up or low suction Possible causes Remedies 1. Tools, flex hose and/or telescoping 1. Remove each part and check for blo
Summary of the content on the page No. 14
Replacement parts Item Part No. Part Name 1 203-7270 Dust Bag (3pk) 2 203-7268 Pre-Motor Filter 3 203-7269 Post-Motor HEPA Media Filter* 4 203-7275 Pet Hair Eraser Floor Nozzle 5 203-7277 Pet Hair Lifter 6 203-7257 Flexible Hose with Handle 7 203-7256 Telescoping Extension Wand 8 203-7279 Pet Tool Adaptor 9 203-1291 Pet Contour Tool 10 203-1290 TurboBrush™ Pet Tool 11 203-7280 Combination Crevice Tool/Dusting Brush 12 203-7278 Accessory Bag 2 3 4 1 5 6 7 8 9 10 11 12 *The Filter Media,
Summary of the content on the page No. 15
Warranty This warranty gives you specific legal rights, and you may also have other rights which may vary from country to country. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Services by telephone, or regular post as described below, or contact your local in country distributor. Limited One Year Warranty Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, BISSELL Homecare, Inc., will rep
Summary of the content on the page No. 16
BISSELL consumer services If your BISSELL product should require service: Call BISSELL Consumer Services at the numbers below and we will give you the location of a BISSELL Authorized Service Center in your area. For all other countries, contact your local in country distributor for questions, service, or repair. If you have questions about your warranty or need replacement parts please contact the numbers below. For UK inquiries: For all other inquiries: Monday - Thursday 9 am — 5 pm Monda
