Summary of the content on the page No. 1
Owner’s
Manual
™
TurboPOWER
ENGLISH pp. 1-15
™
ESPAÑOL pág. 18-27
FRANÇAIS p. 28-37
The Easy to Use
Deep Cleaner
with attached tools
Review this manual before operating deep cleaner
SteamVac™ Deep Cleaner cleans carpet fibers by
applying hot tap water and cleaning solution.
www.hoover.com
Summary of the content on the page No. 2
I m p o rtant Safeguard s ! Grounding When using an electrical appliance, always follow basic precautions, including the following: READ ALL INSTRUCTIONS BEFORE USING APPLIANCE. A B • Do not use with damaged cord or plug. If appliance is not working as it WARNING: should, has been dropped, damaged, To reduce the risk of fire, electric left outdoors, or dropped into water, shock, or injury: take it to a Hoover Factory Service Center or Authorized Hoover Warranty • Use indoors only. Service Deale
Summary of the content on the page No. 3
Thank you for choosing a HOOVER product. Contents Important safeguards . . . . . . . . . . 2 If you need any assistance: Parts needed for assembly. . . . . . . 3 Visit our website at www.hoover.com. Click on the “Service” button to find Assembling deep cleaner . . . . . . 3-5 the service outlet nearest you OR Deep cleaner description . . . . . . . . 6 Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. General operation . . . . . . . . . . . . 6-9 only) OR Filling
Summary of the content on the page No. 4
The assembled cleaner will look like this 1-2 1-3 drawing. A Remove nozzle stored on upper handle Attach upper handle by gently pushing nozzle downward Remove clean solution tank (upper tank) while pivoting it away from the handle at from deep cleaner. (A). 1-4 1-5 1-6 B With cord hook (B) to back of deep cleaner, Push b o l t s into holes on front of handle. If Place nuts in recessed areas on back push upper handle down onto lower bolts will not go through hole easily, of handle. Hold each nut
Summary of the content on the page No. 5
1-11 1 - 1 2 1-10 G I H E J F Push screw into hole and tighten Attach lower hose Storing hose and securely with a Phillips screwdriver. holder nozzle on rack With front of deep cleaner resting on Stretch hose out and identify ends. floor, place 2 projections (E) on lower G. Nozzle connector end of hose hose holder into 2 holes (F) on back of H. Solution tube cleaner. I. Trigger J. Converter end of hose Note: You may find it helpful when stor- ing the hose and nozzle to refer to the informat
Summary of the content on the page No. 6
2. How to use The assembled deep cleaner will look like the drawing. Deep cleaner description 2-1 1. Hand grip 18. Upholstery and stair clean 2. Solution trigger: press to ing connection: push door 1 release clean solution open to connect stair/uphol 3. Hose stery tool solution tube 2 4. Hose holders: wrap hose 19. Recovery tank latches: one 3 around holders for storage on each side of tank 5. Cord hooks: wrap cord 20. ON/OFF pedal 4 around hooks for storage. 21. Handle release pedal: step Th
Summary of the content on the page No. 7
2-6 2-7 2-5 F G The deep cleaner may also be lifted by Brush speed selector Brush indicator placing a hand under the upper clean Your ‘SteamVac’ deep cleaner has three The brush indicator will spin (F) when solution tank handle as shown. agitator brush settings. the deep cleaner is turned ON and the Hl - for normal cleaning of carpet and brushes are rotating. bare floors If the indicator does not spin and the LO - for gentle cleaning of carpets and pattern is visible (G) when the deep bare floo
Summary of the content on the page No. 8
Using cap, measure detergent following For heavy traffic areas: 2-11 the chart below. Pre-treat with HOOVER PreCleaner 5 OUNCES/ Spray. For carpet, carpeted stairs and uphol- 150 ml stery: If you do not have access to the PreCleaner Spray, double the amount Fill cap to fill line (5 ounces) with HOOVER of HOOVER Detergent (use 2 capfuls Carpet/Upholstery Detergent. or 10 ounces per 1 gallon tank). For bare floors: A Fill cap to fill line (5 ounces) with HOOVER Bare Floor Cleaner * Do not use Bar
Summary of the content on the page No. 9
2-16 2-17 2-18 G F E Unlatch back part of tank lid and The lid replaces in a hinge-like man- Step on handle release pedal and lower remove lid. ner. Position the front of lid under tabs handle until it rests on the floor. (G) on front of tank. Rotate lid down If cleaning stairs or upholstery, remove Empty tank. Pour dirty water out from the onto tank. Make sure that the lid is hose by reversing procedure as shown rear of the tank (F). secure on all sides before placing on page 12. tank on cleane
Summary of the content on the page No. 10
c. Empty tanks, rinse with clear water To clean nozzle After cleaning and let air dry. Rinse the solution tank a. Allow carpet or upholstery to dry. To If lint or other debris becomes lodged in cap and recovery tank lid and let air dry. help prevent matting and resoiling the nozzle, do not attempt to remove carpet, keep children and pets away nozzle cover. 3-1 from surface until it is completely dry. If Pour one to two cups of clear water on a it is necessary to walk on damp car- non-carpeted f
Summary of the content on the page No. 11
Do not use any type of wax with your 3-5 Cleaning bare floors ‘SteamVac’ deep cleaner. Move speed selector to the LO or Hl How to attach bare floor position for scrubbing or OFF if attachment (available at addi- scrubbing is not desired. tional cost if not included with your Dry hands and plug deep cleaner into cleaner) a properly grounded outlet. Disconnect deep cleaner from electri- Step on handle release pedal and lower cal outlet. handle to operating position; turn deep To prevent possible l
Summary of the content on the page No. 12
3-9 3-10 3-11 H F G 4. Replace panel with converter (G). 3. Remove recovery tank front panel (F) 5. Before connecting tube (H) to Slide converter halfway down opening by sliding it straight up. cleaner, make sure black tabs are until it is firmly in place. extended by pulling tan collar toward tube. Open door on hood labeled “Stair/ upholstery Cleaning Connection”. Press round solution tube connector onto round projection inside door. Press con- nector collar down firmly to ensure that it is ful
Summary of the content on the page No. 13
3-14 3-16 3-17 L 3-15 M 3. Drain suction hose by turning deep Occasionally, debris may become cleaner ON and holding end of hose up lodged inside of the hose at the con- After using tool for several seconds. Do not press verter end (L). To clean out the hose, lift 1. Follow steps a and b for “After clean- trigger. bottom of converter clip (M) with a ing” on page 10. screwdriver and remove clip. Remove 4. Disconnect deep cleaner from elec- 2. Rinse tool and hose by filling sink with debris as sho
Summary of the content on the page No. 14
3-22 3-23 Cleaning upholstery Read “Before you begin cleaning” Instructions on page 10. Be sure to check the cleaning code on A A your upholstery. Use your HOOVER ‘SteamVac’ deep cleaner only on upholstery marked “W” or “W/S”. 1. Attach hose and solution tube as instructed on pages 11 and 12. Agitator brushes will not rotate while solution B B tube is connected to deep cleaner. 9. For heavily soiled areas, it may be 5. Gently press the tool (A) or (B) onto 2. Fill clean solution tank with HOOV
Summary of the content on the page No. 15
Full Two Year S t o r a g e 5. If you have a Before storing: Warranty problem • Empty solution tank and rinse (Domestic Use) thoroughly with clean water. If a minor problem occurs, it usually can be solved quite easily when the cause is • Replace empty solution tank and Your HOOVER® appliance is warr a n t e d found by using the check list below. turn deep cleaner ON. Squeeze in normal household use, in accord a n c e trigger and push deep cleaner for- with the Owner’s Manual against original
Summary of the content on the page No. 16
HOOVER et sont des marques déposées HOOVER y son marcas registradas HOOVER and are registered trademarks 8-02 F5886-900 Litho USA 56518-153
