Summary of the content on the page No. 1
O F F EJ
RDS P AU I N T RPT
ST
1 2 3
RDM
TALK
5 6
4
PTY
TA
BAND M U T E
LUD
LOC
PA I R I N G
MODE
SEL
AS
PS
REMOTE CONTROL
Attention!! This car radio unit is compatible with the latest profile Bluetooth. It is inevitably possible
that certain mobile phones are not compatible concerning the communications as well as the
identification numbers. Check if your mobile phone is compatible with Bluetooth version 1.2 or 2.0.
CD/MP3
NCU160 USB/SD/MMC/WMA
RESET MIC
AMS
FLAT
POP
CLSC ROCK
PHONE
LOUD
TRK
Summary of the content on the page No. 2
Contents Notes on Installation..............................................................2 Before You Install...................................................................2 Remove the Old Unit from the Dashbord...............................2 Installation..............................................................................3 Wiring Connections................................................................4 Care of Discs............................................................
Summary of the content on the page No. 3
Notes on Installation Disconnect negative battery terminal before starting installation. Consult the vehicle's owner's manual for proper instruction. The unit is designed for a 12Volt DC negative ground operation system only. Before Installing the unit, make sure your vehicle is a 12Volt DC negative ground system. Be sure to connect the leads according to the diagram. Incorrect connections may cause the unit to malfunction or damage the vehicle's electrical system. Be sure to connect the ne
Summary of the content on the page No. 4
Installation DIN FRONT DASH MOUNT Removing the unit Installation the unit 1. Frame 1. Dashboard. 2. Insert fingers into the groove in the front of 2. Holder frame and pull out to remove the frame, After inserting (When re-attaching the frame, point the side the holder into with a groove downwards and attach it.) the dashboard, select the appropriate tab according to the thickness of the dashboard material and bend them inwards to secure the holder in place. 3. Screw 3. Re
Summary of the content on the page No. 5
Wiring Connections Make sure that you have a good chassis ground. Good ground connections will eliminate most electrical noise problems. A good chassis ground requires a tight connection to the vehicle's metal chassis. The area around the ground connection should be clean, bare metal without rust, paint, plastic, dust, or dirt for a good electrical connection. ANTENNA RCA LINE OUT POWER BLUE BLACK ANTENNA GROUND FUSE 1A FUSE 8A RED YELLOW IGNITION MEMORY FRONT LEFT SPEAKER FRONT RIGHT
Summary of the content on the page No. 6
Location of Controls (9) (5) (2) (15) (21)(1)(3)(20)(18) CD/MP3 NCU160 USB/SD/MMC/WMA RESET MIC AMS FLAT POP CLSC ROCK PHONE TRK MUTE INTR LOUD RDM RPT BND MP3 INPUT DIS VOL PUSH SEL MUTE/PAIRING LO/DX PAU INT RPT RDM ST TK LUD 1 2 3 4 5 6 MOD (14) (11) (12) (13) (17) (10) (16) (7) (6) (19) (4) (8) O F F EJ (1) (8) RDS P AU I N T RPT (11) ST 1 2 3 (17) RDM (12) TALK 5 6 4 PTY TA (13) BAND M U T E *Remove the transparency plastic thin plate (D) (7) LUD before use and replace the CR2025(3V) li
Summary of the content on the page No. 7
Operating Instructions 1. POWER ON/OFF CONTROL Press the button to turn the power “ON” or “OFF”. Note : The unit can be turn on by pressing any keys on the panel (except panel release button & disc eject button). It will help the user who cannot find the power button in dark. 2. BAND SELECTOR Each time this button is pressed, the radio band is changed. The indication “FM1”, “FM2”, “FM3”, “AM1” or “AM2” will appear on the display according to your selection. 3. PRE-SCAN/AUTO-STORE BUTTON Th
Summary of the content on the page No. 8
10. MODE SELECTION Press this button to select Radio (TUNER), CD/MP3/WMA (S-CDP), USB (USB-DRIV) or SD/MMC (MEM- CARD) mode. 11. STEREO/MONO CONTROL Press this button to select “FM STEREO” or “MONO” reception. 12. TALK BUTTON Press this button for Bluetooth wireless technology operation (please refer to the “Handsfree Operation” for details). 13. LOUD CONTROL / LOCAL-DISTANT SELECTOR For Loud Function Briefly press this button to activate the loudness circuitry which compensates for loss of
Summary of the content on the page No. 9
NOTE: When the preset button to be memorized is kept pressed for more than 2 seconds, the receiving station frequency will be stored in the button pressed. After this, the memorized station can be recalled by pressing the button once. On CD / MP3 / WMA / USB-DRIV / MEM-CARD Mode lPreset 1- press this button to pause the disc / file played. lPreset 2- press this button to scan the first 10 seconds of all the tracks on the selected disc / USB drive / SD or MMC Card. lPreset 3- press this butt
Summary of the content on the page No. 10
Precautions This unit will only play the following discs. Type of disc Label on the disc Recorded material Size of disc Audio only CD, MP3, WMA 12 cm Instruction to play MP3/WMA Songs IMPORTANT NOTES l The MP3/WMA file recording media acceptable to this unit are CD-R, CD-RW, USB flash memory, SD or MMC memory card. l The MP3/WMA formats acceptable are limited. l Do not attempt to play a media containing non-MP3/WMA files or non-MP3/WMA files with MP3/WMA extension. Otherwise, th
Summary of the content on the page No. 11
Pairing the Unit with Mobile Phone via Bluetooth Wireless Technology Attention!! This car radio unit is compatible with the latest profile Bluetooth. It is inevitably possible that certain mobile telephones are not compatible concerning the communications as well as the identification numbers. Ensure that your mobile phone is compatible with Bluetooth 1.2 or 2.0 l Press “MUTE” button about 5 seconds until “PAIRING” show on display. l Turn ON connection via Bluetooth wireless technology from t
Summary of the content on the page No. 12
Simple Troubleshooting Guide PROBLEM CAUSE/SOLUTION No Power Check wiring connections. Check and make sure the fuse is not blown. Replace with the proper rating / size fuse. Some errors occur in the LCD or Press the RESET Button (21). nothing functions when buttons are pressed. Unable to receive stations Check and make sure the antenna is connected properly. Poor radio reception Check and make sure the antenna is the correct length. Make sure the antenna is not broken. If the antenna is broken,
