Waterford Precision Cycles Chimney Hood user manual

Summary of the content on the page No. 1

An AGA Company
60 / 70 / 90cm Stainless Steel
60 / 70 / 90cm Stainless Steel
Chimney Hoods
Chimney Hoods
To be installed by a trained and competent person
INSTALLATION & OPERATING MANUAL
To be left with end user

Summary of the content on the page No. 2

WARNING & SAFETY INFORMATION Please read this manual carefully, it provides important information about the safety, installation, use and main- tenance of the appliance. The manufacturer cannot be considered responsible for any damage caused by improper, incorrect or unreasonable use. WARNING! Do not connect the appliance to the mains until the installation is fully complete. ELECTRICAL CONNECTION The mains power supply must correspond to the rating indicated on the plate situated inside the h

Summary of the content on the page No. 3

GENERAL GUIDELINES INSTRUCTIONS FOR ASSEMBLY Before installing and /or using the cooker hood, The hood is intended for fitting on the wall. Position please read these instructions carefully. the hood 70cm above the hob. Remove the metal anti-grease filters. Position the hood against the wall Before installing the cooker hood make sure the volt- and mark on the wall the position of the support age (V), frequency (Hz) indicated on the serial num- holes. Using a drill bit with a diameter of 6mm

Summary of the content on the page No. 4

600 - 700 - 900 regularly depending on use and at least every three THE MANUFACTURER DECLINES ALL months in a dishwasher or in hot water with normal RESPONSIBILITY IN THE EVENT OF FAILURE TO washing-up detergent. After having carefully rinsed OBSERVE THE INSTRUCTIONS GIVEN HERE and dried the metal anti-grease filter, put it back in FOR INSTALLATION, MAINTENANCE AND SUIT- place. ABLE USE OF THE HOOD. c) Changing the light bulb HOOD DIMENSIONS Before changing the light bulb, ensure that the appli

Summary of the content on the page No. 5

An AGA Company WARRANTY We undertake to repair or replace, free of charge to you any part found to be faulty within the 12 month period from the date of purchase provided that:- * The fault is, in our opinion, caused by defective workmanship, or material and not by accident, misuse, neglect or normal wear and tear. * Any manufacturing defect is reported to the stockist from whom you bought the appliance within 12 months of the date of purchase. * The Waterford appliance is installed to the Man