Tektronix 494AP user manual

User manual for the device Tektronix 494AP

Device: Tektronix 494AP
Category: Water Dispenser
Manufacturer: Tektronix
Size: 22.4 MB
Added : 6/26/2013
Number of pages: 336
Print the manual

Download

How to use this site?

Our goal is to provide you with a quick access to the content of the user manual for Tektronix 494AP. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with Tektronix 494AP.

For your convenience

If looking through the Tektronix 494AP user manual directly on this website is not convenient for you, there are two possible solutions:

  • Full Screen Viewing - to easily view the user manual (without downloading it to your computer), you can use full-screen viewing mode. To start viewing the user manual Tektronix 494AP on full screen, use the button Fullscreen.
  • Downloading to your computer - You can also download the user manual Tektronix 494AP to your computer and keep it in your files. However, if you do not want to take up too much of your disk space, you can always download it in the future from ManualsBase.
Tektronix 494AP User manual - Online PDF
Advertisement
« Page 1 of 336 »
Advertisement
Print version

Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual Tektronix 494AP but the selected pages only. paper.

Summaries

Below you will find previews of the content of the user manuals presented on the following pages to Tektronix 494AP. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.

Abstracts of contents
Summary of the content on the page No. 1

o
o
o
Service
Manual
o
o
o
o
o
Tektronix
o
o
o
I
o
494A
& 494AP
o
Spectrum
Analyzers
o
Volume
1
o
a
070-ss60-00
o
o
o
o
o
o
o
o
o
o
o
o
o
o
a
o
o
a
o
Warning
o
The
servicing instructions
are for use by qualified
personnel
only. To avoid personal
injury, do
not
o
perform
any servicing unless
you are qualified
to
do so. Refer
o to the Safety Summary
prior to
performing
service.
o
Please check
for change information
at the rear
o
of this manual.
o
First Edition:
January 1 987
o
o

Summary of the content on the page No. 2

I o o o ? o Copyright @ Tekrronix, Inc. 1987. All rights reserved. a Tektronix products are covered by U.S. and foreign patents, issued and pending. Information in this publication supercedes o that in all previously published material. Specifications and price change privileges reserved. o Printed in the U.S.A. t Tektronix, Inc., P.O. Box 1000, Wilsonville, OR 97070_1000 o TEKTRONIX and TEK are registered trademarks of Tektronix. o Inc. O o o o o a o o o o o o o o o o o o o a o o o

Summary of the content on the page No. 3

o o o o o RELEASE OF COPYRIGHT o Tektronix provide cannot manuals for measurement products that are no o longer eligible for long term support. Tektronix hereby grants permission and license for others to reproduce and distribute copies of any Tektronix o measurement product manual, including user manuals, operato/s part manuals, service o manuals, and the (a) like, that have a Tektronix Number (b) and are for a measurement product that is no longer o supported by Tektronix. A Tek

Summary of the content on the page No. 4

o a o o ,.'.t a o a o a a o o o t a a o I o o o o o o o O a I o a o a o o t a o o a a a a a

Summary of the content on the page No. 5

I o o I o I WARRANTY t I Tektronix warrants that this product will be free from defects in materials and workmanship fbr a period of one (l) year from the date of shipment. o If any such product proves defective during this warranty Tektronix, at its feriod, option, either will repair the defective product without charge for parts and labor, or will provide a replacement o in exchange for the defective product. I In order to obtain service under this warranty, Customer

Summary of the content on the page No. 6

O a o I ? o a a a a a I t o I a a a O o O o o o t C a I a o O t a o a o a o o a o o I o

Summary of the content on the page No. 7

o o 494A/494AP Service Vot. 1 o t o PREFACE o I This manual contains servic€ information I for . - the ANSI Y1.1 Abbreviations TEKTRONfX 494A1494Ap. The information is tocated in . - o two volumes. Volume ANSI Y32.2 Graphic 1 Symbots contains the text and Volume 2 contains the diagrams and parts lists. The Tabte o - of IEEE 91 Logic Symbots a Contents in each volume lists the contents of both volumes. O Change/History Inf ormation Manuals that describe other aspects

Summary of the content on the page No. 8

o o o I a o t a a a o a o o I O a a a o o o o o o o t o a a o o I o o o a o o o a o a o

Summary of the content on the page No. 9

o o 494A/494AP Service Vot. 1 o t o TABLE OF CONTENTS o The 494A/494AP service Manuat is divided into two volumes. o VOLUME 1 o o Page Page PREFACE o ........................ i Section 4 PERFORMANCE CHECK TABLE OF CONTENTS .............. .......... iii o Introduction LIST OF ILLUSTRATTONS ..,.4-1 ........... ........ x LIST Incoming OF TABLES Inspection Test ...................... 4_1 ............. xiii a SERVICING Option Instrument SAFETY Checks ..............,...... SUMMA

Summary of the content on the page No. 10

o 49441494AP Servtce Vot. i o o I .| TABLE OF (Gonr.) CONTENTS r page Page o Section 4 PERFORMANCE CHECK (Conr.) 15. Adjust Band Leveling for Waveguide Bands o .............. 24. Check LO 5-25 Emission .....4-29 16. PhasE Lock Calibration .................... point 25. Check 1 5-2S dB Compression .......4-29 a OPTION INSTRUMENTS ONLY ............. 26. 5-29 Check External Reference 17. Adjust Option 07 VR Band Leveling Input Power 5-29 .... 4-31 a 18. Adjust Option 42 Module ......

Summary of the content on the page No. 11

o o 494A/494AP Service Vot. 1 o I O TABLE OF CONTENTS (Conr.) I page Page I Section 6 MAINTENANCE (Conr) Preparing the 2nd LO o Assembly Firmware for Adjustment Version and ............. 6-35 o Enor Reassembling Message the Readout ............... 6-1 5 2nd LO Assembty Selected Components ..... 6-9g .................. 6-1 5 O Replacing Troubleshooting EPROM and Calibrating or ROM the 16-20 MHz Phase I Devices Lock ........ 6-15 Section Surface-Mounted ..................... C

Summary of the content on the page No. 12

a 494A1494AP Servlce Vol. 1 o o o 't TABLE OF CONTENTS (Cont.) o Page Page o Section 7 THEORY OF OPERATTON (Cont) Frequency Synchronizer .......... 7-21 a Phase/Frequency DETAILED -4 DESCR|PT|ON ................ ..... 7 Detector ...,.,..,.....,7-21 1ST CONVERTER SECTTON ............. 7_4 a Tune Amplifi er ............... ........... 7-22 RF Interface .................... Qircuits 7-4 'l -22 Lock Detector .............. ......... 7 st Converter ................. ".. ..........,,,..

Summary of the content on the page No. 13

o o 494A1494AP Service Vot. I o o o TABLE OF CONTENTS (Conr.) o Page Page O Section 7 THEORY OF OPERATION (Conr) lst LO DRIVER .........7-67 a Digital Controf Fast ...... 7-6g Retrace Blanking ...,.,... 742 Input Switching ........................ Memories 7-69 o ........7-47 Oscillator Filter DEFLECTION AMPLIFIERS .......... 7-47 o Switch Driver Horizontal .......7-69 Section ...............,... 747 Summing Amptifier ................... 7-69 Vertical Section ....249 o Oscillat

Summary of the content on the page No. 14

o 4944/494AP Servlce Vot. 1 a o I TABLE , OF CONTENTS (Cont.) a Page Page o Section 7 THEORY OF OPERATTON (Conr) POWER SUPPLY ..........7-103 o Primary Circuits ........ 7-103 DtctTAL CONTROL SECTTON .......... 7_88 Line Input Circuits .................... 7-1 03 Microcomputer ............................. 7-gg a Invert€r Circuit ..... 7-103 Processor ............. 7-gg Multivibrator .... 7-103 o Microprocessor ................... 7-88 Ramp Generator .................. 7-l 04 Cfock .

Summary of the content on the page No. 15

494A/{94AP Service Vot. 1 TABLE OF CONTENTS (Cont.) VOLUME 2 Sec|ion 9 REPLACEABLE ELECTRICAL PARTS Section 10 DTAGRAMS Section 1.I REPLACEABLE MECHANICAL PARTS

Summary of the content on the page No. 16

I 494A/494AP Servlce Vol. 1 a o o t LIST OF ILLUSTRATIONS t a page Figure Figure Page a The 494AP o Spectrum Analyzer. ................... xvi Test of 4-23 oscilloscope display VERT output with a full screen display o 2-1 Dimensions. ....,....,..2-12 on the Spectrum Analyzer. .......4-34 Equipment 4-24 setup for checking o 3-1 Location of input power selector switch Option 07 frequency response and fine I fuse. .._....... .....,..,.........9-2 from 0.01 GHz to 1 GHz. .......... 4-35 4

Summary of the content on the page No. 17

I o 494A/494AP Servtce Vot. 1 o a o LIST OF ILLUSTRATIONS (Conr.) I I Figure Page o Flgure Page 5-21 PreseleetorDriver o construction details. .................. 6-gg adjustment setup. ......... ............5_22 6-23 2182MHz 2nd LO Phase Lock a 5-22 Preselector Driver test point adjustment setup. ........ .............. 6_39 and adjustment locations ........... S_Zg I 6-24 Tune and Sweep Range 5-23 Test equipment setup for band adjustments ............641 leveling adjus

Summary of the content on the page No. 18

o 494A/494AP Servlce Vot. 1 I o a LIST I OF ILLUSTRATIONS (Cont.) I o Figure Page Figure Page a 7-12 Selection of position disptay o 7-23 Simplified digital-to-analog on the log scale. .....7-94 converter. ....-........ 7-66 I 7-13 Functional diagram showing the 7-24 Simplified span decade attanuator. .............. 7-67 sp€ctrum analyzer and 1405 TV 7-25 DAC variance graph. ................7-73 I Sideband Adapter system. ........ 7€6 7-26 Simpfffied tune voltage converter. ........

Summary of the content on the page No. 19

o a 494A1494AP Service Vot. 1 o a o LIST OF TABLES O I Table page Table page I 1-1 TEKTRON'X WAVEGUIDE MIXERS .............. 1-3 6-6 EQUIPMENT REQUIRED FOR RETURN O LOSS ADJUSTMENT ...............6-27 2-1 FREQUENCY RELATED o 6-7 EOUIPMENT REQUIRED FOR CHARACTERTSTTCS .................. 2-1 2nd LO CALIBRATION ................................. 6-94 2-2 o AMPLITUDE RELATED 6-8 EQUIPMENT REQUIRED FOR CHARACTERTSTTCS ................. 2_6 CALIBRATING THE 16-20 MHz I 2-3 INPUT

Summary of the content on the page No. 20

o {944/494AP Service Vot. 1 o o a I LIST OF TABLES (Cont.) o ) Table page page Table I 8.1 EXTENDED SERVICE AND 84 OPTION 41 ALTERNATE o WARRANW OPT|ONS .............8_1 SPECTF|CAT|ONS ......... ............8-4 8.2 OPNON 07 ALTERNATE 8-5 o OPTION 42 ELECTRICAL spEctFtcATloNs ................... 8-2 CHARACTERTSTTCS .................. 8-5 8.3 OPTIONS o 21 AND 22 WAVEGUIDE MtxERS CHARACTERTSTTCS ...................... 8_3 I o t o I o t a I o I o O I O I o t a t I a o I o I a I a a o


Alternative user manuals
# User manual Category Download
1 Tektronix 494AP User manual TV Converter Box 0
2 Tektronix 2715 User manual Water Dispenser 1
3 Tektronix 7L12 User manual Water Dispenser 0
4 Tektronix 495 User manual Water Dispenser 2
5 Tektronix 2754P User manual Water Dispenser 10
6 Tektronix 494A User manual Water Dispenser 4
7 Tektronix 495P User manual Water Dispenser 0
8 Edelbrock 2475 User manual Water Dispenser 0
9 Sony 2 User manual Water Dispenser 3
10 ADTX User manual Water Dispenser 4
11 Agilent Technologies E4408B User manual Water Dispenser 16
12 AEG PWE9039M User manual Water Dispenser 15
13 Agilent Technologies 8156A User manual Water Dispenser 7
14 Agilent Technologies 8591E User manual Water Dispenser 7
15 Agilent Technologies 8596E User manual Water Dispenser 5