Summary of the content on the page No. 1
OPERATING INSTRUCTIONS
CA-DW539
INSTRUCCIONES DE MANEJO
MODE D’EMPLOI CD CARRY COMPONENT SYSTEM
SISTEMA DE COMPONENTES DE DISCOS
COMPACTOS PORTATIL
MINICHAINE PORTABLE A LECTEUR DE CD
English : See page 2. En
Español : Ver la página 12. E
Français : Voir page 22. F
8B-CT5-913-01
U
020320ACK-I-FM
Summary of the content on the page No. 2
WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC IMPORTANT SAFETY SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep CAUTION the Operating Instructions for future reference. All RISK OF ELECTRIC SHOCK DO NOT OPEN warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the “CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK, safety suggestions below
Summary of the content on the page No. 3
INSTRUCTIONS Object and Liquid Entry – Never push objects of any Damage Requiring Service kind into this unit through the cabinet slots as they may Unplug this unit from the wall outlet and refer servicing touch dangerous voltage points or short-circuit parts to qualified service personnel under the following that could result in a fire or electric shock. Never spill conditions: liquid of any kind on the unit. 1) When the power cord or plug is damaged. 2) If liquid has been spilled, or objects
Summary of the content on the page No. 4
Power supply Connections IMPORTANT • Make sure that the AC cord is disconnected and OPE/BATT batteries are removed before connecting speakers. • Do not connect other than the supplied speakers. Position the speakers. 1 To couple with the speakers, slide each speaker down into the guide brackets on the center unit until The OPE/BATT indicator lights up while the power is the height is level with the unit. on. To separate the unit from the speakers, slide the speakers up and off, while pressing th
Summary of the content on the page No. 5
Remote control Specifications Insert two R6 (size AA) batteries. Tuner section Frequency range, antenna — FM: 87.5 - 108.0 MHz Rod antenna, AM: 530/531 - 1,710/1,602 kHz (10/9 kHz step) Ferrite bar antenna Deck section Track format — 4 tracks, 2 channels / Frequency range — Normal tape: 50 - 12,000 Hz (EIAJ) / Recording system — AC bias / Erasing system — Magnet erase / R6 (AA) Heads — Deck 1: Recording/playback head (1), Erasure head (1); Deck 2: Playback head (1) When the reach of the remote c
Summary of the content on the page No. 6
TUNER OPERATION A Press *RADIO/BAND repeatedly to select *REPEAT/SLEEP/FM MODE/OSC 1 - If an FM stereo broadcast contains noise, press the the desired band. button so that is displayed. FM AM Noise is reduced, although reception is monaural. To restore stereo reception, press the button again. The power is turned on and the previously tuned - If a high-pitched sound is heard during AM recording, station is received. press the button repeatedly until the noise is reduced. * or BAND on the remote
Summary of the content on the page No. 7
SOUND ADJUSTMENT Volume or tone adjustment does not affect recording. VOLUME (VOL) Press VOLUME N or M. The volume level is displayed as a number from 0 to MAX (25). • The volume level is automatically set to 14 if the power is turned off when the volume level is set to 15 or more. (except when turning the power back on within 4 seconds) • Pressing DISPLAY on the remote control displays the adjusted volume level. 3-mode equalizer Press one of the 3-mode equalizer buttons (ROCK, POP, JAZZ). The s
Summary of the content on the page No. 8
CD OPERATION B To start play when the power is off, press CD. The Press CD. 1 power is turned on and play of the loaded disc begins The power is turned on. (Direct Play Function). Press CD OPEN to open the disc 2 If you load a disc while the CD indicator flashes in step compartment. Place a disc with the 2, play starts without pressing e. printed side up and close the disc compartment. To select a track directly with the remote control, press the numbered buttons 0-9 and +10. CD play CD OPEN sta
Summary of the content on the page No. 9
SETTING THE SLEEP TIMER The unit can be turned off automatically at a specified time. Keep REPEAT/SLEEP/FM MODE/OSC 1 pressed until “30” flashes in the display. 2 Within 4 seconds, press r or t to specify the time until the power is turned off. Each time it is pressed, the time changes between 10 and 90 minutes in 10-minute steps. PROGRAMMED PLAY Up to 30 tracks can be programmed from the disc. Specified time In stop mode, keep *s MEMORY pressed 1 until “M” flashes in the display. * or s STOP on
Summary of the content on the page No. 10
TAPE OPERATION C • Use Type I (normal) tapes only. RECORDING FROM A CD OR THE • Note that recording is done on only one side of the TUNER tape. Insert a tape to be recorded on into deck 1 1 INSERTING A TAPE with the side to be recorded facing out. Press Z to open the cassette holder and insert a tape with the exposed side down and Deck 1 the side to be played facing out. Deck 1 Deck 2 Get ready to record from the source. 2 To record from a CD, press CD and load the disc. To record from a radio b
Summary of the content on the page No. 11
MICROPHONE MIXING Connect a microphone with a mini plug to the MIC jack and play a source to be mixed. To record the microphone mixing sound, insert a tape in deck 1 and press w. • During dubbing at high speed, the microphone mixing sound is not recorded. MIC VOL – Adjusts the microphone volume. If a howling sound is produced, turn the volume down. • To prevent howling, hold the microphone away from the speakers. The use of unidirectional type microphones is also recommended. Maintenance DUBBING
Summary of the content on the page No. 12
NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interferen
