Summary of the content on the page No. 1
Quick RefeRence Guide
2010 Mu RAn O
Summary of the content on the page No. 2
02 01 03 04 17 18 06 05 08 07 09 10 19 11 12 20 13 14 15 16 21 01 in STRu MenT BR iGHTne SS c OnTROL* STee Rin G WHee L SWiTc HeS fOR A udi O 12 keY PORT 17 Pu SH BuTTO n i GniTi On 07 ® c OnTROL/BLueTOOTH VeHic Le d YnAM ic c OnTROL (Vdc) 02 TWin TR iP Od OMeTe R c OnTROL 18 nAVi GATiOn SYSTe M 13 08 c Rui Se c OnTROL Off SW iTc H 03 19 Audi O SYSTeM LOW TiRe PReSSu Re WARnin G LiGHT 09 POWeR LifT GATe OP ene R 14 POWeR d OOR On /Off SW iTc H 04 TRiP c OMPuTe R 20 AuTOMATic c LiMAT
Summary of the content on the page No. 3
ni SSAn intelligent k ey™........................................... 2 Automatic door Locks ............................................. 3 Windshield Wiper/Washer Switch ................................... 4 Headlight and Turn Signal control ................................... 4 ® Steering Wheel Switches for Audio control/Bluetooth (if so equipped)................................................... 5 cruise control .................................................... 6 Automatic
Summary of the content on the page No. 4
NISSAN INTELLIGENT KEY™ The ni SSAn intelligent k ey™ allows you to lock or unlock your vehicle and start the engine. ReMOTe keYLe SS enTRY Lock Doors Press the button to lock all doors. Unlock Doors Press the button once to unlock the driver’s door only. Press the button again within 5 seconds to unlock all doors. Using the Panic Alarm Press and hold the button for longer than 0.5 seconds. The panic alarm will sound and the headlights will stay on for 25 se
Summary of the content on the page No. 5
SiLencin G THe HORn B ee P feATu Re For vehicles without Navigation system: To deactivate: Press and hold the and buttons for at least 2 seconds. To activate: Press and hold the and buttons for at least 2 seconds. For vehicles with Navigation system: if you change the horn beep feature with the keyfob, the display screen will not show the current mode. u se the keyfob to return to the previous mode and set the horn beep feature using the control panel. Press the SETTING b
Summary of the content on the page No. 6
WINDSHIELD WIPER/WASHER SWITCH The ignition switch must be in the On position to 04 activate the windshield wipers. Move the lever to the following positions to operate the windshield wipers: 05 1B 1A intermittent (INT) – Push the lever down. front wipers operate intermittently and can be further adjusted by twisting the time control ring 1B . 1A 1A Rain-Sensing intermittent (if so equipped) 02 (AUTO) – Push the lever down. front wipers operate intermittentl
Summary of the content on the page No. 7
fOG Li GHT OPeRATiOn (if so equipped) n OTe: The headlights must be on and the low beams selected for the fog lights to operate. Turn the switch (inside collar) 02 to the position to turn on the fog lights. Turn the switch (inside collar) 02 to the OFF position to turn off the fog lights. HiGH BeAM Push the headlight control switch forward A to select A the high beam function. The blue indicator light illuminates in the instrument panel. Pull the headlight switch ba
Summary of the content on the page No. 8
CRUISE CONTROL To activate the cruise control, push the ON/OFF switch. The c Rui Se indicator light in the instrument panel will illuminate. To set cruising speed, accelerate the vehicle to the desired speed, push the COAST/SET switch and release. To reset at a faster cruising speed, push and hold the ACCEL/RES switch. When the vehicle attains the speed you desire, release the switch. To reset at a slower cruising speed, push and hold the COAST/ SET switch. Release the switch
Summary of the content on the page No. 9
To disable auto mode, press the air flow mode control button 05 , the fan speed control dial 04 or the front defroster control button 07 . 03 UPPER VENT BUTTON When the upper vent button is pushed, the air flow against the driver’s or passenger’s upper body becomes gentle. The indicator light on the button will illuminate. 04 FAN SPEED CONTROL DIAL Turn the dial to the left to decrease fan speed or turn the dial to the right to increase fan speed. Press the dial t
Summary of the content on the page No. 10
02 01 03 04 05 06 07 10 09 08 ® FM/AM/XM * RADIO WITH CD PLAYER (if so equipped) 01 EJECT BUTTON Press the button; the cd will eject. 02 CD INSERT SLOT Load a cd face up into the cd slot. The cd will be guided automatically into the slot and start playing. 03 STATION SELECT BUTTONS To store a radio station in a preset, you must first select the f M, AM or SAT (if so equipped) radio band by pressing the AM·FM 04 or SAT 05 (if so equipped) buttons and tuning to the ® d
Summary of the content on the page No. 11
07 TUNE/FOLDER AND AUDIO KNOB (Bass, Treble, etc.) To manually tune the radio, turn the TUNE/FOLDER/AUDIO knob. if playing a cd that is formatted with MP3/WMA folders, turn the TUNE/FOLDER/AUDIO knob to scroll through the available folders. Adjust the Bass, Treble, Balance and fade by pushing the TUNE/FOLDER/AUDIO knob until the desired mode appears in the display. Then turn the TUNE/FOLDER/AUDIO knob to adjust to the desired level. 08 SEEK/CAT AND TRACK BUTTONS
Summary of the content on the page No. 12
Select the compactflash™ player by using one of the following methods: Press the SOURCE select switch on the steering wheel and the ENTER switch. Press the DISC·AUX button. Give voice commands. f or information, see ni SSAn Voice Recognition System. SEEK/CAT AND TRACK BUTTONS Press the SEEK/CAT or TRACK buttons while a cf card is playing; the next track or the beginning of the current track on the cf card will be played. Press and hold the SEEK/CAT (rewind) button or the TRACK (fas
Summary of the content on the page No. 13
® MUSIC BOX (if so equipped) ® The Music Box audio system can store songs from cds being played. The system has a 9.3 GB storage capacity. RECORDING CDS The system will not record MP3 or WMA files, only regular formatted cds. 1. Turn on the audio system and insert a cd. 2. Select the “Rec” key. The system starts recording and playing the first track on the cd and R ec cd appears on the screen. PLAYING RECORDED SONGS TM Select the Music Box audio system by using one of the following
Summary of the content on the page No. 14
MAINTENANCE ITEMS You can set up to four different maintenance interval items. To display the setting of the main- tenance interval, select one of the four “Reminder” keys using the multi-function controller 01 and press the ENTER button. To set the maintenance interval, select the “interval” key using the multi-function controller and press the ENTER button. use the multi-function controller to change the interval and press the BACK button to accept the changes. To reset the maintenance in
Summary of the content on the page No. 15
TRIP COMPUTER When the selection button 01 is pressed repeatedly, the 01 following modes will display on the screen: 02 Setting Warnings (if there are any) MPG (instant fuel economy) MPG/MPH (average fuel economy and speed) Time/Miles (elapsed time and distance since last reset) Range (distance to empty) exterior temperature SeTTin G MOde When the setting button 02 is pressed, you are able to set reminders for alerts and maintenance intervals or change language displays.
Summary of the content on the page No. 16
VEHICLE DYNAMIC CONTROL (VDC) OFF SWITCH The Vehicle dynamic c ontrol (Vdc ) system monitors driver inputs and vehicle motion. under certain conditions, it controls braking and engine output to help the driver in handling the vehicle. Vdc does not prevent accidents due to careless or dangerous driving techniques. Always be mindful of vehicle speed and driving conditions. Vdc may need to be temporarily shut off if you are trying to free a vehicle stuck in snow or mud. Push the Vehicle dyn
Summary of the content on the page No. 17
ENTRY/EXIT FUNCTION The driver’s seat and steering column automatically move to allow the driver to get into and out of the driver’s seat more easily. The driver’s seat slides backward and the steering column moves upward when the driver’s door is opened and the ignition switch is in the LOck position. The driver’s seat and steering column return to the previous position when: The key is inserted into the ignition switch. TM The ignition switch is pushed with the driver’s door closed
Summary of the content on the page No. 18
FRONT PASSENGER AIR BAG STATUS LIGHT This vehicle is equipped with the nissan Advanced Air Bag System. u nder some conditions, depending on the type of occupant or object detected in the front-passenger’s seat by the occupant classification sensor, the front passenger air bag is designed to automatically turn OFF. When the front pas- senger air bag is OFF, the front passenger air bag status light will illuminate.* f or example: When the system detects that the front-passenger’s seat is occu
Summary of the content on the page No. 19
FUEL-FILLER DOOR RELEASE SWITCH The fuel-filler door release is located on the instrument panel to the left of the steering wheel. To open the fuel-filler door, push the release. To lock, close the fuel-filler door securely. TILT/TELESCOPIC STEERING POWeR 01 Push the switch up or down; forward or backward to adjust the steering wheel to the desired position. MAnu AL The telescopic lock lever is located on the left side of the steering column. Pull the telescopic lock lever dow
Summary of the content on the page No. 20
MOONROOF CONTROLS (if so equipped) The ignition switch must be in the On position to operate the moonroof controls. 01 SLidin G Sun SHAde And MOO n ROOf 02 When the moonroof switch is pushed to the OPEN position 02 , the front and rear sunshades will fully open. When the 03 switch is pushed again, the moonroof will fully open. When the moonroof switch is pushed to the CLOSE 04 position 04 , the moonroof will automatically close. Push the switch again, the front and rear
