Audiovox AA-940 user manual

Summary of the content on the page No. 1

Model AA-940
Two Button Code Learning
Remote Alarm With Starter Inhibit
And Two Stage Shock Sensor
Installation & Operating Manual
What Is Required For This Installation:
1) A working knowledge of automotive mechanical and electrical systems.
2) Electric Drill, 1/8” Drill Bit and (2), # 8 x 3/4” Sheet Metal Screws: To drill the mounting holes and secure
the Siren Assembly to the vehicle.
3) Electrical Tape: For insulating your wiring connections.
4) (4) 6” Cable Ties: For securing the Starter

Summary of the content on the page No. 2

a) With the system disarmed, turn the ignition switch on then off 8 times, ending with the key on. After 4 seconds, the siren will chirp 3 times indicating the unit is ready to accept programming of up to 3 transmitters. b) Within 8 seconds, press any button of the transmitter to be programmed. NOTE: If no transmitter button is activated, or the ignition switch is turned off, the unit will exit the program mode. Also, any time the program mode is entered and any transmitter is activated, all

Summary of the content on the page No. 3

Emergency System Override: If in the event the transmitter becomes inoperative while the system is armed, a method of overriding the alarm is required to allow you to start the vehicle. To override the system without the keychain transmitter: a) Open the vehicle door, the alarm system will sound. b) Turn the ignition key from off to on five times ending with the key on. After 5 seconds the unit will disarm. Transmitter: The two transmitters provided with your unit have a small 12 volt battery t