Summary of the content on the page No. 1
CS-2011RS Series IV
Super Rage™
Remote Control Alarm & Remote Engine Starting System
OPERATION INSTRUCTIONS
INTRODUCTION
CONGRATULATIONS on your choice of a Super Rage™ Alarm & Remote Engine Starter by Crimestopper
Security Products Inc. This booklet contains the information necessary for operating your system. If any
questions arise, contact your installation dealer or Crimestopper Security Products Inc.
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMA
Summary of the content on the page No. 2
TABLE OF CONTENTS Operation Cautions & Warnings……..………..…………………………………………………………….………2 Operating Instructions - Alarm……………………………………………………….………..……………..……..3-6 LED Diagnostics………………..…………………………………………………………………….………..…..….6 Remote Engine Control………………………...…………………………………………………….………...…..6-10 Optional Turbo Timer Mode……………………...…………………………………………………………..…..….11 Anti-Carjack Protection...……………………………………….………….……..…………...…………..……...…12 Transmitter Programming……………………………….…………………………………
Summary of the content on the page No. 3
OPERATING INSTRUCTIONS - ALARM Active Arming / Locking: Press and release button #1 (Lock symbol) on the transmitter. The #2 System will arm and confirm with one siren chirp, one light flash, and DISARM the LED will begin to flash. Power locks will lock (if equipped). #1 UNLOCK Starter disable circuit will turn on. After a short delay to allow the ARM/ vehicle and electronics to settle, the system will be completely LOCK SEE 2-CAR armed. START PG. 14 #3 Disarming: / Unlocking TR
Summary of the content on the page No. 4
OPERATING INSTRUCTIONS - ALARM Prior intrusion Alert This system will notify you if the alarm was tripped while you where away. Upon disarming, the two normal disarm chirps will be heard then the system will emit 4 additional siren chirps. Check your vehicle for any signs of a break in or tampering. Also see LED Diagnostics Section to determine the cause of the trigger. Remote Panic Protection To sound the alarm in an emergency situation or to draw attention to your vehicle, press a
Summary of the content on the page No. 5
OPERATING INSTRUCTIONS - ALARM Remote AUX. Output 2 (Optional) This system contains a second auxiliary output to activate other accessories or devices. To activate the systems’ Second Auxiliary Output, press and hold Button #3 (Trunk Symbol) on the transmitter for more than 2 seconds. This is a momentary output that will stay active as long as the remote button is held down. Remote output #2 requires programming before operation. Check with your installer or follow programming option
Summary of the content on the page No. 6
OPERATING INSTRUCTIONS - ALARM Optional M.A.P. (Mobile Accessories Protection) This system can be programmed to provide Crimestopper’s unique M.A.P. (Mobile Accessories Protection) feature that allows you to prevent unauthorized access of your vehicles Audio, Cellular, Navigation, or Entertainment systems. This feature is OPTIONAL and will requires extra parts and labor for installation. Consult your installation dealer about MAP before or during installation. The CS2011RS must be pro
Summary of the content on the page No. 7
REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START DIAGRAM: SOLID FLASH 1X AFTER IGN START 3 STARTER SEC. THEN SOLID REMOTE ENGINE STARTING - UNSUCCESSFUL START In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then nd rd attempts to restart the engine a 2 and 3 time. For hard starting engines, the unit will allow a starter crank time of up to13 seconds maximum. This should provide ample cranking time for difficult
Summary of the content on the page No. 8
REMOTE ENGINE CONTROL ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock/Disarm system (If armed) or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter & Shift out of park. 4) Remote starter will reset instantly when the brake is pressed. Parking lights will turn off and the ignition key is now controlling your vehicle. ID
Summary of the content on the page No. 9
REMOTE ENGINE CONTROL INFINITY RUN MODE This mode allows the vehicle’s engine to remain running INDEFINITELY. This mode can be beneficial to law enforcement vehicles or commercial vehicles that need to remain running unattended for long periods of time. INFINITY RUN MODE – EXITING THE VEHICLE: 1) Follow steps on the last page for “IDLE DOWN MODE - EXITING THE VEHICLE”, except press the remote start button TWO times at STEP #1. 2) Parking Lights will start flashing instead of coming o
Summary of the content on the page No. 10
REMOTE ENGINE CONTROL TIMED SELF START MODE This mode allows the vehicle to be programmed to self-start every 4 hours and run for the programmed run time. This can be helpful during extremely cold conditions where engine fluid freeze-up is a concern. THE VEHICLE MUST BE OUTDOORS OR IN A WELL VENILATED AREA. TIMED SELF-START MODE – EXITING THE VEHICLE: 1) Have engine running with the Key, then press and release the Start button. 2) Within the next 10 seconds press the valet/progra
Summary of the content on the page No. 11
OPTIONAL TURBO TIMER MODE OPTIONAL TURBO TIMER MODE: IMPORTANT NOTE: This mode requires the use of an extra part called a momentary switch or button that is not included with the kit. Check with your installer about adding this feature. The optional Turbo Timer mode allows the your system to keep your vehicle running for 1 to 5 minutes [selectively] after you remove the key, exit the vehicle, and lock the doors remotely [if you own a Turbo or Turbo Diesel]. This is handy for turbo coo
Summary of the content on the page No. 12
ANTI CARJACK PROTECTION REMOTE OPERATED CARJACK PROTECTION This feature provides Active Carjack protection through the remote control. When the Ignition is on (vehicle is running), press and hold the #1 LOCK Button and #3 TRUNK Button for 2 seconds. The parking lights will flash 2 times and the LED will begin to flash rapidly to confirm the beginning of a Carjack countdown. 30 Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-warning chirps turning into
Summary of the content on the page No. 13
TRANSMITTER PROGRAMMING Note: Remotes Transmitters come pre-programmed from the Factory. When re-learning remotes or adding remotes, ALL your system’s remote codes must be learned at time of programming!! This system allow storage of up to 4 different remote codes in memory. 1. Open hood (ground the Blue hood pin wire if no hood pin is installed.) 2. Turn key to the ON position. (Starting the vehicle is not necessary.) 3. Press Program/Valet button 4 times. After a few seconds, th
Summary of the content on the page No. 14
2 VEHICLE OPERATION The CS-2011RS Series IV system can be used for 2 car operation. A single remote can control two independent vehicles with an identical systems installed. See diagram below on how to switch your remote to car 2 operation. Follow the “Transmitter Programming” steps on the second vehicle and learn YOUR remote, along with Car #2’s existing remotes. NEW Push-Button 2-Car method: Your remote may have a push-button on the side in place of a slide- switch for 2-car oper
Summary of the content on the page No. 15
TROUBLESHOOTING: “BEFORE YOU CALL SECTION” Before calling your dealer or Crimestopper, read the following section for tips that may remedy or explain your problem. SYSTEM LED FLICKERS WHEN PRESSING REMOTE CONTROL BUTTONS: This is normal operation. There may be a slight flicker visible from the LED when pressing the remote as the system is authorizing the code from the remote control. There is nothing wrong with your system. UNIT CHIRPS 3X, FLASHES LIGHTS ONCE, BUT WILL NOT ATTE
Summary of the content on the page No. 16
www.crimestopper.com email@crimestopper.com ONLINE TECHNICAL SUPPORT Phone (800) 998-6880 www.crimestopper.com/techweb03.html FAX (805) 581-9500 © 2003 Crimestopper Security Products
