Graco Childwith Harness System user manual

Summary of the content on the page No. 1

INSTALLATION - with harness system
1 Place forward-facing on vehicle seat.
2 Lift seat pad flap, thread vehicle seat belt
through openings and buckle belt (fig. a).
Press down firmly in center of car seat to
3
compress vehicle seat cushion while tightening
vehicle seat belt.
HINT: Use your knee to press down in center
of car seat (fig. b).
Pull front to back and left to right to check for
4
secure installation (fig. c).
If not secure, see “Vehicle Seat Belts” section.
Attach tether hook (A)

Summary of the content on the page No. 2

HARNESS SYSTEM - removal and re-assembly Removal: Re-assembly: Lift adjuster bar and pull both harness straps When re-assembling harness system, be sure out of current slots. harness straps are not twisted. 1 Thread end of harness strap down through slot Pull harness strap out of car seat, harness tie, in seat pad, under both clips on bottom and and tongues. back up through slot in opposite side of car seat pad. Store all parts for future use. 2 Thread ends through tongues or shields (a

Summary of the content on the page No. 3

HARNESS SYSTEM - removal and re-assembly (continued) 3 4 2 5 1 Clip Clip 4

Summary of the content on the page No. 4

HEIGHT and WEIGHT LIMITS With Harness System Outgrowing Car Seat ❃ ❃ Child MUST meet all of the following requirements: • Weight is 30 - 40 lbs. (13.6 - 18.1 kg). WARNING  Minimum height is 35 inches (89 cm) tall. To avoid injuries from whiplash, top of  Child is able to sit upright unassisted . child’s ears must be below top edge of * headrest.  Child’s shoulders are not above top harness slots. With Harness System 30 lbs. 40 lbs. 80 lbs. (13.6 kg) (18.1 kg) (36.3 kg) Without Harness Syst