Summary of the content on the page No. 1
CLEANview
CYCLONIC
USER'S GUIDE
80E7 and 28F4 SERIES 220-240V
2
Thank You
3
Safety Instructions
4
Product View
5
Assembly
6-7
Operations
8-12
Maintenance and Care
13-14
Troubleshooting
14
Replacement Parts
15
Warranty
16
Consumer Services
Summary of the content on the page No. 2
Thanks for buying a BISSELL Cleanview™ Cyclonic We’re glad you purchased a BISSELL Cleanview cyclonic vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your BISSELL Cleanview cyclonic vacuum is well made, and we back it with a limited one year warranty. We also stand behind it with a knowl- edgeable, dedicated Consumer Services department, so, should you ever have a problem, you’ll receive fast, considerate a
Summary of the content on the page No. 3
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, ■ Young children should be supervised to ensure basic precautions should be observed, that they do not play with the appliance. including the following: ■ Remove plug from electrical outlet before cleaning or maintaining the appliance. REAd ALL ■ If the supply cord is damaged, it must be replaced by the manufacturer or its service INSTRUCTIONS agent in order to avoid a hazard. BEFORE USINg YOUR ■ Do not pick up toxic
Summary of the content on the page No. 4
Product view Cord Clip Hose Clip Deluxe Stretch Hose Handle ™ TurboBrush Tool (select models only) Crevice Tool Carrying Handle Extension Twist 'n Wand Quick ™ Snap Hose ™ Release Connector Cord Wrap Quick ™ Reach Handle Combination Primary Dusting Separator Hose Wand Brush/ Upholstery Upper Tank Tool Hose Power Cord Wand Base Inner and Power Switch Outer Dirt Circular Handle Container Filters Release Pedal Filter Cup Pre-Motor Lock ’n ™ Filter Seal Lever Foot Hose HEPA
Summary of the content on the page No. 5
Assembly The only tool you’ll need to assemble your vacuum cleaner is a screwdriver. WARNING: Attach handle to vacuum Plastic film can be dangerous. To avoid danger of suffocation, keep 1. Locate the vacuum handle and remove away from babies and children. the screw packet taped to the base of the handle. 2. Stand the vacuum upright and place the handle on the top of the vacuum body. 3. Insert the screws into the existing holes on each side. Tighten securely with a screwdriver. Attach
Summary of the content on the page No. 6
Operations Handle position 1 Press the handle release pedal with your foot to place your BISSELL Cleanview cyclonic bagless vacuum into one of three cleaning positions. 2 1. Upright- For storage and above floor cleaning with special tools. 2. Normal Cleaning- Press handle release pedal once. Use for most household floor 3 cleaning tasks. 3. Low Cleaning- With the vacuum in normal cleaning position, press handle release pedal again. Use for reaching under low furniture such as tables, c
Summary of the content on the page No. 7
Operations Special tools NOTICE: The floor brush will continue to rotate while Your BISSELL Cleanview cyclonic bagless you use your vacuum for above floor vacuum is not only a powerful carpet cleaning. To prevent carpet damage, do and rug vacuum cleaner, it’s also a ver- not lean on the vacuum or let the power- satile above floor vacuum cleaner when foot tilt forward. you select one of the special tools. 1. Raise handle to upright position. Tip: 2. Grasp the Quick Reach handle and lift
Summary of the content on the page No. 8
Maintenance and care To maintain maximum cleaning performance from your BISSELL Cleanview cyclonic bagless vacuum, WARNING: perform these simple maintenance To reduce the risk of electric shock, turn steps. power switch OFF and disconnect plug 1. Empty the dirt container when the dirt from electrical outlet before performing maintenance or troubleshooting checks. reaches the “Full” line on the side. 2. Check the inner and outer circular filters, and the pre-motor filter at least once
Summary of the content on the page No. 9
Maintenance and care Cleaning the inner & outer circular filters 1. Unplug cleaner from electrical outlet. 2. Remove the dirt container as described NOTICE: in the previous section. Grasp the filter This product is intended for household use only and not for commercial or industrial cup located at the bottom of the dirt use. Vacuuming of dust from products like container and twist counterclockwise to plaster, concrete or ashes will damage the unlock and remove. motor and void the warr
Summary of the content on the page No. 10
Maintenance and care Replacing the HEP A media post-motor filter * The post-motor filter is a H13 HEPA media filter*, which assists in the filtration process to return clean air to the room. 1. Unplug the vacuum from electrical outlet. HEPA Media 2. Remove the filter door, located on the Post-Motor front of the vacuum. Filter* 3. Remove the post motor filter. 4. Replace the post-motor filter with a new filter. NOTE: The post-motor filter is a white pleated HEPA media filter*. Thi
Summary of the content on the page No. 11
Maintenance and care Check r otating floor brush and drive belt You should check your vacuum cleaner’s rotating floor brush and drive belt regu- larly for wear or damage. You should also clean the brush and brush ends of string, hair and carpet fibers. These can wrap around the brush and hamper its ability to effectively clean your carpet. Also remove any debris that has accu- mulated under the brush cover. 1. Unplug cleaner from electrical outlet. Brush 2. Place handle in low position an
Summary of the content on the page No. 12
Maintenance and care Clearing clog Low suction, poor pickup or no suction may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the vacuum motor or a reduction in the spinning action in the dirt container, check for clogs. Primary Separator 1. Unplug cleaner from electrical outlet. 2. Empty dirt container. 3. Check upper tank and primary separa- tor for build up or clogs. Check to make sure primary separator is installed cor- rectly. To unlock the primary sepa
Summary of the content on the page No. 13
Troubleshooting WARNING: To reduce the risk of electric shock, turn power OFF and dis- connect plug from electrical outlet before performing maintenance or troubleshooting. Vacuum cleaner won’t turn on Possible causes Remedies 1. Power cord not firmly plugged in 1. Check electrical plug Vacuum cleaner won't pick up dirt Possible causes Remedies 1. Incorrect height adjustment 1. Adjust powerfoot to correct height setting 2. Hose not attached to suction opening 2. Grasp Quick Release handl
Summary of the content on the page No. 14
Troubleshooting Visible dirt escaping from cleaner continued Possible causes Remedies 3. Dirt container installed incorrectly 3. Position correctly and lock into place 4. Filter cup installed incorrectly 4. Remove dirt container and make sure filter cup is fully attached Other maintenance or service not included in the manual should be performed by an authorized service representative. Thank you for selecting a BISSELL product. Please do not return this pr oduct to the store.
Summary of the content on the page No. 15
Warranty This warranty gives you specific legal rights, and you may also have other rights which may vary from country to country. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Services by telephone, or regular post as described below, or contact your local in country distributor. Limited One Year Warranty Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, BISSELL Homecare, Inc., will rep
Summary of the content on the page No. 16
BISSELL consumer services If your BISSELL product should require service: Call BISSELL Consumer Services at the numbers below and we will give you the location of a BISSELL Authorized Service Center in your area. For all other countries, contact your local in country distributor for questions, service, or repair. If you have questions about your warranty or need replacement parts please contact the numbers below. For UK inquiries: For spare parts and accessories: Monday - Thursday 9 am — 5
