Summary of the content on the page No. 1
COMPACT COMPONENT SYSTEM
MX-K50
Consists of CA-MXK50 and SP-MXK50
CA-MXK50 SP-MXK50
DISC CHANGE
STANDBY
STANDBY/ON
3 CD
CD-R/RW PLAYBACK
SOUND
MX-K50
MODE
CLOCK
/TIMER
STANDBY/ON
DISPLAY
12 3 ACTIVE BASS
SLEEP
EX. LEVEL
ACTIVE BASS EXTENSION
4 5 6
SOUND
AUX MODE
78 9
FM MODE
10 +10 FM
CD TAPE
AUX /AM
KARAOKE ECHO
FM/AM TAPE FADE TUNING
TAPE A/B MUTING
PROGRAM RANDOM TAPE A TAPE B
PHONES REPEAT
ACTIVE BASS
CD DISC
SKIP REC START CD REC EX. LEVEL
/STOP START DUBBING
COMPU PLAY CONTROL
+
VOLUME
V
Summary of the content on the page No. 2
Warnings, Cautions and Others Caution –– switch! Disconnect the mains plug to shut the power off com- pletely. The switch in any position does not discon- nect the mains line. The power can be remote controlled. – G-1 – MX-K50[U]safety.pm6 1 02.5.10, 9:57 AM
Summary of the content on the page No. 3
CAUTION CAUTION To reduce the risk of electrical shocks, fire, etc.: • Do not block the ventilation openings or holes. 1. Do not remove screws, covers or cabinet. (If the ventilation openings or holes are blocked by a 2. Do not expose this appliance to rain or moisture. newspaper or cloth, etc., the heat may not be able to get out.) • Do not place any naked flame sources, such as lighted candles, on the apparatus. • When discarding batteries, environmental problems must be considered and local r
Summary of the content on the page No. 4
Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1 Front: No obstructions and open spacing. 2 Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3 Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. 15 cm 15 cm 1 cm 1 cm 15 cm 15 cm 15 cm CA-MXG50 CA-MXG50 10 cm – G-3 – MX-K50[U]safety.pm6 3
Summary of the content on the page No. 5
IMPORTANT FOR LASER PRODUCTS / REPRODUCTION OF LABELS / 1 CLASSIFICATION LABEL, PLACED ON ON EXTERIOR 2 WARNING LABEL, PLACED INSIDE THE UNIT SURFACE ADVARSEL: Usynlig laser- VARO: Avattaessa ja suo- DANGER: Invisible laser VARNING: Osynlig laser- stråling ved åbning, når jalukitus ohitettaessa olet radiation when open and strålning när denna del är sikkerhedsafbrydere er ude alttiina näkymättömälle interlock failed or defeated. öppnad och spärren är CLASS 1 af funktion. Undgå udsæt- l
Summary of the content on the page No. 6
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging from the wall outlet, always pull the This manual is organized as follows: plug, not the AC power cord. • The manual mainly explains operations using the DO NOT handle the AC power cord with wet hand
Summary of the content on the page No. 7
Contents Location of the Buttons and Controls ....................... 3 Front Panel ................................................................. 3 Remote Control .......................................................... 5 Getting Started............................................................ 6 Unpacking .................................................................. 6 Putting the Batteries into the Remote Control ........... 6 Connecting Antennas ...................................
Summary of the content on the page No. 8
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel i DISC CHANGE STANDBY o 1 STANDBY/ON ; 2 a 3 CD CD-R/RW PLAYBACK s 3 d 4 5 SOUND MX-K50 MODE f 6 7 CLOCK /TIMER 8 DISPLAY 9 g ACTIVE BASS EXTENTION p h q w FM CD TAPE AUX /AM j TAPE A TAPE B REPEAT PROGRAM RANDOM PHONES ACTIVE BASS EX. LEVEL REC START CD REC /STOP START DUBBING e k COMPU PLAY CONTROL r t y u l FULL - LOGIC CONTROL CD SYNCHRO RECORDING – 3 – EN01-12.MX-K50[U].pm6 3 02.5
Summary of the content on the page No. 9
Continued Display Window 3 1 2 4 5 6 7 q 8 9 p See pages in the parentheses for details. a Disc number buttons and lamps (CD1, CD2, and CD3) (14 – 16, 19) Front Panel Pressing one of these buttons also turns on the unit. 1 STANDBY/ON button and STANDBY lamp (9, 10) s SET button (9, 12, 15, 21 – 23) 2 CLOCK/TIMER button (9, 21 – 23) d CANCEL/DEMO button (8, 9, 15, 21, 22) 3 DISPLAY button (9) f SOUND MODE control (11) 4 PRESET +/– buttons (12) g VOLUME control (10, 20) 4/¢ (reverse search/forward
Summary of the content on the page No. 10
Remote Control Remote Control 1 STANDBY/ON button (9) 2 SLEEP button (23) 3 AUX button (10) STANDBY/ON Pressing this button also turns on the unit. 4 Number buttons (12, 14) 12 3 ACTIVE BASS 1 5 KARAOKE button (20) EX. LEVEL SLEEP 6 TAPE 3 button (10, 17) 2 q 4 5 6 SOUND AUX MODE Pressing this button also turns on the unit. 3 78 9 w 7 FM/AM button (10, 12) FM MODE Pressing this button also turns on the unit. +10 10 e 4 8 CD 6 button (10, 13 – 15) 5 KARAOKE ECHO r Pressing this button also turns
Summary of the content on the page No. 11
Getting Started Continued Unpacking Connecting Antennas After unpacking, check to be sure that you have all the FM antenna following items. The number in the parentheses indicates the quantity of the pieces supplied. FM antenna (supplied) • AM loop antenna (1) • FM antenna (1) • Remote control (1) • Batteries (2) • AC plug adaptor (1) If any is missing, consult your dealer immediately. Putting the Batteries into the Remote Control 1 Attach the FM antenna to the FM [75 Ω ] Insert the batteries—UM
Summary of the content on the page No. 12
AM antenna Connecting Speakers 2, 3 1 1 2, 3 Vinyl-covered wire (not supplied) ANTENNA [ ] FM 75 AM Red SPEAKER [ ] 6-16 Speaker Speaker cord cord (red/black) (red/black) Black AM loop antenna (supplied) 1 Press and hold the clamp of the AM terminal From right From left speaker’s speaker’s on the rear of the unit. terminals terminals 2 Insert the end of the AM loop antenna cord into the terminal. 1 Press and hold the clamp of the speaker • If the AM loop antenna wire is
Summary of the content on the page No. 13
110 110 127 127 NOW, you can plug in the unit and other Connecting Other Equipment connected equipment FINALLY! You can connect an audio equipment. • DO NOT connect any equipment while the power Canceling the Display Demonstration is on. • DO NOT plug in any equipment until all When connecting the AC power cord into a wall outlet, the connections are complete. unit automatically starts display demonstration. On the unit ONLY: To connect an analog component To cancel the display demonstration, pr
Summary of the content on the page No. 14
Common Operations Turning On or Off the Power 3 Press 4 or ¢ to adjust the minute, then press SET. STANDBY To turn on the unit, press STANDBY/ STANDBY/ON ON so that the STANDBY lamp goes off. SET STANDBY To turn off the unit (on standby), press STANDBY/ON STANDBY/ON again so that the STANDBY lamp lights up. To check the clock time DISPLAY Press DISPLAY while playing any source. • Each time you press the button, the source A little power is always consumed even while the unit is on indication and
Summary of the content on the page No. 15
Continued Setting the AM Tuner Interval Spacing Adjusting the Volume Some countries space AM stations 9 kHz apart, and some You can adjust the volume level only while the unit is turned on. countries use 10 kHz spacing. • This function works only when the unit is turned off. Turn the VOLUME control clockwise to • 9 kHz spacing is the initial setting. increase the volume or counterclockwise to decrease it. On the unit ONLY: • The volume level can be adjusted in 32 To select 10 kHz, press STANDBY/
Summary of the content on the page No. 16
• As you turn the control, the sound modes change as Reinforcing the Bass Sound follows: This function only affects the playback sound, not your D.CLUB HALL STADIUM ROCK recording. (Dance CLUB) The ACTIVE BASS EX. (extension) LEVEL control OFF provided for this unit can maintain the richness and fullness CLASSIC POP (Canceled) of the bass sound while listening to any source at low volume. Surround modes*: Turn the ACTIVE BASS EX. LEVEL D.CLUB : Increases resonance and bass. control clockwise to
Summary of the content on the page No. 17
Listening to the Radio Before operating the tuner, make sure you have selected On the unit ONLY: the correct AM Tuner interval spacing (see page 10). 1 Tune in the station you want to preset (in this example, of FM 87.50). Tuning in a Station • See “Tuning in a Station”. 1 Press FM/AM. The unit automatically turns on and tunes FM /AM SET in the previously tuned station (either FM 2 Press SET. or AM). • Each time you press the button, the band alternates between FM and AM. 2 Start searching for
Summary of the content on the page No. 18
. Playing Back CDs DISC CHANGE This unit has been designed to playback the following CDs: 3 If you wish to load a third disc, Audio CD, CD-R, and CD-RW. press DISC CHANGE on the unit or DISC SKIP on the remote DISC When playing a CD-R or CD-RW SKIP control. User-edited CD-Rs (CD-Recordable) and CD-RWs The disc tray rotates by 120˚. (CD-ReWritable) can be played back when they are already “finalized.” • You can play back your original CD-Rs or CD-RWs 4 Press 0 again. recorded in music CD format O
Summary of the content on the page No. 19
Continued Basic CD Operations 3 Press one of the disc number buttons (CD1, CD2 or CD3) While playing a CD, you can do the following operations. for the disc you want to start to play from. To exchange CDs during playback of another CD play starts from the first track of the DISC CHANGE Press DISC CHANGE to change the CD and the selected disc. carrousel comes out. • Pressing CD 6 instead of the disc number buttons If you change CDs during play, the current play starts playing back if a CD is on t
Summary of the content on the page No. 20
5 Program other tracks you want. Programing the Playing Order of the Tracks • To program tracks from the same disc, repeat step 4. —–Program Play • To program tracks from a different disc, repeat steps 3 and 4. You can arrange the order in which the tracks play before you start playing. You can program up to 32 tracks. 6 Press CD 6. • To use Repeat play (see page 16) for Program play, press CD The tracks are played in the order you REPEAT after starting Program play. have programed. On the unit
