Our goal is to provide you with a quick access to the content of the user manual for Zanussi ZBT6234. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with Zanussi ZBT6234.
If looking through the Zanussi ZBT6234 user manual directly on this website is not convenient for you, there are two possible solutions:
Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual Zanussi ZBT6234 but the selected pages only. paper.
Below you will find previews of the content of the user manuals presented on the following pages to Zanussi ZBT6234. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
squashed or damaged power plug may overheat Care and cleaning and cause a fire. • Before maintenance, switch off the appliance and dis- 3. Make sure that you can come to the mains plug connect the mains plug from the mains socket. of the appliance. • Do not clean the appliance with metal objects. 4. Do not pull the mains cable. • Do not use sharp objects to remove frost from the ap- 5. If the power plug socket is loose, do not insert pliance. Use a plastic scraper. the power plug. There is a ris
Environment Protection bish. The insulation foam contains flammable gases: the appliance shall be disposed according to the appli- This appliance does not contain gasses which cable regulations to obtain from your local authorities. could damage the ozone layer, in either its refrig- Avoid damaging the cooling unit, especially at the rear erant circuit or insulation materials. The appliance shall near the heat exchanger. The materials used on this ap- not be discarded together with the urban ref
Frozen Food Calendar Movable shelves The walls of the refrigera- tor are equipped with a series of runners so that the shelves can be posi- tioned as desired. The symbols show different types of frozen goods. The numbers indicate storage times in months for the Positioning the door shelves appropriate types of frozen goods. Whether the upper or lower value of the indicated storage time is valid de- To permit storage of food pends on the quality of the foods and treating before packages of variou
Butter and cheese: these should be placed in special air- • lean foods store better and longer than fatty ones; tight containers or wrapped in aluminium foil or poly- salt reduces the storage life of food; thene bags to exclude as much air as possible. • water ices, if consumed immediately after removal Milk bottles: these should have a cap and should be stor- from the freezer compartment, can possibly cause ed in the bottle rack on the door. the skin to be freeze burnt; Bananas, potatoes, onion
It is important to periodically clean the defrost water 5. Switch on the appliance. drain hole in the middle of the refrigerator compartment 6. Set the temperature regulator to obtain the maxi- channel to prevent the water overflowing and dripping mum coldness and run the appliance for two or onto the food inside. Use the special cleaner provided, three hours using this setting. which you will find already inserted into the drain hole. 7. Reload the previously removed food into the com- partment
Problem Possible cause Solution The lamp is defective. Refer to "Replacing the lamp". The compressor operates con- The temperature is not set correctly. Set a higher temperature. tinually. The door is not closed correctly. Refer to "Closing the door". The door has been opened too fre- Do not keep the door open longer than quently. necessary. The product temperature is too high. Let the product temperature decrease to room temperature before storage. The room temperature is too high. Decreas
7. Open the door. Make sure that the light comes on. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Con- Closing the door tact the Service Center. 1. Clean the door gaskets. Technical data Dimension of the recess Height 1446 mm Width 560 mm Depth 550 mm Rising Time 20 h The technical information are situated in the rating plate on the internal left side of the appliance and in the ener- gy label. Installation Electrical co
On the opposite side: • Install the lower pin. • Install the lower door. • Tighten the middle hinge. • Install the upper door. • Tighten the spacer and tighten the upper pin. • Loosen the upper pin • Loosen the middle • Remove the lower door. and remove the spacer. hinge. • Loosen the lower pin. • Remove the upper pin and the upper door. Ventilation requirements Installing the appliance Caution! Make sure that the mains cable can The airflow behind the ap- min. move freely. 50 mm 2 pliance must
2 I 4mm 1 44mm I Install the appliance in the Adjust the appliance in the Attach the appliance to the Push the sealing strip be- niche. niche. niche with 4 screws. tween the appliance and Push the appliance in the The lower hinge cover (in the adjacent cabinet. direction of the arrows (1) the accessories bag) until the upper gap cover makes sure that the dis- stops against the kitchen tance between the appli- furniture. Make sure that ance and the kitchen furni- the distance between the ture is
8 mm 8 mm Ha K Ha Hc Ha Hb Hb Push the part (Hc) on the Open the appliance door Remove the brackets and Place the small square on part (Ha). and the kitchen furniture mark a distance of 8 mm the guide again and fix it door at an angle of 90°. from the outer edge of the with the screws supplied. Insert the small square door where the nail must Align the kitchen furniture (Hb) into guide (Ha). be fitted (K). door and the appliance Put together the appliance door by adjusting the part door and the