Zanussi ZI 428 D user manual

User manual for the device Zanussi ZI 428 D

Device: Zanussi ZI 428 D
Size: 0,28 MB
Date of adding : 2013-06-28 18:46:25
Number of pages: 10
Print the manual


How to use this site?

Our goal is to provide you with a quick access to the content of the user manual for Zanussi ZI 428 D. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with Zanussi ZI 428 D.

For your convenience

If looking through the Zanussi ZI 428 D user manual directly on this website is not convenient for you, there are two possible solutions:

  • Full Screen Viewing - to easily view the user manual (without downloading it to your computer), you can use full-screen viewing mode. To start viewing the user manualZanussi ZI 428 D on full screen, use the buttonFullscreen.
  • Downloading to your computer - You can also download the user manual Zanussi ZI 428 D to your computer and keep it in your files. However, if you do not want to take up too much of your disk space, you can always download it in the future from ManualsBase.
Zanussi ZI 428 D user manual
« Page 1 of 10 »
Print version

Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual Zanussi ZI 428 D but the selected pages only. paper.


Below you will find previews of the content of the user manuals presented on the following pages to Zanussi ZI 428 D. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.

Abstracts of contents
Summary of the content on the page No. 1

ZI 428 D
2222 126-83
This document was created with FrameMaker 4.0.4

Summary of the content on the page No. 2

CONTENTS Warnings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 12 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 13 Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 13 Power connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 13 Cleaning the appliance’s interior . . . . . . . . . . . . . . . . . . . . . . . .page 13 Instructions for total built-in . . . . . . . . . . . . . . . . . . . . .

Summary of the content on the page No. 3

WARNINGS It is most important that this instruction book should be ª The inner lining of the appliance consists of retained with the appliance for future reference. Should the channels through which the refrigerant passes. If appliance be sold or transferred to another owner, or should these should be punctured this would damage the you move house and leave the appliance, always ensure that the appliance beyond repair and cause food loss. DO book is supplied with the appliance in order tha

Summary of the content on the page No. 4

INSTALLATION If this refrigerator featuring magnetic door seals is to replace The manufacturer declines to accept any liability if this an older appliance having a spring lock on the door or lid, be accident-prevention procedure is not followed. sure to make that spring lock unusable before you discard the This appliance complies with E.E.C. directive old appliance. no. 87/308 of 2.6.87 relative to radio interference This will prevent it from becoming a death-trap for a chi

Summary of the content on the page No. 5

For appropriate venting, follow indications in Open the door and push the appliance against the Fig. 2. side of kitchen furniture opposite to that of appliance hinges. Fig. 2 2 50-min. cm 200 Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grill (C) and hinge cover (D) into position. Fig. 5 min. 2 cm 200 D D033 Push appliance into housing until stop strip (A) C D502 touches the kitchen unit. Press in the joint covers between the applia

Summary of the content on the page No. 6

20mm Position the runners (H) at the top and bottom of Remove the little plates and make the holes with a the inside of the kitchen unit as shown in Fig. 8 and diam. of 2 mm. Replace the little plates over the mark the position of the external holes. runners and screw in the screws provided After preparing the holes, screw the runners to the (3.5x16 mm). kitchen unit door using 3.5x16 mm screws. For the alignment of the kitchen unit door, if necessary, use the clearance size of the sl

Summary of the content on the page No. 7

USE and do not open the door too often. Starting-up and temperature regulation Freezing is completed after 24 hours from the start. Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to On the inner door of the compartment you be found on the top right hand side of the inner will find a list of foods followed by a number. These liner, clockwise beyond the «O» position, to start numbers indicate the maximum period of time for the appliance. whi

Summary of the content on the page No. 8

For more thorough cleaning, the top door shelf can Food refrigeration be removed by pulling it in the direction of the To achieve the best results with the refrigerator arrows, then refitting it in position (Fig. 13). compartment, you should follow one or two very Fig. 13 simple rules: Do not put warm foods or evaporating liquids in the refrigerator. Cover or wrap foods (particularly if they have a strong smell). Do not cover the shelves (grids) with paper or plastic sinc

Summary of the content on the page No. 9

To carry out complete defrosting of the ( ) freezer compartment proceed as follows: Unplug the appliance from the power supply or set the thermostat to position «O». Remove the frozen foods and wrap them in several sheets of newspaper, then keep them in a cool place. Leave the door open. Place a basin on the refrigerator compartment shelf underneath the drainage hole and pull the plug downward (Fig. 15); to reinsert it, just push it up. The plug can be removed by pulling it downward

Summary of the content on the page No. 10

MAINTENANCE Unplug the appliance before carrying out any Replacing the interior light bulb maintenance operation. The light inside the refrigerator compartment is Clean the interior periodically with lukewarm easy to get at through the opening in the light water and some sodium bicarbonate; the cabinet holder. exterior with a silicone wax spray; the condenser If the light does not go on when the door is open, and the motor compressor with a brush or a vacuum check that it is screwed

Similar user manuals
# User manual Category Download
1 Zanussi 102213 Refrigerator 245
2 Zanussi 102212 Refrigerator 19
3 Zanussi 102232 Refrigerator 10
4 Zanussi 102234 Refrigerator 17
5 Zanussi 102217 Refrigerator 17