Our goal is to provide you with a quick access to the content of the user manual for Electrolux ERN16510. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with Electrolux ERN16510.
If looking through the Electrolux ERN16510 user manual directly on this website is not convenient for you, there are two possible solutions:
Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual Electrolux ERN16510 but the selected pages only. paper.
Below you will find previews of the content of the user manuals presented on the following pages to Electrolux ERN16510. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.
2 electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information 2 Care and cleaning 6 Operation 4 What to do if… 7 First use 4 Technical data 8 Daily use 4Installation 8 Helpful hints and tips 5 Environmental concerns 13 Subject to change without notice SAFETY INFORMATION In the interest of your safety and to ensure lid, be sure to make that spring lock un- the correct use, before installing and first usable before you discard the
electrolux 3 damage to the cord may cause a short- • Do not clean the appliance with metal circuit, fire and/or electric shock. objects. • Regularly examine the drain in the refrig- Warning! Any electrical component erator for defrosted water. If necessary, (power cord, plug, compressor) must clean the drain. If the drain is blocked, be replaced by a certified service agent water will collect in the bottom of the ap- or qualified service personnel to avoid pliance. hazard. Installation 1. Power
4 electrolux Environment Protection ance shall be disposed according to the applicable regulations to obtain This appliance does not contain gasses from your local authorities. Avoid dam- which could damage the ozone layer, aging the cooling unit, especially at the in either its refrigerant circuit or insula- rear near the heat exchanger. The ma- tion materials. The appliance shall not terials used on this appliance marked be discarded together with the urban by the symbol are recyclable. refus
electrolux 5 gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Positioning the door shelves To permit storage of food packages of vari- ous sizes, the door shelves can be placed at different heights. To make these adjustments proceed as fol- lows: HELPFUL HINTS AND TIPS Normal Operating Sounds ture Regulator toward warmer settings to allow automatic defrosting and so a sav- • You may hear a faint gurgling and a bub- ing in electricity consu
6 electrolux Butter and cheese: these should be placed Bananas, potatoes, onions and garlic, if not in special airtight containers or wrapped in packed, must not be kept in the refrigera- aluminium foil or polythene bags to exclude tor. as much air as possible. Milk bottles: these should have a cap and should be stored in the bottle rack on the door. CARE AND CLEANING Caution! Unplug the appliance before Defrosting of the refrigerator carrying out any maintenance Frost is automatically eliminate
electrolux 7 • leave the door/doors ajar to prevent un- the food inside from spoiling in case of a pleasant smells. power failure. If the cabinet will be kept on, ask some- body to check it once in a while to prevent WHAT TO DO IF… Warning! Before troubleshooting, Important! There are some sounds during disconnect the mains plug from the normal use (compressor, refrigerant mains socket. circulation). Only a qualified electrician or compe- tent person must do the troubleshoot- ing that is not in
8 electrolux Problem Possible cause Solution The product temperature is too Let the product temperature de- high. crease to room temperature be- fore storage. Many products are stored at the Store less products at the same same time. time. There is no cold air circulation in Make sure that there is cold air the appliance. circulation in the appliance. Replacing the lamp 1. Disconnect the mains plug from the mains socket. 2. Remove the screw from the lamp cover. 3. Remove the lamp cover (refer
electrolux 9 Positioning Blue: Neutral 5 Install this appliance at a location where the ambient temperature corresponds to the As the colours of the wires in the mains climate class indicated on the rating plate of lead of this appliance may not correspond the appliance: with the coloured markings identifying the terminals in your plug, proceed as follows: Climate Ambient temperature 1. Connect the wire coloured green and class yellow to the terminal marked either with SN +10°C to + 32°C the let
10 electrolux min. 2 200 cm min. 2 200 cm On the opposite side: Installing the appliance 1. Tighten the lower pin. Caution! Make sure that the mains 2. Install the spacer. cable can move freely. 3. Install the door. 4. Tighten the upper pin. Do the following steps: 1. Apply the adhesive sealing strip to the appliance as shown in figure. Ventilation requirements The airflow behind the appliance must be sufficient.
electrolux 11 2. Install the appliance in the niche. 4. Attach the appliance to the niche with 4 Push the appliance in the direction of screws. the arrows (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrows (2) against the cupboard on the opposite side of the hinge. I 2 5. Remove the correct part from the hinge 1 cover (E). Make sure to remove the part DX, in the case of right hinge, SX in op- posite case. 3. Adjust the appliance i
12 electrolux 6. Attach the covers (C, D) to the lugs and 9. Push the part (Hc) on the part (Ha). the hinge holes. Attach the hinge covers (E) to the hinge. Ha C D Hc E 10. Open the appliance door and the kitch- E en furniture door at an angle of 90°. Insert the small square (Hb) into guide 7. Disconnect the parts (Ha), (Hb), (Hc) (Ha). and (Hd). Put together the appliance door and the furniture door and mark the holes. Ha Hb 8 mm Hc Ha Hd Hb 8. Install the part (Ha) on the inner side of the kit
electrolux 13 11. Remove the brackets and mark a dis- 13. Press the part (Hd) on the part (Hb). tance of 8 mm from the outer edge of the door where the nail must be fitted (K). 8 mm Hb K Hd Ha Do a final check to make sure that: • All screws are tightened. • The magnetic sealing strip is attached 12. Place the small square on the guide tightly to the cabinet. again and fix it with the screws sup- Important! If the ambient temperature is plied. low (for example, in the Winter), the size of Align