Our goal is to provide you with a quick access to the content of the user manual for Haier HR-155S. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with Haier HR-155S.
If looking through the Haier HR-155S user manual directly on this website is not convenient for you, there are two possible solutions:
Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual Haier HR-155S but the selected pages only. paper.
Below you will find previews of the content of the user manuals presented on the following pages to Haier HR-155S. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.
H R - 1 5 5 S
D o m e s t i c R e f r i g e r a t o r
O p e r a t i o n I n s t r u c t i o n s
Basi c Operation 5
Operatio n Instructions 6-7
Cautions All these valuable materials may be taken Disposal of the old appliance to a waste collecting center and used again Before disposing an old appliance that goes after adequate recycling. out of use, please make sure it’s inoperative and safe. Unplug the appliance and remove Consult your local authorities for the name or destroy all of the springs, latches, or and address of the waste materials collecting boltlocks in order to avoid the risk of child centers and waste paper disposal serv
Cautions For the purpose of safety, the appliance If the supply cord is damaged, it must must be properly grounded in accordance be replaced by the manufacturer or its service with specifications. agent or a similarly qualified person in order to avoid a hazard. Always remember to unplug the appliance before cleaning. Never unplug your refrigerator by pulling on the power cord. Specifications Always grip plug firmly and pull straight out from the outlet. This appliance
Parts (1) (2) (3) (4) (5) (7) (8) (6) (5)=Shelf (1)=Evaporator door (6)=Vegetable box (2)=Ice-tray (7)=Bottle rack (3)=Evaporator (8) Knob of thermostat (4)=Drip tray The manufacturer reserves the right to improve the product from time to time without further notice. .3.
Installation The appliance must stand on even flooring.If the freezer is not level, adjust the front leveling leg to raise or lower it. Install the appliance in a well-ventilated Do not expose the appliance to direct room. Allow 10cm on each side and 10cm sunlight or a heat source as cookers, over the top of the freezer for easy radiators, heaters, etc. installation and proper air circulation. >10cm >10cm An extremely cold room is unsuitable To prevent electric shock,
2 3 4 5 Basic Operation Clean the inner compartment before using. After the refrigerator is levelled and cleaned,wait 30 minutes or more before plugging in. Start-up Clean the refrigerator briefly. After 2 or 3 hours of non-load operation,the inner compartment is cold enough and suitable for food storage. Temperature selection Adjust the inner temperature according to the ambient temperature and the amount of food. Application Setting 1-2 summer,ambient temperature 25°C-
Operation Instructions Do not make the inner temperature lower than necessary. Adjust the temperature regulator in accordance with the ambient temperature and the amount of food. To lower the power consumption, allow warm foods and beverages to cool down before storing them in the refrigerator. For cold air circulation in the inner compartment, do not overfill the shelves. Wrap or pack the foods to be refrigerated separately to keep the strong smells from giving off and to
Operation Instructions Bottles of beverages that may get cracked when frozen should not be stored in the evaporator. Medicine or valuable scientific specimen should not be stored in the refrigerator. Keep off the cold surface of the evaporator especially when hands are wet. When the plug is pulled out, wait 3 minutes or more before plug in again. Otherwise it may do harm to the compressor. When not in use Unplug the appliance. Clean the inner compartment thoroughly. Leav
Defrosting/Cleaning Defrosting The surface of evaporator ices up when the refrigerator is working. When the frost layer is thick as 3mm, the refrigerator must be defrosted and cleaned. Otherwise, it may results in lower efficiency and high energy consumption. Set the temperature at ‘0’ position. After defrosting, dry the water tray and then replace it in the refrigerator. Reset the temperature regulator to its original position. Note: Never use a sharp or pointed item to
Defrosting/Cleaning Cleaning 1. Unplug the appliance. 2. Wash the inner compartment with lukewarm water and neutral detergent. 3. Dry the surface of the refrigerator thoroughly. Note: 1. Avoid splashing water on the freezer when cleaning. 2. Do not use cleansers such as soaps, paint, boiled water or acid, etc. 3. When using a chemical rag, do not scratch the inner surfaces hardly. For efficient operation, dirt and dust should be removed from back and bottom of your freezer from time
Troubleshooting Before calling the service center, check the following points and see if you can solve the problem yourself. Problem Possible Causes Electrical connection is loose. No refrigeration Fuse is broken. Wrong temperature selection. The inner compartment is overfilled. The inner Temperature The appliance is exposed to direct sunlight or is not cold enough. a heat source, such as heater. Frequent door opens. The appliance doesn’t stand level. Unusual noises Some part of the refrigerator