Summary of the content on the page No. 1
FRIGIDAIRE
C O M M E R C I A L
COMMERCIAL FREEZER/REFRIGERATOR
GLASS DOOR REFRIGERATOR
TABLE OF CONTENTS
Product Registration………………………………….…..... 2
Important Safety Instructions……………………….…..... 2
Electrical Information…………………………………........ 3
Caster Installation and Setup (Glass Door)................... 3-4
Caster Installation and Setup (Non-Glass Door).......... 5-6
Appliance Start-up…………………………………............. 6
Features……………………………………………………..... 6-7
Routine Maintenance…………………………………….
Summary of the content on the page No. 2
Product Registration Important Safety Instructions Read all instructions before using this appliance For Your Safety Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this unit or any other appliance. Read product labels for flammability and other warnings. Child Safety • Destroy carton, plastic bags, and any exterior wrapping material immediately after the appliance is unpacked. Children should never use these items for play. Cartons covered with rugs, bedspr
Summary of the content on the page No. 3
CASTER INSTALLATION AND SET-UP Electrical Information (Glass Door Only) These guidelines must be followed to ensure that safety mechanisms in the design of this appliance will operate Inspect the underside of the cabinet and packaging for damage properly. such as a fork truck can cause. If hidden damage is found after uncrating, immediately call the delivery carrier and request an inspection. Retain all packaging and crating materials until the Avoid fire hazard or inspecti
Summary of the content on the page No. 4
• Remove bottom door support bracket and screw opposite the REAR SWIVEL CASTER INSTALLATION door hinge using a 3/8" socket wrench (see Fig. 3). • Place a washer on one of the four long bolts and then feed the bolt through the hole in one of the swivel casters (see Fig. 6). • Next, insert that same caster bolt through the hole on the metal spacer plate and then thru the rear hole of the caster rail (see DOOR SUPPORT Fig. 7). BRACKET • Thread the caster bolt into the hole in the bottom-most foo
Summary of the content on the page No. 5
CASTER INSTALLATION AND SET-UP (NON-GLASS DOOR) INSPECTION FOR DAMAGE CASTER RAIL INSTALLATION Inspect the underside of the cabinet and packaging for damage such as a Place a washer onto one of the six long bolts and slide bolt through the fork truck can cause. If hidden damage is found after uncrating, hole located at the front of caster rail. immediately call the delivery carrier and request an inspection. Retain all Align the caster rail assembly with the right hand side of the un
Summary of the content on the page No. 6
Appliance Placement Features Leave a one (1) inch space on all sides and the back of the NSF and FDA Approved Adjustable Shelving cabinet for ease of installation, proper air circulation and electrical This appliance is provided with NSF and FDA approved heavy connections. DO NOT block the front grill on the lower front duty epoxy powder coated adjustable shelves. The one with the of your appliance. Sufficient air circulation is essential for the wires that are angled on the front and back goes
Summary of the content on the page No. 7
scratch the appliance surface when removing adhesive labels. Any glue left from the tape can be removed with a mixture of NSF Certified Temperature Gauge warm water and mild detergent or touch the residue with the This appliance is equipped with an NSF certified temperature sticky side of tape already removed. DO NOT REMOVE THE gauge to display cabinet internal temperature. The temperature SERIAL PLATE. gauge is located on the top right side of the evaporator housing inside the unit. Condensate
Summary of the content on the page No. 8
Before calling for service, review this list. It may save you time and expense. This list TROUBLESHOOTING includes common occurrences that are not the result of defective workmanship or GUIDE m aterials in this appliance. PROBLEM CAUSE CORRECTION APPLIANCE OPERATION Appliance does not run. * Appliance is plugged into a * Use another circuit. If you are unsure about the circuit that has a ground fault outlet, have it checked by a certified technician. * Temperature control is in the * See The
Summary of the content on the page No. 9
PROBLEM CAUSE CORRECTION SOUND AND NOISE (Cont.) Bubbling or gurgling soun Refrigerant (used to cool This is norm al. * * appliance) is circulating Vibrating or rattling noise. * Appliance is not level. It rocks on * Level the appliance by putting wood or metal the floor when it is moved shims under part of the appliance. * Floor is uneven or weak. * Ensure floor can adequately support appliance. Level the appliance by putting wood or metal shims under part of the appliance. * appliance is t
Summary of the content on the page No. 10
IMPORTANT SAFETY NOTICE The information provided herein is designed to assist qualified repair personnel only. Untrained persons should not attempt to make repairs due to the possibility of electrical shock. Disconnect the power cord before servicing. ELECTRICAL CIRCUIT STAINLESS STEEL DOOR STAINLESS STEEL DOOR GLASS DOOR REFRIGERATOR FREEZER REFRIGERATOR IMPORTANT IF ANY GREEN GROUNDING WIRES ARE REMOVED DURING SERVICING, THEY MUST BE RETURNED TO THEIR ORIGINAL POSITION AND PROPERLY SECU
Summary of the content on the page No. 11
Commercial Appliance Warranty Information Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions. Exclusions This warranty does not cover the following: 1. All labor costs on commercial laundry products. 2. P
