Summary of the content on the page No. 1
70008
Rev 70008-20071026
Owner’s Manual and Operating Instructions
4200 Peak Watts / 3500 Running Watts
4200 Peak Watts / 3500 Running Watts
Liquid Petroleum Gas Powered
Liquid Petroleum Gas Powered
PORTABLE GENERATOR
PORTABLE GENERATOR
Summary of the content on the page No. 2
Summary of the content on the page No. 3
Table of Contents Introduction ..................................... 1 Storage ........................................... 15 Portable Power Generator ........................ 1 Engine Storage ........................................ 15 Accessories ................................................ 1 Generator Storage ................................... 15 This Booklet .............................................. 1 Specifications ................................. 16 Manual Conventions .....
Summary of the content on the page No. 4
Summary of the content on the page No. 5
Introduction Accessories Introduction Champion Power Equipment manufactures Congratulations on your purchase of a and sells accessories designed to help you Champion Power Equipment generator. CPE get the most from your purchase. To find out designs and builds generators to strict more about our covers, power cables and specifications. With proper use and storm kits, please visit our web site at maintenance, this generator will bring years of satisfying service. www.championpo
Summary of the content on the page No. 6
Manual Conventions CAUTION Manual Conventions CAUTION indicates a potentially hazardous This manual uses the following symbols to situation which, if not avoided, may result in help differentiate between different kinds of minor or moderate injury. information. The safety symbol is used with a key word to alert you to potential hazards in operating and owning power equipment. Follow all safety messages to avoid or reduce CAUTION the risk of serious injury or death. CAUTION u
Summary of the content on the page No. 7
Safety Rules DANGER Safety Rules Generator produces powerful voltage. DO NOT touch bare wires or receptacles. WARNING DO NOT use electrical cords that are worn, damaged or frayed. Read this manual thoroughly before operating DO NOT operate generator in wet weather. your generator. Failure to follow instructions DO NOT allow children or unqualified persons to could result in serious injury or death. operate or service the generator Use a ground fault circuit interrupter (GFCI
Summary of the content on the page No. 8
Safety Rules DANGER CAUTION Propane (LPG) is highly flammable and explosive. Exceeding the generator’s running capacity can damage the generator and/or electrical devices connected to it Fire or explosion can cause severe burns or death if the gas is ignited. DO NOT overload the generator. Start the generator and allow the engine to Before starting the generator stabilize before connecting electrical loads. Turn the generator off. Connect electrical equipment in the off position,
Summary of the content on the page No. 9
Controls and Features Controls and Features Read this owner’s manual before operating your generator. Familiarize yourself with the location and function of the controls and features. Save this manual for future reference. Generator (1) Fuel Valve – Turn this valve to the (6) Serial Number – Please have this “On” position to supply fuel to the engine.. number available when calling for assistance. (2) Choke – Used to start the engine. (7) Low Oil Sensor – Senses the level of
Summary of the content on the page No. 10
Controls and Features Power Panel (1) Gas Inlet – Nipple for LPG hose (6) 120 V 30 A Twist-Lock – protected by connection. a 30 A push-to-reset circuit breaker, this receptacle powers 120 Volt AC, 60 Hz, single (2) Engine switch – Flip switch to the phase loads requiring up to 29.2 A or3500 “On” position to start the generator. Flip to Watts of power. the “Off” position to turn off the generator. (7) 120 V 20 A Duplex – each receptacle (3) Circuit Breakers – Protects the is
Summary of the content on the page No. 11
Controls and Features Parts Included Your Model 70008 Gasoline Powered Generator ships with the following parts: Wheel Kit Axle 1 piece 8” Solid Wheel 2 pieces Support Leg 1 piece Vibration Mounts 2 pieces Bolt Kit Wheel Retaining Pins 2 pieces Flat Washers 2 pieces Cap Screws and Nuts 4 sets Oil Funnel 1 piece Wrench 1 piece Spark Plug Socket 1 piece Spark Arrester Kit Spark Arrester 1 piece Cover Plate 1 piece Screws, Lock Washers 2 pieces Gas Hose and Regulator
Summary of the content on the page No. 12
Assembly Install the Support Leg 1. Attach the rubber vibration mount to Assembly the support leg with a cap screw Your generator requires some assembly. (M8x30) and lock nut (M8). This unit ships from our factory without oil. 2. Attach the support leg to the generator It must be properly serviced with fuel and oil frame with cap screws (M8x20) and lock before operation. nuts (M8). 3. Tip the generator slowly so that it rests If you have any questions regarding the on the wheels
Summary of the content on the page No. 13
Assembly 3. Add 1.16 qt (1.1 L) of oil and replace oil fill cap/dipstick. See “Specifications” for CAUTION oil recommendations based on operating conditions. Use approved LP cylinders equipped with an OPD 4. Check engine oil level daily and add as (overfilling prevention device) valve. needed. Always keep the cylinder in a vertical position CAUTION with the valve on top and installed at ground level on a flat surface Cylinders must not be installed near any heat The engine is
Summary of the content on the page No. 14
Operation 2. Obtain an Uninterruptible Power Supply (UPS) device. Operation Most UPS devices come with a rechargeable battery between the electronic equipment and power supply Generator Location source. The device buffers the voltage Please consult your local authority. In some and protects against virtually all short- areas, generators must be registered with duration voltage fluctuations. the local utility. Generators used at construction sites may be Starting the Engine subject
Summary of the content on the page No. 15
Operation 2. Let the generator run at no-load for several minutes to stabilize internal Power Management temperatures of the engine and Use the following formula to convert voltage generator. and amperage to watts: 3. Turn the engine switch to the “Off” position. Volts x Amps = Watts 4. Turn the fuel valve to the “Off” position. 5. Close the OPD valve on the LPG To prolong the life of your generator and cylinder. attached devices, follow these steps to add electrical load:
Summary of the content on the page No. 16
Operation Wattage Reference Chart Use the chart to determine approximate wattage requirements for your equipment. NOTE Starting watts can exceed three times the running watts. The values in the following table are approximate. Refer to your tool or appliance for actual wattage consumption. Running Starting Item Watts Watts Essentials Light Bulb 100W 100 Refrigerator/Freezer 1200 2400 Freezer 500 500 Sump Pump 600 1800 Well Pump 1 HP 2000 4000 Water Heater 4000 Se
Summary of the content on the page No. 17
Maintenance 6. Dispose of used oil at an approved waste management facility. Maintenance The owner/operator is responsible for all periodic maintenance. WARNING Never operate a damaged or defective generator. Spark Plugs 1. Remove the spark plug cable from the spark plug. WARNING 2. Use the spark plug tool that shipped with your generator to remove the plug. Tampering with the factory set governor will void 3. Inspect the electrode on the plug. It your warranty. mus
Summary of the content on the page No. 18
Maintenance Spark Arrester Every 8 hours or daily Check oil level 1. Allow the engine to cool completely Clean around air intake and muffler before servicing the spark arrester. First 5 Hours 2. Remove the two screws holding the Change oil cover plate which retains the end of the Every 50 hours or every season spark arrester to the muffler. 3. Remove the spark arrester screen. Clean air filter Change oil if operating under heavy load 4. Carefully remove the carbon depos
Summary of the content on the page No. 19
Storage 4. Remove the spark plug and pour about ½ ounce of oil into the cylinder. Crank Storage the engine slowly to distribute the oil and lubricate the cylinder. The generator should be started at least once 5. Reattach the spark plug. every 14 days and allowed to run for at least 20 minutes. For longer term storage, please follow these guidelines. Generator Storage 1. Allow the generator to cool completely before storage. Engine Storage 2. Turn off the fuel supply at the fue
Summary of the content on the page No. 20
Specifications Spark Plugs Specifications Your generator comes equipped with a ¾” long reach plug (19mm) Engine Specifications Engine 338 cc OHV CPE Use only “Green Power” brand replacement LPG spark plugs. CARB and EPA certified Generator Specifications CAUTION Running Wattage 3500 Watts Starting Wattage 4200 Watts Failure to use the proper plug may damage your AC Load 120 V engine and will void your warranty. Phase Single Frequency 60 Hz Fuel Capacity Liquefied Petro
