Harbor Freight Tools 93863 user manual

Summary of the content on the page No. 1

SOLAR LIGHT SET
4 PIECE
Model 93863
ASSEMBLY & OPERATING INSTRUCTIONS
Diagrams within this manual may not be drawn proportionally.
Due to continuing improvements, actual product may differ slightly from the product described herein.
®
Distributed exclusively by Harbor Freight Tools .
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
Read this material before using this product.
Failure to do so can result in serious injury.
SaVe THiS Manual.
© ®

Summary of the content on the page No. 2

THANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please complete the owner’s record below: Model______________ Serial No._____________ Purchase Date_______________ SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you read the entire manual to become familiar with the unit BEFORE you begin assembly. Technical Specifications The Solar Light Set includes 4 solar lights and parts for each one. Material: Polystyrene and Polypropolene. Power:

Summary of the content on the page No. 3

8. Dress properly. Protective, electrically nonconductive clothes and nonskid footwear are recommended when setting up the Solar Light Set. Wear restrictive hair covering to contain long hair. 9. Use eye protection. Always wear ANSI approved impact safety goggles when setting up this product. 10. Maintain products with care. Keep the Solar Light Set clean for better and safer performance. Inspect the Solar Light Set periodically. If damaged, have it repaired by an authorized technici

Summary of the content on the page No. 4

3. Each light is powered by a battery. Each Battery (6) has a pull tab that keeps the battery disconnected until you are ready to use the Solar Light Set. To access the battery, see steps 4, 5 and 6. Refer to the section, “Replacing the Battery” and see Figure 1. 4. Remove the Solar Assembly (3) by unscrewing it from the Cover (1) and gently pulling it off. Unscrew the three screws from the Solar Assembly (3)-see Figure 1. 5. Carefully separate the top portion of the Solar Assembl

Summary of the content on the page No. 5

Replacing the Battery It is recommended that you replace the battery in each Light every 12 months. 1. Remove the Cover (1). Unscrew the three screws from the Solar Assembly (3)-see Figure 1. 2. Carefully separate the top portion of the Solar Assembly from the bottom piece as seen in Figure 1. Be careful to not bump or pull on any wires while doing this. If any wires are pulled, they may disconnect and break the Solar Light. 3. Remove the old Battery (6). Make certain that the n

Summary of the content on the page No. 6

Parts List Part # Description Quantity Part # Description Quantity 1 Cover 4 5 Stake 4 2 LED Light 4 6 Battery 4 3 Solar Assembly 4 7 Transparent Cover 4 4 Tube 8 Note: Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts. PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES AN