American Standard Savona Elite 2901E SERIES user manual

Summary of the content on the page No. 1

2901E SERIES
SAVONA ELITE™
HIGH GLOSS ACRYLIC
WHIRLPOOL
SHOWN LESS ALL FITTINGS
INSTALLATION INSTRUCTIONS
1810mm
19mm
(71-1/4)
(3/4)
IN-LINE HEATER
905mm
TYP.
REMOVABLE
(35-5/8)
THANK YOU...
BLANK
for selecting an American Standard bath. Your new
552mm
PUMP
bath is shipped to you after careful inspection. The
1105mm
(21-3/4)
OUTLINE OF
(43-1/2)
whirlpool version is completely assembled with pump,
1772mm X
C/L
1067mm
motor, and system piping. All you need to finish the
(69-3/4 X 42)
insta

Summary of the content on the page No. 2

INSTALLATION AND FRAMING INSTRUCTIONS The variety of installations possible for this whirlpool may require framing procedures other than those shown. Locate studs as required. Ensure roughing-in dimensions are proper, plumb and square. Provisions must be made in all installations for an access opening for servicing the pump and controls. It is strongly recommended that an additional opening be provided for access to the drain components. 1. Position the whirlpool into the installation ope

Summary of the content on the page No. 3

ELECTRICAL INSTALLATION INSTRUCTIONS All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other applicable codes. WARNING: When using electrical products, basic precautions should always be observed, including the following: 1. DANGER: RISK OF ELECTRIC SHOCK Connect only to a circuit protected by a ground-fault circuit interrupter. 2. Grounding is required. The unit should be installed by a licensed electrician and grounded. 3. Install

Summary of the content on the page No. 4

WIRE SELECTION GUIDE Maximum distance from The sizes shown on this fusebox to motor chart are recommendations Motor 50' 100' 150' 200' for copper conductors Hi Performance only. Always follow Rating 120V Power Line local and national 2.1 electrical codes 12 10 8 8 DRAIN CONNECTION AND SYSTEM TEST Using recommended drain opening, connect whirlpool drain to waste line. Tighten all drain joints securely. Check the pump couplings and make sure they are hand-tight. Clean the whirlpool and fill