ATD Tools ATD-31167 user manual

Summary of the content on the page No. 1

ATD-31167
1/2" X 50' RETRACTABLE
AIR HOSE REEL
Instruction Manual

Specifications
• Spring driven, automatic rewind, with locking ratchet mechanism (eight locking positions per
revolution).
• Brass connectors on hose and reel.
• 50 Feet of ½” rubber Hose
• Incoming Air Connection: 1/2” NPT swivel
• Hose Connections: Male 1/2” NPT
• Maximum Pressure: 300PSI
• Maximum Air Flow: 35CFM

Read and understand entire manual before assembling or using hose reel. Failur

Summary of the content on the page No. 2

Installing Hose Reel Note: Due to the infinite ways one would mount this reel, the mounting hardware is not included and must be purchased separately. Decide first where reel will be mounted before purchasing hardware. Different mounting positions require different types of hardware. Reel can be mounted on the floor, ceiling, or wall. When choosing a location, remember that you can only mount reel to a load-bearing structural member capable of supporting combined weight of reel, hose, and

Summary of the content on the page No. 3

ADJUSTING THE GUIDE ARM • Pull out 3 feet of hose and allow reel to lock in position. • Remove the four bolts connecting guide arm to mounting base. • Rotate guide arm in 90° increments to desired position total number of positions is five (5). • Replace four bolts and tighten. Continue by choosing proper mounting hardware. See illustration for Dimensions. Use washers on mounting bolts to help bear weight of reel (Bolts and Washers are not included). After reel is secured in position

Summary of the content on the page No. 4

ADJUSTING THE HOSE BALL STOP The hose ball stop determines the length of hose that remains outside of reel. To adjust, pull hose out past desired position of hose ball stop and latch reel. Loosen both bolts and move ball stop to proper position. Tighten bolts. Operating Hose Reel 1. Slowly pull hose from reel to desired length. A ratcheting mechanism inside reel makes a short series of clicking sounds every half revolution of reel. 2. To lock reel in position, listen for clicking so

Summary of the content on the page No. 5

REPLACING HOSE 1. Secure and stabilize reel. In most cases, hose can be replaced with reel still mounted. 2. Disconnect incoming air supply. 3. Pull out entire length of hose and lock reel. Make sure reel is securely locked in place. 4. Unscrew hose clamps that secure hose to drum. Disconnect inlet-end of hose from air inlet valve. 5. Pull inlet-end of hose through slot in drum and guide rollers, removing old hose completely. 6. Remove spring hose guard, hose clamp and hose ball stop from

Summary of the content on the page No. 6