Cornelius KIT CM650 user manual

Summary of the content on the page No. 1

IMI CORNELIUS INC.
One Cornelius Place
Anoka. MN 55303-6234
Telephone (800) 238--3600
Facsimile (612) 422--3246
INSTALLATION INSTRUCTIONS
KIT, P/N 2306
For installing Scotsman Model CM450, 500, & 650 Series Ice Makers on Remcort Model DB200 Series Ice/
Drink dispenser.
1. Bin Level Control
A. Locate and drill three (3) 5/16”diameter holes (Ref. Fig. 1).
B. Install mounting clamps.
2. Seal ice maker to top of Dispenser as follows:
A. Run a bead of RTV on the dispenser cover around the outline of

Summary of the content on the page No. 2

ROUTE ICEMAKER BIN LEVEL THERMOSTAT CAPILLARY TUBE AS SHOWN. INSTALL ON HOPPER AS SHOWN IN FIG. 1 24 30 ICEMAKER TO BE FLUSH WITH BACK EDGE OF COVER. APPLY RTV AROUND INSIDE OF ICEMAKER OUTLINE ON DISPENSER COVER TO FORM A SEAL. ADD ADHESIVE BACKED GAS- KET STRIPS TO REMOVABLE LID. REMOVE SCREWS AND TURN BRACKETS AROUND 180_ . REPLACE SCREWS. USING BRACKET AS TEMPLATE, DRILL (4) .136 DIA. HOLES 2 28 80 08 80 0 INTO ICEMAKER CABINET 2 28 80 08 80 0 FOR SHEET METAL SCREWS PROVIDED. DRILLING IS NOT

Summary of the content on the page No. 3

ICEMAKER TOP- VIEW FRONT WALL OF HOPPER THERMOSTAT CAPILLARY TUBE LOCATE AND ADD CLAMP HOLE IF NEEDED TO RETAIN CAPILLARY TUBING 4--5/8 15” 1” DRILL 5/16 DIA. HOLES FOR 8--32 WELD NUT INSERT 8-32 WELL NUTS INTO 5/16 DIA. HOLES, TIGHTENING SCREWS WILL SECURE 1--5/8 CAPILLARY TUB- ING 6 PLASTIC TUBING USE AS REQUIRED LARGE CLAMP (IF NEEDED) BIN LEVEL THERMOSTAT CAPILLARY TUBING ASSEMBLY 91933 3 12/9/96