Summary of the content on the page No. 1
Clock Radio
AJ3122
Register your product and get support at
www.philips.com/welcome
User manual
Summary of the content on the page No. 2
1 3 6 4 1 5 2 7 ! @ 8 0 9 #
Summary of the content on the page No. 3
English Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. CONTROLS (see fig. 1 ) 1 SET TIME /ALARM SET – sets the clock time – sets the alarm time 2 HR / MIN – adjusts the hours / minutes for clock / alarm time 3 REPEAT ALARM / SLEEP OFF – switches off the active alarm for a 9 minutes period – switches off the radio sleep function 4 ALARM RESET – stops the active alarm for 24
Summary of the content on the page No. 4
INSTALLATION POWER SUPPLY 1 Check if the power supply, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the power cord to the wall outlet. 3 To disconnect the set from the power supply completely, remove the plug from the wall outlet. For users in the U.K.: please follow the instructions on the lower left handed corner of the sheet. CLOCK MEMORY BACKUP The clock memory backu
Summary of the content on the page No. 5
RADIO You can use this set solely as a radio! 1 Adjust RADIO / ALARM to RADIO ON to switch on the radio. 2 Select your waveband by adjusting the FM/MW switch. 3 Adjust TUNING to tune to your desired station. 4 Turn the VOLUME control to adjust the volume level. 5 Adjust RADIO / ALARM to OFF to switch off the radio. To improve reception: FM: Extend and position the pigtail fully to obtain optimal recep- tion. MW: uses a built-in antenna inside the set. Direct the antenna by adjusting the posit
Summary of the content on the page No. 6
SELECTING THE ALARM MODE To use the alarm, you must set the alarm time first. You can choose from two different alarm modes to wake you up: by radio or buzzer. 1 Select your choice of alarm mode by adjusting RADIO / ALARM to RADIO or BUZZER. ™ The alarm indicator (AL) will light up. Helpful Hint: • If you have selected the radio mode, make sure you have adjusted the volume loud enough to wake you. • The buzzer is set at a fixed volume and cannot be adjusted. SWITCHING OFF THE ALARM The
Summary of the content on the page No. 7
REPEAT ALARM This repeats your alarm call at 9-minute intervals. 1 During the alarm call, press REPEAT ALARM. 2 Repeat if desired for up to 59 minutes. The alarm indicator (AL) will remain on. ™ SLEEP This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. This allows you to lie back, listen and fall asleep. Setting and switching off SLEEP 1 In clock (OFF) mode, press SLEEP repeatedly until the desired timer opti
Summary of the content on the page No. 8
SAFETY INFORMATION • Install the unit near the AC outlet and where the AC power cord plug can be easily reached. • Where the MAINS plug or an appliance coupler is used as the discon- nect device, the disconnet device shall remain readily operable. • Place the set on a hard and flat surface so that the system does not tilt. • If you do not intend to use the set for a long time, withdraw the power plug from the wall outlet. In addition to this, it is advisable to remove the battery from the
Summary of the content on the page No. 9
TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. Do not open the set as there is a risk of electric shock. Problem – Possible Cause • Remedy No sound/power – Volume not adjusted • Adjust the v olume Occasional cracklin
Summary of the content on the page No. 10
ENVIRONMENTAL INFORMATION We have reduced packaging to the minimum for easy separation into two materials: paper and cardboard. Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe local regulations on the disposal of packing materials and old equipment. Disposal of your old product Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled b
Summary of the content on the page No. 11
Meet Philips at the Internet http://www.philips.com W AJ3122 CLASS 1 LASER PRODUCT Printed in China AJ3122_61_UM_V1.0
