Summary of the content on the page No. 1
Register your product and get support at
MCD122
www.philips.com/welcome
EN User manual 3
29
Summary of the content on the page No. 2
Contents 7 Tune to FM radio stations 21 1 Important 4 Program radio stations automatically 21 Safety 4 Program radio stations manually 21 Notice 6 Tune to a preset radio station 21 2 Your DVD Micro Theater 7 8 Adjust volume level and sound effect Introduction 7 What’s in the box 7 22 Overview of the main unit 8 Adjust volume level 22 Overview of the remote control 9 Select a sound effect 22 Mute sound 22 Listen through headphone 22 3 Connect 10 Place the unit
Summary of the content on the page No. 3
g Do not block any ventilation openings. 1 Important Install in accordance with the manufacturer’s instructions. h Do not install near any heat sources such Safety as radiators, heat registers, stoves, or
Know these safety symbols produce heat. i Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. j Only use attachments/accessories
Summary of the content on the page No. 4
Do not mix batteries (old and new or Hearing safety carbon and alkaline, etc.). Remove batteries when the unit is not Listen at a moderate volume. used for a long time. Using headphones at a high volume can impair your hearing. This product can o Apparatus shall not be exposed to produce sounds in decibel ranges that may dripping or splashing. cause hearing loss for a normal person, p Do not place any sources of danger on even for exposure less than a minute. The
Summary of the content on the page No. 5
This apparatus includes this label: Notice ! / $ $ ! device that are not expressly approved by Philips Consumer Lifestyle may void the user’s ! !($ ; Environmental information All unnecessary packaging has been omitted. Note We have tried to make the packaging easy to separate into three materials: cardboard (box), The type plate is located on the bottom of the apparatus. polystyrene foam (buffer) and polyethylene (bags, prot
Summary of the content on the page No. 6
You can play DVD discs with the following 2 Your DVD region codes: DVD region code Countries Micro Theater
) ' )J Congratulations on your purchase, and ' $
! \ #% # $ ! Australia, New Zealand support that Philips offers, register your product at www.Philips.com/welcome. Introduction What’s in the box With this unit, you can: Check and identify the contents of your watch video from DVD/VCD/SVCD or package: USB devices Main unit e
Summary of the content on the page No. 7
Overview of the main unit a b c d e f ghijk o n m l a h DBB Turn on the apparatus; switch to Turn on or off dynamic bass standby mode. enhancement. i b VOLUME / Start or pause play. Adjust volume. Adjust time. j Stop play. c SOURCE In demo mode, activate or deactivate Select a source. demonstration. d Display panel k MODE Display current status. Select repeat play modes. e !#?$ ; Open or close the disc compartment. l MP3-LINK f Remote
Summary of the content on the page No. 8
b Source selection keys Overview of the remote Select a source. control c DISPLAY/RDS (RDS function unavailable
Display play information on a connected TV. a d DISC MENU For video discs: access or exit the disc b menu. For video discs with playback x c control(PBC): turn on/off PBC. w d e AUDIO For VCD, select stereo, mono-left or v e mono-right channel. For DVD/DivX video, select an audio u language. f f / Search within a track. g Tune to a radio
Summary of the content on the page No. 9
l SLEEP/TIMER 3 Connect Set the sleep timer. Set the alarm timer. m SUBTITLE Place the unit Select a subtitle language. n GOTO During disc play, specify a position to start play. o ANGLE/PROG Select a DVD camera angle. Program radio stations. p Numeric keypad Select a title/chapter/track directly. q Stop play. r / 1 Place the unit near to the TV. Skip to the previous/next track. Skip to the previous/next title or 2
!# /! " ( ch
Summary of the content on the page No. 10
1 q ' ! " ?; Connect TV 2 Insert the stripped part of the wire completely. Connect video cables Insert the right speaker wires to “R”, left speaker wires to “L”. With this connection, you can watch video from Insert the red wires to “+”, black wires the unit on the TV screen. to “-”. You can select the best video connection that your TV suppor ts. 3 ! " ?; Option 1: Connect through SCART (for a standard TV). Option 2: connect through component
Summary of the content on the page No. 11
Note Option 3: Connect through composite video ! / @ @ ( @% when a progressive scan TV is connected. 8 If your TV does not support progressive scan, you cannot view the picture. For how to activate progressive scan on your TV, refer to the TV user manual. Connect a progressive scan TV through TV $ @ # !/!( @ ; 1 Connect component video cables (red/ blue/green - not supplied) to: the VIDEO OUT (Pr/Cr Pb/Cb Y) socket
Summary of the content on the page No. 12
4 Get started Connect power 8 Caution Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in ( ; If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Caution Model No. ____________________________ Risk
Summary of the content on the page No. 13
3 Turn on the TV and switch to the correct Set clock video-in channel in one of the following ways: 1 In the standby mode, press and hold Go to the lowest channel on your TV, CLOCK to activate the clock setting then press the Channel Down button mode. until you see the blue screen. » The hour digits are displayed and begin Press the source button repeatedly on to blink. the remote control of your TV. 2 Press + VOL - to set the hour, then press CLOCK again. Tip » The minute digits
Summary of the content on the page No. 14
5 Play Turn on Progressive Scan Progressive scan displays twice the number of frames per seconds than interlaced scanning Note (ordinary TV system). With nearly double the number of lines, progressive scan offers higher ! $ )$ ##; ( ; Before you turn on this feature, ensure that: The TV supports progressive scan signals. You have connected this unit with the TV Play a disc through component video. 1 Turn on the TV. Caution 2
Summary of the content on the page No. 15
To access or exit the menu manually: Play from USB 1 Press DISC MENU. !$%&'
)*% )*%
;<# Note With the PBC feature, you can play VCD Ensure that the USB device contains playable music, interactively according to the menu screen. pictures or video. 1 During play, press DISC MENU to enable/ disable PBC. 1 Insert the USB device. » When PBC is enabled, the menu screen is displayed. » When PBC is disabled, normal play is resumed. Select an audio lan
Summary of the content on the page No. 16
3 . Play control To stop play, press . To pause or resume play, press . = > ?
To change a subtitle language, press SUBTITLE. 1 During play, press MODE/DIM repeatedly ! !#? mode. Note To resume normal play, press MODE/ You can only play DivX videos rented or purchased DIM repeatedly until no option is through the DivX registration code of this unit. displayed. % '
Summary of the content on the page No. 17
Play starts automatically at your Change the audio channel selected point. Note Resume video play from last stopped This feature is only available for VCD/DivX play. point Note 1 During play, press AUDIO repeatedly to select an audio channel available on the This feature is only available for DVD/VCD play. disc: Mono Left Mono Right 1 In stop mode and when the disc has not Stereo been removed, press . To cancel resume mode and stop play Select a camera angle completely: 1
Summary of the content on the page No. 18
[All] – If the connected device supports 6 Adjust settings multi-channel audio formats, select this option. [Night Mode] 1 Press SYSTEM MENU. Make loud sound level softer and soft sound 2 Select a setup page. level louder so that you can watch the DVD 3 Select an option and then press . movies at a low volume, without disturbing others. 4 Select a setting and then press OK. [On] & ( @' / /! To return to the previous menu, press only). . [Off] – enjoy s
Summary of the content on the page No. 19
[Picture Setting] [Parental Control] Customize picture color settings. Restricts access to discs that are unsuitable for children. These types of discs must be recorded [Component Video] with ratings. Set the video output according to the video connection. If the composite connection is used, Press OK. ! / ( ; Select a rating level, then press OK. [S-VIDEO] – If the S-Video connection is Press the numeric keys to enter the password. used, select this option. [In
Summary of the content on the page No. 20
7 Tune to FM Program radio stations manually radio stations Note 1 Ensure that you have connected and fully You can program a maximum of 20 preset radio extended the supplied FM antenna. stations. 2 Press TUNER. 3 Press and hold / . 1 Tune to a radio station. 4 ! !#( 2 Press ANGLE/PROG to activate change, release the button. programming. » The FM tuner tunes to a station with 3 Press / to allocate a number from strong reception automatically. 1 to 20
