Summary of the content on the page No. 1
HOMEOWNER'S CARE AND
OPERATION INSTRUCTIONS
B-VENT MULTI-OPEN
®
ELITE SERIES
WARNINGS
B-VENTED GAS APPLIANCES
• Hot! Do not touch! The glass and P/N 875,026M REV. B 01/2007
surfaces of this appliance will be hot
MODELS
during operation and will retain heat
for a while after shutting off the appli-
ance. Severe burns may result.
Ms illivolt Models Electronic Model
• Carefully supervise children in the
EM BVSTNMEE BVSTPEE BVSTN EBVCRN
same room as appliance.
EM BVPFNMEE BVPFPEE BVPFN EBVCLN
•
Summary of the content on the page No. 2
GENERAL INFORMATION CONGRATULATIONS! Note: Installation and repair should be per- In selecting this LENNOX B-Vented Gas Appliance you have chosen the finest and formed by a qualified service person. The appli- most dependable fireplace to be found anywhere. It is a beautiful, prestigious ance should be inspected annually by a quali- alternative to a wood burning fireplace. Welcome to a Family of tens of thousands fied professional service technician. More fre- of satisfied LENNOX Fireplace Own
Summary of the content on the page No. 3
The following table shows the units' gas ori- The appliance and its individual shut-off valve must WARNING: CHILDREN AND ADULTS be disconnected from the gas supply piping system fice size for the elevations indicated: SHOULD BE ALERTED TO THE HAZARDS during any pressure testing of that system at pres- sures in excess of ¹⁄₂ psig (3.5 kPa). OF HIGH SURFACE TEMPERATURES. USE Orifice size Model Elevation CAUTION AROUND THE APPLIANCE TO No. Feet (meters) These appliances must not be connected to a A
Summary of the content on the page No. 4
O I O L I P T O IGNITER OFF ON CONTROL it TPTH TP TH L I P F LO F To ease door closure, depress the catch to place Gas Controls/Control Compartment Access Manifold Pressure Port ON/OFF Switch it in its retracted position, then close the door. The gas controls can be found behind the Operation of millivolt and electronic gas con- control compartment access panel. Inlet trol systems are different. Before lighting and Pressure operating your appliance determine if you have Port To open the control
Summary of the content on the page No. 5
CAUTION: DO NOT TOUCH THE FRONT EN- Variable Flame Height Adjustment WARNING: DO NOT OPERATE THE SHUT- CLOSURE GLASS WITH YOUR HANDS WHILE ( Millivolt Appliances only) OFF LEVER UNLESS A COMPLETE OUTSIDE THE FIREPLACE IS IN USE. COMBUSTION AIR SYSTEM HAS BEEN IN- 1. All Millivolt appliances are equipped with a STALLED WITH YOUR APPLIANCE. variable gas control valve. Flame height for Outside Combustion Air Controls these models may be adjusted through a range between fixed low and high settings
Summary of the content on the page No. 6
Manual-Reset Safety Limit Switch B - To access the blocked flue safety switch Maintenance This appliance is equipped with a manual- when top radiant panel is covered with non- The appliance and venting system should be reset blocked flue safety limit switch. Refer to combustible material: thoroughly inspected before initial use and at Figure 5 for its location. If, during appliance least annually by a qualified service techni- operation, the flame goes out (independently Note: This procedure sho
Summary of the content on the page No. 7
Maintenance Schedule Annually (Before the onset of the Burning Season) Maintenance Task Accomplishing Person Procedure Inspecting/Cleaning Burner, Logs Qualified Service Technician Inspect valve and ensure it is properly operat- and Controls ing. Check piping for leaks. Vacuum the con- trol compartment, fireplace logs and burner area. Check Flame Patterns and Flame Height Qualified Service Technician Refer to Figure 9 on page 9 and verify that the flame pattern and height displayed by the appli
Summary of the content on the page No. 8
Burner Adjustments Lower Compartment Door and Hinge WARNING: DO NOT ATTEMPT TO SUB- Top Flange Modesty Panel STITUTE THE MATERIALS USED ON (Glass Enclosure Note - The air shutter for the burner primary air Panel Frame) THESE DOORS, OR REPLACE CRACKED opening is factory-set. Do not adjust the fac- Front Glass tory-set position. The factory-set position is OR BROKEN GLASS WITH ANY MATERI- Enclosure Panel shown in Figure 7. ALS OTHER THAN THOSE PROVIDED BY THE APPLIANCE MANUFACTURER. *Air Shutter T
Summary of the content on the page No. 9
Log Placement WARNING: LOG SET GETS VERY HOT AND WILL REMAIN HOT UP TO ONE HOUR AFTER GAS SUPPLY IS TURNED OFF. HANDLE ONLY WHEN LOG SET IS COOL. TURN OFF ALL GAS TO THE APPLIANCE BEFORE INSTALLING THE GRATE AND LOG SET. WARNING: THIS APPLIANCE IS NOT DE- SIGNED TO BURN WOOD. ANY ATTEMPT TO DO SO COULD CAUSE IRREPARABLE DAMAGE TO YOUR APPLIANCE AND PROVE HAZARDOUS TO YOUR SAFETY. Glowing Embers Vermiculate And Volcanic (Rockwool) Stone On Firebox Bottom WARNING: THE SIZE AND POSITION OF Figu
Summary of the content on the page No. 10
TH TH TP TP Hood Ignitor Rod WARRANTY MILLIVOLT Millivolt Wiring Diagram If any of the original wire as supplied must be replaced, it must be replaced with Type AWM 105°C – 18 GA. wire. Your gas appliance is covered by a limited Thermocouple twenty year warranty. You will find a copy of White the warranty accompanying this manual. Please read the warranty to be familiar with its ³⁄₈" Min coverage. (9 mm) Thermopile Pilot Retain this manual. File it with your other docu- Nozzels ments for future
Summary of the content on the page No. 11
ACCESSORY COMPONENTS Door Frame Kits A decorative door frame kit is available for use with these appliances. The DTK is de- signed to attach directly to the front face of the appliance at its extreme edges. The DTK provides a picture frame finish for the appli- ance. The door frame kit can be retrofitted Remote Control System (Standard) H0249 RCL onto previously installed appliances. Standard Remote Control System (Model RCL) The Model RCL (Standard) Remote Control Door Frame Kits System, featu
Summary of the content on the page No. 12
ACCESSORY COMPONENTS CONTINUED Charcoal Finish Louver Assembly Kits (3-piece Top and 3-piece Bottom Assembly) CATALOG NO. / MODEL NO. AND NUMBER OF SETS Charcoal Finish Unit Model for 24 in. wide for 40 in. wide Glass Door Glass Door No. 88L23 88L25 LVR24C-2 LVR40C-2 E- BVST 2 Remote Control System (Deluxe) H0251 RCL-T E1 BVPF 2 EBVCR Deluxe Remote Control System 11 EBVCL (Model RCL-T) The Model RCL-T (Deluxe) Remote Control System has all of the features of the standard Charcoal Finish Louvers
Summary of the content on the page No. 13
ACCESSORY COMPONENTS CONTINUED 2-Piece Polished Brass and Brushed Stainless Louvers Kits Decorative louvers are available for use with all Multi-Open Series appliances. These louvers are designed to replace either the middle char- coal louver of each set or the charcoal louver in each set closest to the glass door. These kits include two narrow louvers. They provide a touch of elegance to any Multi-Open Series Screen Panel Kit 24 inch Wide Glass Door 98K74 HG24 appliance. These kits can be ret
Summary of the content on the page No. 14
ACCESSORY COMPONENTS CONTINUED Style View Doors Continued - Style View Doors also come in a Tall Arch Pane Design. Two distinctive grille kits, the “Crescents” and “Sunrise” design, are also offered seperately. They are easy to install and will not require hardware to attach them to the standard glass door frame. The door includes heavy duty magnet door latches and functional twin-pane doors. TALL ARCH PANE DOORS Cat. No. Model Description Model Series Tall Arch Pane Door H3529 TAPD40C 40” Arch
Summary of the content on the page No. 15
NOTES: NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 15
Summary of the content on the page No. 16
I O O L I P T O it TPTH TP TH L I P F L F O LIGHTING INSTRUCTIONS – MILLIVOLT GAS VALVE FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This appliance has a pilot which must be lighted with a piezo • Do not use any phone in your building. ignitor. When lighting the pilot, follow these instructions • Immediately call your gas supplier from a neighbor’s phone.
Summary of the content on the page No. 17
I O O L I P T O it TPTH TP TH L I P F L F O INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT : SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A. Cet appareil est muni d’une veilleuse qui doit être allumée avec un • Appelez immédiatement votre compagnie de gaz en utilisant le téléphone
Summary of the content on the page No. 18
IGNITER OFF ON CONTROL LIGHTING INSTRUCTIONS — ELECTRONIC FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. When lighting the appliance, follow these instructions • Immediately call your gas supplier from a neighbor’s exactly. phone. • If your gas supplier cannot be reached, call the fire B. BEFORE OPERATING smell all around the appliance area department. for g
Summary of the content on the page No. 19
IGNITER OFF ON CONTROL INSTRUCTIONS D’ALLUMAGE — ELECTRONIC POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT: SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A. Lorsque vous allumez l’appareil, suivez exactement ces instruc- • Appelez immédiatement votre compagnie de gaz en utilisant tions. le téléphone du voisin. • S’il vous est
Summary of the content on the page No. 20
TROUBLESHOOTING THE MILLIVOLT GAS CONTROL SYSTEM Note: Before troubleshooting, make sure that the appliance main line gas shut-off valve and the gas control valve are in the "OPEN" position and the burner ON/OFF switch is in the “ON” position. Important: Valve system troubleshooting should only be accomplished by a qualified service technician. SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION A. Defective ignitor 1. Spark ignitor will not light Check for spark at electrode and pilot; if no spark and (
