Summary of the content on the page No. 13
NOTE: The brake system requires a break-in period. You may have to repeat procedure 6F often during the first several hours of use. Repeat as necessary from thereafter to maintain proper brake function. 6B. Brake lever reach adjustment. The Electric Punk is supplied with a brake lever that adjusts to accommodate a variety of hand sizes. To adjust the brake lever so it is easier for smaller hands to operate the brake, turn the screw in the direction marked “B” in the photo below. Leave enough gap
Summary of the content on the page No. 14
Figure 10a. Figure 10b. If the belt requires tensioning, loosen the two screws and the locknut (A in Figure 10b) and turn the adjusting screw (B in Figure 10b) in 1/8 to 1/4 turn increments until the desired tension is attained. Be careful not to over tighten the belt! Once the belt tension is correct, retighten the screws and locknut to secure the adjusting mechanism. 6D. Changing a tire. Changing a tire or repairing a flat requires removal of the wheel from the frame (rear) or fork (front).
Summary of the content on the page No. 15
to separate the two halves and to remove and repair or replace the tube and/or tire. 6) To reassemble, reverse the order of disassembly. Figure 11c. Figure 11d. Figure 11c. Figure 11d. Figure 11e. Figure 11f 15
Summary of the content on the page No. 16
6E. Rear Suspension. The rear suspension allows for adjustment of the spring preload. For heavier riders, tighten the adjusting ring clockwise. For lighter riders, loosen the adjusting ring counter-clockwise (see Figure 12). Figure 12 7. Safety Helmets. Although not every state or municipality requires juvenile-age cyclists to wear a helmet, Razor strongly recommends you wear a properly approved helmet, such as ANSI or SNELL, even if the law does not mandate the use of a helmet. Suitable helme
Summary of the content on the page No. 17
required and are not standard equipment on the Electric Punk. We do not recommend riding at night or in low-light conditions. Wet weather riding. Do not ride in wet weather. WARNING: Keep your fingers and other body parts away from the drive belt, steering system, wheels and all other moving components. WARNING TO PARENTS: Kids need to be taught and be frequently reinforced of the importance of safe riding, the rules of the road and the dangers and hazards of traffic, especially motor vehicle
Summary of the content on the page No. 18
Turning without warning. Children are often struck from behind because they made unexpected turns into traffic, or they inadvertently veered into traffic when looking over their shoulder. Observe the following safety tips for left turns: Do not cut across the street, cross only at intersections. Practice looking over your shoulder to the rear without accidentally turning (do this only in an open space free from traffic and obstructions). Riding at night and in low visibility. Do not ride at nigh
Summary of the content on the page No. 19
8. Razor Limited Warranty and Registration The manufacturer warranties this product to be free of manufacturing defects for a period of 90 days from date of purchase. This Limited Warranty does not cover normal wear and tear, tires, tubes or cables, nor any damage, failure or loss caused by improper assembly, maintenance, storage or use of the Electric Punk. This Limited Warranty will be void if the product is ever: • used in a manner other than for recreation or transportation; • modified in a
Summary of the content on the page No. 20
QUESTIONS? Please read the owner’s manual thoroughly. If you still have questions, check our website for updates and contact information. Spare tires, tubes and batteries are available! Keep your Electric Punk running for years with these and other genuine Razor parts. Visit our website and e-mail us for more information on spare part availability. Specifications subject to change without notice. Patent Pending EP Rev. 1.4/18/03 ©Copyright 2003, Razor USA. Cerritos, CA All rights reserved.
Summary of the content on the page No. 1
TM TM
TM
Owner ’ s Manual
Summary of the content on the page No. 2
Razor Owner’s Manual + Safety Handbook Table of Contents 1. Parts of the Electric Punk . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 2. Proper Fit and Size Adjustments . . . . . . . . . . . . . . . . . . . . . . .4 3. Brake . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 4. Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 4A. Un-box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 3
were selected on the basis of their compatibility with the frame, fork and all other parts. Certain after-market products may or may not be compatible with your Electric Punk. Consult your retailer or call Razor prior to modifying or replacing any component with a non-factory specified product. TOOLS REQUIRED FOR ASSEMBLY/ADJUSTMENT ONLY * 4, 5 and 6mm hex (Allen) keys Razor recommends assembly by an adult with experience in bicycle mechanics. Some tools * Bicycle-style tire pump for Schrader m
Summary of the content on the page No. 4
2. Proper Fit and Size Adjustments Fit. When properly adjusted, the rider should be able to sit comfortably and steer with both feet remaining on the foot rests at all times. If the rider has to stretch to reach the foot rests or is too cramped, the seat should be adjusted accordingly. WARNING: The age recommendation is only an estimate. If you are too small or too large to comfortably reach the pedals or handlebars, do not ride the Electric Punk. WARNING: Failing to properly adjust and tighte
Summary of the content on the page No. 5
adjusted and maintained on a regular basis. Check or have them checked and adjusted by a qualified mechanic. Worn brake parts, stretched or frayed inner wires or a kinked housing indicate brake service or parts replacement may be necessary for proper function. 4. Assembly WARNING: Razor highly recommends that you have your Electric Punk assembled by an experienced, adult mechanic. Many retailers provide assembly but some charge extra. If your retailer can’t do the assembly, you can have your Ele
Summary of the content on the page No. 6
NOTE:: The brake cable and trigger switch wire are attached to the controls on the handlebars. Be careful not to deliberately or inadvertently kink or bend these wires during assembly. 4B. Install the handlebars and stem. Insert the handlebars into the stem as shown in Figure 3a. Insert the stem into the fork as shown in Figure 3b. Note the “minimum insertion” line (“A” in Figure 3b). The stem must be inserted into the fork until this line is no longer visible (Figure 3c). Align the stem squar
Summary of the content on the page No. 7
4C. Install the seatpost Insert the seatpost and seat assembly into the frame as shown in Figure 4a. Note the “minimum insertion” line (arrow in Figure 4a). The post must be inserted until this line is no longer visible. Align the seat square to the frame and flip the quick-release (QR) lever “closed” as shown in Figures 4b and 4c. With the QR lever closed, you should not be able to twist the seatpost in the frame, even with firm pressure. The tension on the clamp can be adjusted by tightening,
Summary of the content on the page No. 8
4D. Adjust and tighten the handlebars With the seat installed and tightened, sit on the Electric Punk and, with the stem QR open, adjust the handlebar square to the front wheel (remember, the stem must also be square to the front wheel). When the handlebar position is satisfactory, push the QR lever (Figure 5a) until it is closed (Figure 5b). This will lock the handlebars in position. With the QR lever closed, you should not be able to twist the handlebars in the stem, even with firm pressure. I
Summary of the content on the page No. 9
NOTE: Although we make every effort to keep our manual up-to- date, if your Electric Punk does not look exactly this, then we’ve made improvements since this document was printed. Check out the Razor website: www.razor.com for technical updates on the latest service and adjustment procedures. 4E. Inflating the tires The tires on the Electric Punk are inflated when shipped, but they invariably will lose some pressure between the point of manufacturing and your purchase. Both tires require 36 ps
Summary of the content on the page No. 10
4F. Adjusting the seat. If you desire to change the seat tilt (Figure 7), or adjust the fore and aft position of the seat on the seat rails, this can be accomplished by loosening one side of the “seat guts” using a 15mm box wrench. Adjust the tilt as desired and retighten securely. Figure 7. 4G. Charging prior to use. The Electric Punk will probably not have a fully charged battery at the time of purchase. Therefore it is a good idea to charge the battery prior to use. The charging input is lo
Summary of the content on the page No. 11
off the ground two or three inches and let go so it can bounce on the ground. Does everything sound tight? There should not be any unusual rattles or sounds from loose parts or broken components. If you are not sure, ask an experienced mechanic to check. 5B. Brake. Check the brake for proper function. When you pull the lever the brake should act against the rim and provide positive braking action. The cable should have the proper slack so the brakes do not drag, yet the lever should not touch t
Summary of the content on the page No. 12
6. Maintenance and Repairs 6A. Brake cable adjustment. The main adjustment on the brake is to take up the cable slack and bring the lever into adjustment. This is typically accomplished with the adjusting barrel at the brake lever as shown in Figure 9a. Figure 9a. If there is too much slack, the lever will go all the way to the handlebar without the brake being applied (Figure 9b). If there is not enough slack, the brake will drag even when the lever is not pulled. Ideally, you want 2-3mm of p
