Grindmaster LIQUID COFFEE DISPENSER LCD-2A user manual

User manual for the device Grindmaster LIQUID COFFEE DISPENSER LCD-2A

Device: Grindmaster LIQUID COFFEE DISPENSER LCD-2A
Category: Coffeemaker
Manufacturer: Grindmaster
Size: 0.64 MB
Added : 8/21/2014
Number of pages: 20
Print the manual

Download

How to use this site?

Our goal is to provide you with a quick access to the content of the user manual for Grindmaster LIQUID COFFEE DISPENSER LCD-2A. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with Grindmaster LIQUID COFFEE DISPENSER LCD-2A.

For your convenience

If looking through the Grindmaster LIQUID COFFEE DISPENSER LCD-2A user manual directly on this website is not convenient for you, there are two possible solutions:

  • Full Screen Viewing - to easily view the user manual (without downloading it to your computer), you can use full-screen viewing mode. To start viewing the user manual Grindmaster LIQUID COFFEE DISPENSER LCD-2A on full screen, use the button Fullscreen.
  • Downloading to your computer - You can also download the user manual Grindmaster LIQUID COFFEE DISPENSER LCD-2A to your computer and keep it in your files. However, if you do not want to take up too much of your disk space, you can always download it in the future from ManualsBase.
Grindmaster LIQUID COFFEE DISPENSER LCD-2A User manual - Online PDF
Advertisement
« Page 1 of 20 »
Advertisement
Print version

Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual Grindmaster LIQUID COFFEE DISPENSER LCD-2A but the selected pages only. paper.

Summaries

Below you will find previews of the content of the user manuals presented on the following pages to Grindmaster LIQUID COFFEE DISPENSER LCD-2A. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.

Abstracts of contents
Summary of the content on the page No. 1


GRINDMASTER CORPORATION
Liquid Coffee Dispenser
Operation and Instruction Manual
for
LCD-2A (Ambient Cabinet)
& LCD-2R (Refrigerated Cabinet)
TABLE OF CONTENTS
Introduction . . . . . . . . . . . . . . . . . . . . . . . . .2
User Replaceable Parts . . . . . . . . . . . . . . .3
Warning Labels . . . . . . . . . . . . . . . . . . . . . .4
Installation . . . . . . . . . . . . . . . . . . . . . . . . .5
How to Dispense a Cup of Coffee . . . . . . . . . .7
User Programming Instructions . . . . . .

Summary of the content on the page No. 2

Introduction The Grindmaster-Cecilware Liquid Coffee Dispensers (LCD-2A) and the Liquid Coffee Chilled Dispenser (LCD-2R) deliver two types of coffee made from liquid concentrate plus hot water. • The dispenser can be set up for continuous draw (by the cup) for self-serve applications, or portion-control to fill carafes and decanters for wait staff. The standard machine allows for (2) portion sizes per dispense head with the use of a hidden override switch located on the bottom left side of t

Summary of the content on the page No. 3

User Replaceable Parts  5 . ( %& /01  $+ %%&+2 34, ! "!  ( "     )*&+ ! "!          !,"!   &(  $2&(  ", ,  83$((6'" ( %7( +-(   !!!"!!#  $% &' ( ! 83$((-,5,!-  " 6  %7(      Page 3 Model LCD-2R and LCD-2A

Summary of the content on the page No. 4

Warning Labels The following warning labels were on your dispenser when it was shipped from the factory. They should remain on your dispenser in good, readable condition at all times. If one of your labels is missing or damaged, order a replace- ment label immediately. Part #62981, Located on lower splash panel on front of dispenser Part #61321, Located behind the drip pan on the front of the dispenser Part #61319, Located on the outside on the back of the dispenser and on the outside on the

Summary of the content on the page No. 5

Installation Water Inlet Connection: The National Sanitation Foundation requires the following for an NSF approved water hook-up: 1. A quick disconnect water connection or enough coiled tubing so that the machine can be moved for cleaning underneath. 2. An approved backflow prevention device, such as a double check valve to be installed between the machine and water supply. A 3/8" male flare adapter is provided on the back of the machine for hook-up to water supply. On uni

Summary of the content on the page No. 6

    Installation (cont.) Electrical Hook-up: Ensure water connection is made to machine before proceeding and water source is turned ON. NOTE: Installation must be performed by a qualified electrician and must conform to all local and national codes. NOTE: Machine is factory configured for field wiring and power cord is not provided. If the machine is intended to configured to 120 volt operation, a conversion kit 63578 is available for the addition of a proper 120 volt power cord and a seria

Summary of the content on the page No. 7

Installation (cont.) 9. After the water tank has completed the fill cycle, the display located on the front door of the dispenser should indicate that the heating element has been activated. Allow 10-60 minutes for the water tank to reach operating temperature. (Note: Heatup time is dependent on water inlet temperature and input wattage to the machine.) Bag-in-Box Hook-up 1. Place cups under dispense spouts to catch concentrate and water for priming and dispense operations to follow. 2. Place

Summary of the content on the page No. 8

User Programming Instructions refer to Figure C Setup Mode Open the door and insert Setup key into keyswitch above cooler compartment. Turn key ¼ turn clock- wise, the display on front of door will say ‘Setup Mode, Press Enter’. The two ‘Prime’ buttons and the Flush button now become the programming buttons: Prime 1 = UP, Prime 2 = DOWN, Flush = ENTER Press the Enter button (flush). The user now has access to the following options: Coffee ratio: The user can adjust the strength of the regular

Summary of the content on the page No. 9

“Engineer” Program Settings TO BE PERFORMED BY A QUALIFIED SERVICE TECHNICIAN ONLY Engineer Mode To access engineer mode go into Setup mode, when the screen says ‘Setup Mode, Press Enter’ press the Hot Water tap – the display will now say ‘Engineer Mode, Press Enter’. The engineer has access to the following options: Max Temp [181F]: Sets the maximum temperature of the boiler. Set Lockout Temp [161F]: Sets the selection lockout temperature. Power Setting [230v AC]: The input mains voltage has

Summary of the content on the page No. 10

“Engineer” Program Settings TO BE PERFORMED BY A QUALIFIED SERVICE TECHNICIAN ONLY Engineer Mode (cont.) No prod, Stop Sel [Disabled]: No product, stop Selection. If enabled, when the coffee goes low during a dispense it will stop, giving a low measure. If disabled it will continue with the dispense even if the coffee goes low, then lock out once the dispense is finished. Calibrate Temp: This is the calibration setting for the boiler thermistor. Calibrate Disp Temp: This is the calibration sett

Summary of the content on the page No. 11

“Engineer” Program Settings TO BE PERFORMED BY A QUALIFIED SERVICE TECHNICIAN ONLY Machine Fault Codes (cont.) 6: Water overheat The thermistor has detected the water is too hot. The boiler element contactor may have failed short circuit. The machine may be running high Wattage Power with a preheater. 7: Leak If the machine refills 15 times without a dispense the machine assumes a leak. A water outlet valve may be leaking. 8: Inlet valve leak Not available with single inlet valve machines 9: T

Summary of the content on the page No. 12

“Engineer” Program Settings TO BE PERFORMED BY A QUALIFIED SERVICE TECHNICIAN ONLY Programming Guide for Calibration of Mix Ratio (cont.) To check water flow rate and calibrate the actual mix ratio adjustment to match the programming mix ratio: IMPORTANT NOTE REGARDING PORTION OVERRIDE BUTTON: The default time setting for the override portion is 100 which equates to 10.0 seconds. The override dispense volume should be set to 100 (= 10.0 seconds) for calibration purpos- es. Follow the program

Summary of the content on the page No. 13

“Engineer” Program Settings TO BE PERFORMED BY A QUALIFIED SERVICE TECHNICIAN ONLY Programming Guide for Calibration of Mix Ratio (cont.) Worksheet Average water volume / Average concentrate volume = mix ratio Example: 600 ml water / 20 ml concentrate = 30:1 ratio Dispensed Water 1. _____________ ml 2. _____________ ml 3. _____________ ml Average: _____________ ml Water Flow Rate = Average ml / Override Portion Time = ml/second Water Flow Rate = _____________ ml / _____________ seconds = ______

Summary of the content on the page No. 14

Weekly Cleaning Instructions refer to Figure E NOTE: Some bag-in-box connectors require some disassembly for cleaning and sanitizing NOTE: Some bag-in-box connectors requires some extra steps for cleaning and sanitizing. 1. Remove fitting cap (a) from bag-in-box quick disconnect fitting if applicable. 2. Then, if equipped with an internal check valve follow the following steps: 3. For QCD (Liqui-Box) fitting remove fitting cap (a) then remove the internal check valve parts by using the edge of

Summary of the content on the page No. 15

Service and Cleaning Draining the Tank Always empty the tank before shipping.  WARNING: Draining of tank should be performed by a qualified service technician. The tank contains 4 gallons (15.1 litre) of very hot water. May cause severe burns. 1. Prepare a minimum 5 gallon (17.5 litre) heat resistant container to drain the tank water into. 2. Unplug the machine. 3. Remove the drain tray and front access panel. 4. Locate the silicone drain hose. Put the end of the drain hose into the buck

Summary of the content on the page No. 16

Troubleshooting Guide A troubleshooting guide is provided to suggest probable causes and remedies for the most likely problem encountered. If the problem remains after exhausting the troubleshooting steps, contact Grindmaster- Cecilware Technical Service Department (800-695-4500, 8am-6pm, M-F). • Only qualified service personnel should perform inspection, testing, and repair of electrical equipment • Intermittent operation of electronic circuit boards is unlikely. Board failure will normally be

Summary of the content on the page No. 17

Troubleshooting Guide (cont.)  WARNING: Risk of electrical shock. Disconnect power before removal of any machine access panels. Problem/Cause Remedy MACHINE DOES NOT POWER UP Machine is unplugged Ensure machine is plugged into power supply Power switch in OFF position Flip power switch to “ON” position (located at lower right corner of back of machine); Blue LCD on door should be illuminated when ON. Branch circuit breaker has tripped Reset circuit breaker at service supply panel Power supply

Summary of the content on the page No. 18

Troubleshooting Guide (cont.) Problem/Cause Remedy LCD DISPLAY INDICATES “OVERFLOW” NOTE: Water must be drained from the tank below the float switch after the fault condition is diagnosed. Water level probe sensitivity is set too low Increase sensitivity of water fill circuit (see programming notes: Water Level Trip) Faulty or corroded level probe Remove level probe and grommet. Remove any scale or miner- al buildup and reassemble. Faulty level control circuit wiring Ensure both probe and probe

Summary of the content on the page No. 19

Wiring Diagram

Summary of the content on the page No. 20

Grindmaster® Coffee Grinders and Brewers � PrecisionBrew™ Brewing Systems � Espressimo® Espresso Machines Crathco® Hot Beverage Dispensers � Crathco® Cold and Frozen Beverage Dispensers � AMW Coffee and Tea Systems Tel (502) 425-4776 � Fax (502) 425-4664 � 1-800-695-4500 (USA & Canada only) P.O. Box 35020 � Louisville, KY 40232 � USA www.grindmaster.com � email: info@grindmaster.com © Grindmaster Corporation, 2009 0910 Form # AM-328-04 PRINTED IN USA Part # 63543


Alternative user manuals
# User manual Category Download
1 Grindmaster 70752-C User manual Coffeemaker 0
2 Grindmaster 70752 User manual Coffeemaker 3
3 Grindmaster 7306 User manual Coffeemaker 0
4 Grindmaster 2450Q User manual Coffeemaker 1
5 Grindmaster 11 User manual Coffeemaker 11
6 Grindmaster 7303 User manual Coffeemaker 3
7 Grindmaster 73010 User manual Coffeemaker 0
8 Grindmaster 7713 User manual Coffeemaker 2
9 Grindmaster 67710E User manual Coffeemaker 0
10 Grindmaster 21 User manual Coffeemaker 4
11 Grindmaster 77110 User manual Coffeemaker 0
12 Grindmaster 20 User manual Coffeemaker 24
13 Grindmaster 70753-C User manual Coffeemaker 0
14 Grindmaster 7716 User manual Coffeemaker 0
15 Grindmaster AMW 80110 User manual Coffeemaker 0
16 Philips coffee maker flavor select HD7606 User manual Coffeemaker 3
17 Sony WALKMAN D-EJ2000 User manual Coffeemaker 19
18 Philips HD 7820/65 User manual Coffeemaker 62
19 Philips coffee maker flavor select HD7612 User manual Coffeemaker 91
20 Philips HD7544 User manual Coffeemaker 8