Zanussi user manual

Summary of the content on the page No. 1

EN
User manual 2
Washer/Dryer Stand with Drawer
PDST HEC

Summary of the content on the page No. 2

Contents How to install the stand on your washing How to install the stand on your tumble dryer _ _ _ _ 4 machine _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Subject to change without notice How to install the stand on your washing machine Warning! Do not install the stand on a washer/dryer column. Caution! If the washing machine is already connected to the mains, proceed as follows: 1. pull out the plug from the mains; 2. stop water supply by closing the tap; 3. disconnect the inlet pipe

Summary of the content on the page No. 3

If the side is as shown in fig. 2, you must pick the rear brackets as in fig. 4. If, the side is as shown in fig. 3, you must pick the rear brackets as in fig. 5. fig. 11 fig. 12 Slide the stand under the washing machine so that its front adjusting feet match the stands front brackets (fig. 11) and the rear bracket is positioned against the ma- fig. 6 fig. 7 chines back (fig. 12). Now you can proceed to fit one of the rear brackets to Screw the rear bracket on- the left side of the stands back u

Summary of the content on the page No. 4

The stand is now installed; check whether your washing machines back feet rest on it (fig. 16). Otherwise undo them using the key supplied with your washing machine (fig. 17). fig. 20 fig. 21 The drawer slides on two metal runners and can easily be pulled out to the full. Should you wish to remove the drawer, you must pull it out completely (fig. 20) and act fig. 18 fig. 19 on the two black plastic levers halfway through the metal runners. Pull the right lever down and the left The stands drawer

Summary of the content on the page No. 5

In the stands drawer you will find an envelope with all the necessary material for a correct assembly. Have ready a Phillips screwdriver to fit rear brackets to the stand and an Torx screwdriver to fit rear brackets to the machines back. The pack includes: • 2 grey short rubber feet to be used for the following tumble dryer models: fig. 2 Proceed as follows (fig. 2): • loosen the nuts using the key supplied with the stand; • adjust the feet to allow for an uneven floor; • tighten up all check

Summary of the content on the page No. 6

Fit the rear brackets to the machines back using the previously removed screws (fig. 11). DX fig. 7 fig. 8 After having removed the front brackets from the stand (fig. 5), fit the rear brackets (fig. 6 and 7) to the stands fig. 12 fig. 13 back, using the screws supplied (fig. 8). The stands drawer, with a capacity of up to 20 kg, con- tains two dividers; they may be taken out if you wish (fig. 12). The drawer was designed with a special com- partment inside where you can place a folding plastic

Summary of the content on the page No. 7

7

Summary of the content on the page No. 8

www.zanussi.com 132949240 - 01 - 012010