Summary of the content on the page No. 1
7K200 SATA OEM Specification
Hｉｔａｃｈｉ Global Storage Technologies
Hard Disk Drive Specification
Hitachi Travelstar 7K200
2.5 inch SATA hard disk drive
Models: HTS722020K9A300 HTS722020K9SA00
HTS722016K9A300 HTS722016K9SA00
HTS722012K9A300 HTS722012K9SA00
HTS722010K9A300 HTS722010K9SA00
HTS722080K9A300 HTS722080K9SA00
Revision 1.0 10 May 2007
1/173
Summary of the content on the page No. 2
7K200 SATA OEM Specification Preliminary Edition (Revision 0.1) (31 March 2007) nd 2 Preliminary Edition (Revision 0.2) (20 April 2007) Final Release (Revision 1.0) (10 May 2007) The following paragraph does not apply to the United Kingdom or any country where such provisions are inconsistent with local law: HITACHI GLOBAL STORAGE TECHNOLOGIES PROVIDES THIS PUBLICATION "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIE
Summary of the content on the page No. 3
7K200 SATA OEM Specification Table of Contents GENERAL...............................................................................................................................................10 1 INTRODUCTION .....................................................................................................................................10 1.1 Abbreviations...........................................................................................................................10
Summary of the content on the page No. 4
7K200 SATA OEM Specification 11.5 Error Register..........................................................................................................................47 11.6 Features Register ....................................................................................................................48 11.7 LBA High Register ..................................................................................................................48 11.8 LBA Low Register....................
Summary of the content on the page No. 5
7K200 SATA OEM Specification 13.5 First-parity DMA Commands.................................................................................................73 14 COMMAND DESCRIPTIONS ..................................................................................................................74 14.1 Check Power Mode (E5h/98h).................................................................................................78 14.2 Device Configuration Overlay (B1h) .........................
Summary of the content on the page No. 6
7K200 SATA OEM Specification 14.43 Write DMA (CAh/CBh)......................................................................................................159 14.44 Write DMA Ext (35h).........................................................................................................160 14.45 Write DMA FUA Ext (3Dh)...............................................................................................161 14.46 Write FPDMA Queued (61h)............................................
Summary of the content on the page No. 7
7K200 SATA OEM Specification List of Tables Table 1. Formatted capacity by model number. 17 Table 2. Data sheet 18 Table 3. Cylinder allocation 18 Table 4. Performance characteristics 19 Table 5. Mechanical positioning performance 20 Table 6. Full stroke seek time 20 Table 7. Single track seek time 20 Table 8. Latency time 20 Table 9. Drive ready time 21 Table 10. Operating mode 22 Table 11. Drive ready time 22 Table 12. Environmental condition 26 Table 13. Magnetic flux density
Summary of the content on the page No. 8
7K200 SATA OEM Specification Table 58 Identify device information --- Continued --- 93 Table 59 Identify device information --- Continued --- 94 Table 60 Identify device information --- Continued --- 95 Table 61 Identify device information --- Continued --- 96 Table 62 Identify device information --- Continued --- 97 Table 63 Number of cylinders/heads/sectors by models for HTS7220XXK9SA00 / HTS7220XXK9A300 98 Table 64 Idle Command (E3h/97h) 99 Table 65 Idle Immediate Command (E1h/95h) 10
Summary of the content on the page No. 9
7K200 SATA OEM Specification Table 120 Error data structure 153 Table 121 Self-test log data structure 154 Table 122 Selective self-test log data structure 155 Table 123 S.M.A.R.T. Error Codes 155 Table 124 Standby Command (E2h/96h) 156 Table 125 Standby Immediate Command (E0h/94h) 157 Table 126 Write Buffer Command (E8h) 158 Table 127 Write DMA Command (CAh/CBh) 159 Table 128 Write DMA Ext Command (35h) 160 Table 129 Write DMA FUA Ext Command (3Dh) 161 Table 130 Write FPDMA Queued Co
Summary of the content on the page No. 10
7K200 SATA OEM Specification General 1 Introduction This document describes the specifications of the HITACHI Travelstar 7K200, a 2.5-inch hard disk drive with Serial ATA interface: Drive Model Number MAX Data Capacity Height Rotation name transfer rate (GB) (mm) speed (rpm) (Gbps) HTS722020K9A300 3.0 Travelstar 200 9.5 7200 7K200-200 HTS722020K9SA00 1.5 HTS722016K9A300 3.0 Travelstar 160 9.5 7200 7K200-160 HTS722016K9SA00 1.5 HTS722012K9A300 3.0 Travelstar 120 9.5 7200 7K20
Summary of the content on the page No. 11
7K200 SATA OEM Specification EMC electromagnetic compatibility ERP Error Recovery Procedure Esd electrostatic discharge FCC Federal Communications Commission FRU field replacement unit G gravity, a unit of force Gb 1 000 000 000 bits GB 1 000 000 000 bytes GND ground h hexadecimal HDD hard disk drive Hz hertz I Input ILS integrated lead suspension imped impedance I/O Input/Output ISO International Standards Organization KB 1,000 bytes Kbit/mm 1,000 bits per mm Kbit/sq-mm 1000
Summary of the content on the page No. 12
7K200 SATA OEM Specification PIO POH power on hours Pop. population P/N part number p-p peak-to-peak PSD power spectral density RES radiated electromagnetic susceptibility RFI radio frequency interference RH relative humidity % RH per cent relative humidity RMS root mean square RPM revolutions per minute RST reset R/W read/write sec second Sect/Trk sectors per track SELV secondary low voltage S.M.A.R.T Self-monitoring, analysis, and reporting technology Trk. track TTL transi
Summary of the content on the page No. 13
7K200 SATA OEM Specification 1.2 References Serial ATA International Organization : Serial ATA Revision 2.6 1.3 General caution Do not apply force to the top cover (See figure below). Do not cover the breathing hole on the top cover (See figure below). Do not touch the interface connector pins or the surface of the printed circuit board. The drive can be damaged by shock or ESD (Electric Static Discharge). Any damages incurred to the drive after removing it from the shipping package and
Summary of the content on the page No. 14
7K200 SATA OEM Specification 2 Outline of the drive ・ 2.5-inch, 9.5-mm Height ・ Perpendicular Recording ・ Formatted capacities of 200GB, 160GB,120GB,100GB, and 80GB (512 bytes/sector) ・ SATA Interface conforming to Serial ATA International Organization: Serial ATA Revision 2.6(15-February-2007) ・ Integrated controller ・ No-ID recording format ・ Coding : 199/200 ・ Multi zone recording ・ Enhanced ECC ・ 10 bit 40 symbol non Interleaved Read Solomon code ・ Non interleave On-The –
Summary of the content on the page No. 15
7K200 SATA OEM Specification Part 1 Functional Specification 15/173
Summary of the content on the page No. 16
7K200 SATA OEM Specification 3 Fixed disk subsystem description 3.1 Control Electronics The control electronics works with the following functions: SATA Interface Protocol Embedded Sector Servo No-ID (TM) formatting Multizone recording Code: 100/102 ・ System ECC ・ Enhanced Adaptive Battery Life Extender ・ Full Data Encryption as optional(HTS7220xxK9SA00 model only) 3.2 Head disk assembly data The following technologies are used in the drive: Femto Slider Perpendicular
Summary of the content on the page No. 17
7K200 SATA OEM Specification 4 Fixed disk characteristics 4.1 Formatted capacity by model number Description HTS722020K9A300 HTS722016K9A300 HTS722012K9A300 HTS722020K9SA00 HTS722016K9SA00 HTS722012K9SA00 Physical Layout Bytes per Sector 512 512 512 Sectors per Track 1209 (max) 1092 (max) 1092 (max) Number of Heads 4 4 3 Number of Disks 2 2 2 Logical Layout Number of Heads 16 16 16 Number of Sectors/ 63 63 63 Track Number of Cylinders 16,383 16,383 16,383 Number of Sec
Summary of the content on the page No. 18
7K200 SATA OEM Specification 4.2 Data sheet 200GB 160GB 120GB 100GB 80GB Rotational Speed (RPM) 7200 7200 7200 7200 7200 Data transfer rates (buffer to/from 876 695 695 876 695 media) (Mbps) Data transfer rates (Gbit/sec) 1.5/3.0 1.5/3.0 1.5/3.0 1.5/3.0 1.5/3.0 Recording density (Kbit/mm) (Max) (KBPI) (Max) 994 903 903 994 903 Track density (Ktrack/mm)(Max) (KTPI)(Max) 164 146 146 164 146 Areal density (Gbit/sq-mm.- Max)
Summary of the content on the page No. 19
7K200 SATA OEM Specification 4.4 Performance characteristics Drive performance is characterized by the following parameters: Command Overhead Mechanical Positioning Seek Time Latency Data Transfer Speed Buffering Operation (Look ahead/Write Cache) Note: All the above parameters contribute to drive performance. There are other parameters which contribute to the performance of the actual system. This specification defines the essential characteristics of the drive. This specificat
Summary of the content on the page No. 20
7K200 SATA OEM Specification 4.4.2 Mechanical positioning 4.4.2.1 Average seek time (including settling) Command Type Typical (ms) Max. (ms) Read 10 16 Write 11 17 Table 5. Mechanical positioning performance Typical and Max. are defined throughout the performance specification as follows: Typical Average of the drive population tested at nominal environmental and voltage conditions. Max. Maximum value measured on any one drive over the full range of the environmental and voltage condi
