Tannoy VNET SC1 user manual

Summary of the content on the page No. 1

User Guide
TM
VNET USB AND RS232 INTERFACE

Summary of the content on the page No. 2

IMPORTANT SAFETY INFORMATION Please read carefully and keep the following instructions and safety information. Heed all warnings and follow all instructions. 1. Do not remove covers. There are no user-serviceable parts inside; please refer servicing to qualified service personnel. 2. This equipment must be earthed. 3. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 4. Only use attachments/ac

Summary of the content on the page No. 3

VNET INTERFACE USER GUIDE IMPORTANT SAFETY INFORMATION VNET™ is a fast networking topology using standard Please read carefully and keep the following Cat5 cabling to interconnect compatible devices instructions and safety information. Heed all using a simple cabling scheme. The total span of warnings and follow all instructions. the network may be at least 1km without repeaters. • Do not remove covers. There are no There is no maximum length for a single span user-serviceable parts inside; plea

Summary of the content on the page No. 4

WINDOWS 2000 DRIVER INSTALLATION 10. Repeat step (4) to (8) to complete installation. You need to have administrator privileges to install COM PORT any new drivers under Windows2000. To install the The PodWare application uses a COM port to driver or update the configuration please log onto communicate with the connected devices. When Windows 2000 as "Administrator" or ask your you use the RS232 connection from your computer system administrator to install the USB driver. to the VNET™ Interface,

Summary of the content on the page No. 5

VNET INTERFACE USER GUIDE 2. Remove the two screws from one side of the Accessory. 3. Using the two screws removed in 2, attach one mounting bracket loosely to the side of the USB Accessory, with the ‘ear’ towards the front, pointing You can connect your computer to the VNET™ outwards. Interface via USB using a USB Type A to USB Type B cable as in diagram 2. It is not usually necessary to use a Power Supply to power the VNET™ Interface when using USB, since USB will supply sufficient power for t

Summary of the content on the page No. 6

OPERATION Are the appropriate indicators illuminated? Once the VNET™ Interface has been connected to (See above). the computer and to the devices (and if applicable, to the optional VNET™ Power Supply) then there Make sure the network cable is not too long, is are no further adjustments to make on the interface correctly connected, and is not damaged. itself. The indicators on the front of the unit operate Check that the Tx indicator flashes when PodWare as follows attempts to go online. Will no

Summary of the content on the page No. 7

NOTES 7

Summary of the content on the page No. 8

Tannoy United Kingdom T: 00 44 (0) 1236 420199 E: enquiries@tannoy.com Tannoy North America T: 00 1 (519) 745 1158 E: inquiries@tannoyna.com Tannoy Deutschland T: 00 49 (0180) 1111 881 E: info@tannoy.com Tannoy France T: 00 33 (0)1 7036 7473 E: ventes@tannoy.com