Summary of the content on the page No. 1
Summary of the content on the page No. 2
Copyright Notice The material in this document is the intellectual property of MICRO-STAR INTERNATIONAL. We take every care in the preparation of this document, but no guarantee is given as to the correctness of its contents. Our products are under continual improvement and we reserve the right to make changes without notice. Trademarks All trademarks are the properties of their respective owners. ® ® Intel and Pentium are registered trademarks of Intel Corporation. AMD, Athlon™, Athlon™ XP, Th
Summary of the content on the page No. 3
Safety Instructions 1. Always read the safety instructions carefully. 2. Keep this User’s Manual for future reference. 3. Keep this equipment away from humidity. 4. Lay this equipment on a reliable flat surface before setting it up. 5. The openings on the enclosure are for air convection hence protects the equip- ment from overheating. DO NOT COVER THE OPENINGS. 6. Make sure the voltage of the power source and adjust properly 110/220V be- fore connecting the equipment to the power inlet. 7. Pla
Summary of the content on the page No. 4
FCC-B Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accor- dance with the instructions, may cause harmful interference to radio communications. Howev
Summary of the content on the page No. 5
WEEE (Waste Electrical and Electronic Equipment) Statement v
Summary of the content on the page No. 6
vi
Summary of the content on the page No. 7
vii
Summary of the content on the page No. 8
CONTENTS Copyright Notice .................................................................................................... iii Trademarks ............................................................................................................ iii Revision History .................................................................................................... iii Technical Support ................................................................................................. iii
Summary of the content on the page No. 9
TV-Out Connector: JTV1 .................................................................... 2-16 Jumpers .................................................................................................... 2-17 Display Jumper: TV/CRT1 ................................................................... 2-17 Clear CMOS Jumper: CLR_CMOS1 ...................................................... 2-17 LCD Power Source Jumper: J7 ........................................................... 2-18 COM Port P
Summary of the content on the page No. 10
x
Summary of the content on the page No. 11
Getting Started Chapter 1 Getting Started Thank you for choosing the Fuzzy CX700/CX700D (MS- 9802 v1.X) Mini ITX mainboard from MSI. Based on the innovative VIA CX700/ CX700M/ CX700M2 controller for optimal system efficiency, the Fuzzy CX700/CX700D accommodates VIA C7/ Eden/ Eden ULV processor and supports one 240-pin 400/533MHz DDR2 DIMM slot to provide the maximum of 2GB memory capacity. Noiseless, fanless and low power consumption are the advantages of the Fuzzy CX700/CX700D, making it an ide
Summary of the content on the page No. 12
MS-9802 Mainboard Mainboard Specifications Processor Support - VIA C7/ Eden/ Eden ULV processor with nanoBGA2 footprint - 3-pin CPU fan pinheader with Smart Fan Speed Control TM - Power Saver Technology enabled Supported FSB - 400/ 533 MHz Chipset - Single chip solution: VIA CX700/ CX700M/ CX700M2 Memory Support - DDR2 400/533 SDRAM (2GB Max) or ECC DDR2 400 only - 1 DDR2 DIMM slot (240pin / 1.8V) LAN - 2 PCI Gb LAN by Realtek RTL8110SC Audio ® - Realtek ALC888 7.1-channel HDA codec - 6 watt a
Summary of the content on the page No. 13
Getting Started Connectors Rear I/O - 1 PS/2 mouse port - 1 PS/2 keyboard port - 1 COM port stack connector (2 RS-232 ports) - 1 VGA/ DVI stack connector - 2 RJ45/ USB stack connectors - 1 3-jack audio connector On-Board Pinheaders - 1 USB pinheader (2 ports) - 1 parallel port pinheader (LPT) - 2 COM ports pinheader (RS-232) - 1 LVDS pinheader - 1 DIO pinheader (4 IN/ 4 OUT) - 1 TV out pinheader - 1 audio pinheader (7.1-channel) - 1 amplifier pinheader - 1 front panel pinheader - 1 SMBUS pinhead
Summary of the content on the page No. 14
MS-9802 Mainboard Watch Dog Timer Setting 1-4
Summary of the content on the page No. 15
Getting Started Software code SIO_IDX equ 4EH SIO_DTA equ 4FH Timer equ 10 ;reset after 10 seconds 1. Enter configuration mode mov dx,SIO_IDX mov al,87h out dx,al out dx,al 2 Set Pin118 to WDTO# mov dx,SIO_IDX mov al,2Bh out dx,al mov dx,SIO_DTA in al,dx and al,not 04h out dx,al 3. Set to and active LDN 08
Summary of the content on the page No. 16
MS-9802 Mainboard Block Diagram 1-6
Summary of the content on the page No. 17
Getting Started Mainboard Layout J2 J1 J3 Top: J4 COM3 J5 Mouse Bottom: CPUFAN1 Keyboard VIA COM4 C7 CPU Serial Ports JLPT1 J6 VIA CX700/ CX700M/ CX700M2 Top: VGA Port VIA JLVDS1 Bottom: VT1632A J7 DVI-D Port JTV1 TV/CRT1 Top: LAN Jack Bottom: USB Ports SATA1 SATA2 Top: LAN Jack BIOS Bottom: USB Ports SYSFAN1 IRDA1 F_USB1 MINIPCI1 T: Line-In JCD1 ALC888 M: Line- Out B: Mic-In JAUD1 IDEB1 JAUD2 JFP1 TPA3005 PCI1 JCF_SEL1 CLR_CMOS1 RTL 8110SC CF1 RTL 8110SC Fuzzy CX700/CX700D (MS-9802 v1.X) M
Summary of the content on the page No. 18
MS-9802 Mainboard Board Dimension 1-8
Summary of the content on the page No. 19
Hardware Setup Chapter 2 Hardware Setup This chapter provides you with the information about hardware setup procedures. While doing the installation, be careful in holding the components and follow the installation procedures. For some components, if you install in the wrong orientation, the components will not work properly. Use a grounded wrist strap before handling computer components. Static electricity may damage the components. 2-1
Summary of the content on the page No. 20
MS-9802 Mainboard Quick Components Guide COM4, p.2-14 COM3, p.2-14 J1, p.2-16 J2~J5, p.2-18 CPUFAN1, p.2-13 Back Panel, p.2-6 DIMM1, p.2-3 J6, p.2-11 JLPT1, p.2-13 JLVDS1, p.2-15 ATX1, p.2-4 J7, p.2-18 SATA1/2, JTV1, p.2-16 p.2-9 SYSFAN1, p.2-13 TV/CRT1, p.2-17 IRDA1, p.2-16 JAUD1, p.2-12 JFP1, p.2-10 PCI1, p.2-19 JCD1, p.2-15 JCF_SEL1, p.2-8 F_USB1, p.2-14 JAUD2, p.2-12 MINIPCI1, CLR_CMOS1, p.2-20 p.2-17 IDEB1, p.2-8 2-2
