Summary of the content on the page No. 1
NEC Multimedia Series
®
MultiSync
MultiSync
™
™
M700
M700
User’s Manual
User’s Manual
15500291.wpc 1 7/27/99, 3:41 PM
You can
register your
product online at
www.nectech.com/
productregistration
Summary of the content on the page No. 2
Index Warning 1 Contents 2 Quick Start 3-4 Controls 5-8 Recommended Use 9-10 Specifications 11 Features 12 Troubleshooting 13 References 14 Limited Warranty 15 TCO’92 16 Avertissement 17 Contenu 18 Mise en marche rapide 19-20 Commandes 21-22 Usage recommandé 24-25 Fiche technique 26 Fonctions 27 Dépannage 28 Références 29 Garantie limitée 30 TCO’92 31 15500291.wpc 2 7/27/99, 3:41 PM
Summary of the content on the page No. 3
WARNING TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT'S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED. REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. CAUTION RISK OF ELECTRIC SHOCK • DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS IN
Summary of the content on the page No. 4
® ® MultiSync MultiSync M M700 700 User’s M User’s Manual anual NEC Multimedia Series Contents You can register your product online at www.nectech.com/productregistration ® ™ Your new NEC Technologies MultiSync M700 monitor box* should contain the following: • MultiSync M700 (JC-1735VMA-3) Monitor with removable tilt/swivel base • Power Cord • Captive Combined Signal Cable • User’s Manual Captive Combined Signal Cable Power Cord User’s Manual * Remember to save your original box and packing mate
Summary of the content on the page No. 5
Quick Start ® ™ To attach the MultiSync M700 monitor to your system, follow these instructions: 1. Turn off the power to your computer. 2. If necessary, install the display card into your system. For more information, refer to the display card manual. 3. For the PC: Connect the MultiSync M700 15-pin mini D-SUB of the captive combined signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws. Captive Combined Signal Cable 15-pin mini D-SUB Figure A.1 For
Summary of the content on the page No. 6
Quick Start cont. 4. Locate the audio output connection on the component(s) which will serve as the source(s) for the built-in speakers. (The component(s) could be your system, CD- ROM, sound card, etc.). 5. Once you have determined the source, identify the connector present from the source and connect the stereo input cable. Headphone Headphones may be connected to the “Headphones” output on the left of the monitor’s bezel marked “ ”. While the headphones are connected, the sound from th
Summary of the content on the page No. 7
Controls ™ OSM (On-Screen Manager) control buttons on the front of the monitor function as follows: Main Menu Sub-Menu EXIT Exits the OSM menu. Exits to the OSM main menu. CONTROL Moves the highlighted Moves the highlighted area / area up/down to select up/down to select one of the one of the controls. controls. CONTROL Moves highlighted Moves the bar in the + or – +/– area left/right to select direction to increase or one of the controls. decrease the adjustment. PROCEED Has no function. Onl
Summary of the content on the page No. 8
Controls cont. Size and Position Left/Right: Moves the image horizontally (left or right). Down/Up: Moves the image vertically (up or down). Narrow/Wide: Increases or decreases the horizontal size of the image. Short/Tall: Increases or decreases the vertical size of the image. ® Color Control/AccuColor Control System Color presets 1 through 5 select the desired color setting. The bar is replaced by the color setting choice from 1 to 5. Each color setting is adjusted at the factory to the state
Summary of the content on the page No. 9
Controls cont. This bar provides adjustment for changing the level of sound effects, acting as an equalizer. NOTE: Select desired setting based upon your application. ™ Language: OSM menus are available in 6 languages. OSM Position: You can choose where you would like the OSM image to appear on your screen. Selecting OSM Position allows you to manually adjust the OSM menu left, right, up or down. OSM Turn Off: The OSM menu will stay on as long as it is in use. In the OSM Turn Off sub-menu, you
Summary of the content on the page No. 10
Controls cont. Information Fitness Tips: The Fitness Tips provide you with helpful reminders to periodically rest your eyes. You may select how frequently the reminders are displayed based upon your individual needs. Select an interval from 15, 30, 45, 60, 90, 120 minutes for the tips to appear. When the tips appear, follow the advice of the tips and press EXIT to clear. Display Mode: Indicates the current mode and frequency setting of the monitor. Monitor Info: Indicates the model and serial nu
Summary of the content on the page No. 11
Recommended Use Safety Precautions and Maintenance FOR OPTIMUM PERFORMANCE, PLEASE NOTE THE FOLLOWING WHEN SETTING UP AND USING ® ™ THE MULTISYNC M700 COLOR MONITOR: • DO NOT OPEN THE MONITOR. There are no user serviceable parts inside and opening or removing covers may expose you to dangerous shock hazards or other risks. Refer all servicing to qualified service personnel. • Do not spill any liquids into the cabinet or use your monitor near water. • Do not insert objects of any kind into the ca
Summary of the content on the page No. 12
Recommended Use cont. CORRECT PLACEMENT AND ADJUSTMENT OF THE MONITOR CAN REDUCE EYE, SHOULDER AND NECK FATIGUE. CHECK THE FOLLOWING WHEN YOU POSITION THE MONITOR: • Adjust the monitor height so that the top of the screen is at or slightly below eye level. Your eyes should look slightly downward when viewing the middle of the screen. • Position your monitor no closer than 12 inches and no further away than 28 inches from your eyes. The optimal distance is 18 inches. • Rest your eyes periodically
Summary of the content on the page No. 13
Specifications ® ™ Monitor MultiSync M700 Notes Specifications Monitor Picture Tube Diagonal: 17 inch 90 deflection, 0.25 mm mask pitch, ® Viewable Image Size: 15.6 inch CromaClear CRT, medium-short persistence Radius: 1210 mm phosphor, multi-layered, anti-static screen coating, semi-dark-tint screen, Invar Shadow ® Mask and OptiClear screen surface. Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms Sync: Separate sync. TTL Level Horizontal sync. Positive/Negative Vertical sync. Positive/Negative Di
Summary of the content on the page No. 14
Features ® CromaClear CRT: Delivers images with more clarity than found in traditional CRT’s. Phosphors appear elliptical when illuminated, resulting in screen images with more depth and dimension. ® OptiClear Screen Surface: Reduces reflection and glare and increases contrast without sacrificing focus level, clarity or brightness. Along with the flat square technology CRT, a high contrast screen with 0.25 mm mask pitch delivers crisp, clean text and graphics. Invar Shadow Mask: Holes in the thi
Summary of the content on the page No. 15
Troubleshooting No picture • Display card should be completely seated in its slot. • Power Button and computer power switch should be in the ON position. • Signal cable should be completely connected to display card/computer. • Check connector for bent or pushed-in pins. Image is scrolling or unstable • Signal cable should be completely attached to the computer. • Check pin assignments and signal timings of the monitor and your display card with respect to recommended timings and pin assignments
Summary of the content on the page No. 16
References • BBS (978) 742-8706 NEC Technologies’ Remote Bulletin Board System is an electronic service accessible with your system and a modem. Communication parameters are: 300/1200/2400/9600/14.4k/28.8k bps, no parity, 8-data bits, 1 stop bit • Customer Service/ Technical Support (800) 632-4662 Fax (978) 742-7049 • Electronic Channels: Internet e-mail: tech-support@nectech.com Internet ftp site: ftp.nectech.com World Wide Web: http://www.nectech.com Product Registration: http://www.nectech.co
Summary of the content on the page No. 17
Limited Warranty NEC Technologies, Inc. (hereinafter “NECTECH”), warrants this Product to be free from defects in material and workmanship and, subject to the conditions set forth below, agrees to repair or replace (at NECTECH’s sole option) any part of the enclosed unit which proves defective for a period of three (3) years from the date of first consumer purchase. Spare parts are warranted for ninety (90) days. Replacement parts or units may be new or refurbished and will meet specifications o
Summary of the content on the page No. 18
S D L D E I I S F P L A C A U I Y D T T E E P O C N O M TCO’92 U This model complies with TCO ’92 guidelines for low frequency electric fields, magnetic field, static electricity and automatic power down requirements. To obtain complete information on the environmental criteria documents, order from: TCO Development Unit SE-11494 Stockholm SWEDEN FAX Number: +46 8 782 92 07 E-mail (Internet): development@tco.se You may also obtain current information on TCO ’92 approved and labelled products by
Summary of the content on the page No. 19
AVERTISSEMENT AFIN D’ÉVITER TOUT RISQUE D’INCENDIE OU D’ÉLECTROCUTION, NE PAS EXPOSER CET APPAREIL À LA PLUIE OU À L’HUMIDITÉ. NE PAS UTILISER LA FICHE D’ALIMENTATION POLARISÉE AVEC UNE PRISE DE CORDON DE RALLONGE OU AUTRE PRISE SAUF SI LES BROCHES PEUVENT ÊTRE ENTIÈREMENT INTRODUITES. NE PAS OUVRIR LE BOÎTIER, LEQUEL CONTIENT DES COMPOSANTS À HAUTE TENSION. CONFIER TOUS TRAVAUX À DU PERSONNEL TECHNIQUE QUALIFIÉ. ATTENTION RISQUE DE DÉCHARGE ÉLECTRIQUE • NE PAS OUVRIR ATTENTION : POUR ÉVITER TOU
Summary of the content on the page No. 20
® ® M MultiSync ultiSync M700 M700 U Use ser’s M r’s Ma an nu ua all NEC Multimedia Series Contenu Votre produit peut être enregistré sur Internet à l’adresse http://www.nectech.com/productregistration ® La boîte* de votre nouveau moniteur NEC Technologies MultiSync MC M700 contient : • Moniteur MultiSync M700 (JC-1735VMA-3) avec socle inclinable/rotatif • Cordon, d’alimentation • Câble unir d’interface • Manuel de l’utilisateur Cable unir d’interface Cordon d’alimentation Manuel de l’utilisateu
