Summary of the content on the page No. 1
NEC MultiSync Series
™
™
®
®
MultiSync125
MultiSync125
MS125 Manual.wpc 1 5/7/01, 3:33 PM
Register your
product online at
www.nectech.com/
productregistration
Summary of the content on the page No. 2
Index Warning 1 Contents 2 Quick Start 3-4 Controls 5-6 Recommended Use 7-8 Specifications 9 Features 10 Troubleshooting 11 References 12 Limited Warranty 13 Avertissement 14 Contenu 15 Mise en marche rapide 16-17 Commandes 18-19 Usage recommandé 20-21 Fiche techniques 22 Fonctions 23 Dépannage 24 Références 25 Garantie limitée 26 MS125 Manual.wpc 2 5/7/01, 3:33 PM
Summary of the content on the page No. 3
WARNING TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT'S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED. REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. CAUTION RISK OF ELECTRIC SHOCK • DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS IN
Summary of the content on the page No. 4
Contents You can register your product online at www.nectech.com/productregistration ® Your new NEC Technologies MultiSync monitor box* should contain the following: • MultiSync Monitor • Power Cord •User’s Manual ™ MultiSync 125 • Video Signal Cable •Diskette Video Signal Cable Diskette Power Cord User’s Manual * Remember to save your original box and packing material to transport or ship the monitor. 2 MS125 Manual.wpc 4 5/7/01, 3:34 PM
Summary of the content on the page No. 5
Quick Start ® To attach the MultiSync monitor to your system, follow these in- structions: 1. Turn off the power to your computer. 2. If necessary, install the display card into your system. For more information, refer to the display card manual. 3. For the PC: Connect the one end of the 15-pin mini D-SUB of the video signal cable to the rear of the monitor and the other end to the connector of the display card in your system (Figure A.1). Tighten all screws. For the Mac: Connect the Macintosh c
Summary of the content on the page No. 6
Quick Start cont. Mac Adapter (Not Included) 15-pin mini D-SUB Video Signal Cable Figure B.1 Power Outlet Power Cord Figure C.1 MultiSync 125 Power Button Figure D.1 4 MS125 Manual.wpc 6 5/7/01, 3:34 PM
Summary of the content on the page No. 7
Controls ™ OSM (On-Screen Manager) control buttons on the front of the monitor function as follows: SELECT Enters and exits the OSM menu. CONTROL –/+ Selects one of the controls and increases or decreases the adjustment. / Moves the highted area / to select control. Adjusts the overall image and background screen brightness. Adjusts the image brightness in relation to the background. Color Preset: Select from 9300K or 6500K color temperature. Color Temperature: Increases or decreas
Summary of the content on the page No. 8
Controls cont. Rotates the entire display clockwise or counterclockwise. Increases or decreases the curvature of the inward or outward top corners. Increases or decreases the curvature of the bottom corner inward or outward. Video Level: Select from 0.7 or 1.0V to match to computers output. Language: Adjusts language of OSM menu. OSD Position: Adjusts Position of OSM menu. Clamp: Adjusts image of a non-standard timing to a normal state. Degauss: Eliminates the buildup of stray magnetic fields wh
Summary of the content on the page No. 9
Recommended Use Safety Precautions and Maintenance FOR OPTIMUM PERFORMANCE, PLEASE NOTE THE FOLLOWING WHEN SETTING UP AND USING ® THE MultiSync COLOR MONITOR: • DO NOT OPEN THE MONITOR. There are no user serviceable parts inside and opening or removing covers may expose you to dangerous shock hazards or other risks. Refer all servicing to qualified service personnel. • Do not spill any liquids into the cabinet or use your monitor near water. • Do not insert objects of any kind into the cabinet s
Summary of the content on the page No. 10
Recommended Use cont. CORRECT PLACEMENT AND ADJUSTMENT OF THE MONITOR CAN REDUCE EYE, SHOULDER AND NECK FATIGUE. CHECK THE FOLLOWING WHEN YOU POSITION THE MONITOR: • Adjust the monitor height so that the top of the screen is at or slightly below eye level. Your eyes should look slightly downward when viewing the middle of the screen. • Position your monitor no closer than 12 inches and no further away than 28 inches from your eyes. The optimal distance is 18 inches. • Rest your eyes periodically
Summary of the content on the page No. 11
Specifications ® ™ Monitor MultiSync 125 Notes Specifications Monitor Picture Tube Diagonal: 21.0 inch 90° deflection, 0.25 mm trio dot pitch, Viewable Image Size: 20.0 inch medium short persistence phosphor, Radius: 1730 mm multi-layered, anti-static screen coating, semi-tint screen, Invar Shadow Mask and ® OptiClear screen surface. Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms Sync: Separate sync. TTL Level Horizontal sync. Positive/Negative Vertical sync. Positive/Negative Composite sync Positi
Summary of the content on the page No. 12
Features Flat Square Technology: Using a 0.25 mm dot type CRT, delivers an increased contrast and crisp, clean text and graphics without sacrificing the focus level, clarity and brightness. ® OptiClear Screen Surface: Reduces reflection and glare and increases contrast without sacrificing focus level, clarity or brightness. Along with the flat square technology CRT, a high contrast screen delivers crisp, clean text and graphics. Invar Shadow Mask: Holes in the thin metal sheet behind the glass o
Summary of the content on the page No. 13
Troubleshooting No picture • Display card should be completely seated in its slot. • Power Button and computer power switch should be in the ON position. • Signal cable should be completely connected to display card/computer and monitor. • Check connector for bent or pushed-in pins. Image is scrolling or unstable • Signal cable should be completely attached to the computer and monitor. • Check pin assignments and signal timings of the monitor and your display card with respect to recommended tim
Summary of the content on the page No. 14
References • BBS (978) 742-8706 NEC Technologies’ Remote Bulletin Board System is an electronic service accessible with your system and a modem. Communication parameters are: 9600/14.4k/28.8k bps /56 k bps, no parity, 8-data bits, 1 stop bit • Customer Service/ Technical Support (800) 632-4662 Fax (978) 742-7049 • Electronic Channels: Internet e-mail: tech-support@nectech.com Internet ftp site: ftp.nectech.com World Wide Web: http://www.nectech.com Product Registration: http://www.nectech.co
Summary of the content on the page No. 15
Limited Warranty NEC Technologies, Inc. (hereinafter “NECTECH”), warrants this Product to be free from defects in material and workmanship and, subject to the conditions set forth below, agrees to repair or replace (at NECTECH’s sole option) any part of the enclosed unit which proves defective for a period of one (1) year from the date of first consumer purchase. Spare parts are warranted for ninety (90) days. Replacement parts or units may be new or refurbished and will meet specifications of t
Summary of the content on the page No. 16
AVERTISSEMENT AFIN D’ÉVITER TOUT RISQUE D’INCENDIE OU D’ÉLECTROCUTION, NE PAS EXPOSER CET APPAREIL À LA PLUIE OU À L’HUMIDITÉ. NE PAS UTILISER LA FICHE D’ALIMENTATION POLARISÉE AVEC UNE PRISE DE CORDON DE RALLONGE OU AUTRE QUE SI LES BROCHES PEUVENT ÊTRE ENTIÈREMENT INTRODUITES. NE PAS OUVRIR LE BOÎTIER, LEQUEL CONTIENT DES COMPOSANTS À HAUTE TENSION. CONFIER TOUS TRAVAUX À DU PERSONNEL TECHNIQUE QUALIFIÉ. ATTENTION RISQUE DE DÉCHARGE ÉLECTRIQUE • NE PAS OUVRIR ATTENTION : POUR ÉVITER TOUT RISQU
Summary of the content on the page No. 17
Contenu Votre produit peut être enregistré sur Internet à l’adresse http://www.nectech.com/productregistration La boîte de votre nouveau moniteur NEC Technologies ® MultiSync contient : MC • Moniteur MultiSync avec socle inclinable/rotatif MultiSync 125 • Cordon d'alimentation •Câble de signal captif •Mode d'emploi Câble de signal captif Diskette Cordon d'alimentation Manuel de l’utilisateur * Ne pas oublier de conserver la boîte et le matériel d'emballage d'origine pour trans- porter ou expédie
Summary of the content on the page No. 18
Mise en marche rapide ® Pour raccorder le moniteur MultiSync au système, suivre les direc- tives ci-après : 1. Mettre l'ordinateur hors tension. 2. Si nécessaire, installer la carte vidéo dans le système. Pour plus d'informations, se reporter au mode d'emploi de la carte vidéo. 3. Pour le PC : Connecter la mini-fiche D-SUB à 15 broches du câble d’interface au connecteur de la carte vidéo du système (Figure A.1). Serrer toutes les vis. Pour le Mac : Connecter l'adaptateur de câble Macintosh (non
Summary of the content on the page No. 19
Mise en marche rapide (suite) Adaptateur Mac (non fourni) Mini-fiche D-SUB à 15 broches Câble d’interface Figure B.1 Prise de courant Cordon d’alimentation Figure C.1 MultiSync 125 Bouton d’alimentation Figure D.1 17 MS125 Manual.wpc 19 5/7/01, 3:34 PM
Summary of the content on the page No. 20
Commandes La commande d’cOSM (gestionnaire d’On-Screen) se boutonne sur l’avant de la fonction de moniteur comme suit: SELECT Écrit et quitte le menu d’cOSM. CONTROL –/+ Choisit un des commandes et des augmentations ou diminue le réglage. / Déplace mise en valeur la zone / pour choisir la commande. Ajuste l’image et l’éclat globaux d’écran de fond. Ajuste l’éclat d’image par rapport au fond. La Couleur A pré-établi: Choisissez parmi la température de la couleur 9300K ou 6500K La Tem
