NEC XP37 user manual

User manual for the device NEC XP37

Device: NEC XP37
Category: Computer Monitor
Manufacturer: NEC
Size: 0.6 MB
Added : 8/22/2013
Number of pages: 38
Print the manual

Download

How to use this site?

Our goal is to provide you with a quick access to the content of the user manual for NEC XP37. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with NEC XP37.

For your convenience

If looking through the NEC XP37 user manual directly on this website is not convenient for you, there are two possible solutions:

  • Full Screen Viewing - to easily view the user manual (without downloading it to your computer), you can use full-screen viewing mode. To start viewing the user manual NEC XP37 on full screen, use the button Fullscreen.
  • Downloading to your computer - You can also download the user manual NEC XP37 to your computer and keep it in your files. However, if you do not want to take up too much of your disk space, you can always download it in the future from ManualsBase.
NEC XP37 User manual - Online PDF
Advertisement
« Page 1 of 38 »
Advertisement
Print version

Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual NEC XP37 but the selected pages only. paper.

Summaries

Below you will find previews of the content of the user manuals presented on the following pages to NEC XP37. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.

Abstracts of contents
Summary of the content on the page No. 1


R
37 Plus Plus
37
R
Multimedia Monitor
User's Manual
R
37 Plus 37 Plus
NEC Technologies, Inc.
MultiSync is a registered trademark of NEC Technologies, Inc. in the U.S.A.
1250 N. Arlington Heights Road, Suite 500
NEC is registered trademark of NEC Corporation.
Printed in Japan
1993 by NEC Technologies, Inc.
Itasca, Illinois 60143-1248
79TH1235

Summary of the content on the page No. 2

DOC compliance Notice CAUTION This Class A digital apparatus meets all requirements of the Canadian RISK OF ELECTRIC SHOCK Interference-Causing Equipment Regulations. DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO WARNING NOT REMOVE COVER. NO USER-SERVICEABLE This equipment has been tested and found to comply with the limits for PARTS INSIDE. REFER SERVICING TO QUALIFIED a Class A digital device, pursuant to Part 15 of the FCC Rules. These SERVICE PERSONNEL. limits are design

Summary of the content on the page No. 3

DOC avis de conformation ATTENTION Cet appareil numérigue de la classe A respecte toutes les exigences du RISQUE D’ELECTROCUTION Réglement sur le Matériel Brouilleur du Canada. NE PAS OUVRIR MISE EN GARDE: AFIN DE REDUIRE LES RISQUES D’ELECTRO- CUTION, NE PAS DEPOSER LE COUVERCLE, IL N’Y A AUCUNE PIECE UTILISABLE A L’INTERIEUR DE CET APPAREIL. NE CONFIER LES TRAVAUX D’ENTRETIEN QU’A UN PERSONNEL QUALIFIE. Ce symbole a pour but de prévenir l’utilisateur de la présence d’une tension dangereuse, n

Summary of the content on the page No. 4

unauthorized product modification, or failure to follow instructions supplied with LIMITED WARRANTY the product. NEC Multimedia Monitor Products • Repair or attempted repair by anyone not authorized by NECTECH. NEC Technologies, Inc.(hereafter NECTECH)warrants this product to be free from • Any shipment of the product (claims must be presented to the carrier). defects in material and workmanship under the following terms. • Removal or installation of the product. HOW LONG IS THE WARRANTY • Any o

Summary of the content on the page No. 5

CONTENTS 1. Introduction Introduction to the MultiSync XP37 Plus/XM37 Plus ............................................................... 1 Feature Highlights ...................................................................................................................... 1 2. Part Names and Functions Front View / Rear View ............................................................................................................. 3 Terminal Board .........................................

Summary of the content on the page No. 6

1 OSM and IPM are trademarks of NEC Technologies, Inc. • On-screen menus IBM PC/AT, PS/2, VGA, S-VGA, 8514/A and XGA are registered Plain English and clear instructions with graphic icons show you exactly trademarks of International Business Machines Corporation. how to adjust your screen image. Apple and Macintosh are registered trademarks of Apple Computer, • Flexible inputs Inc. Connect up to four different inputs at once and switch among them Microsoft is a registered trademark of Microsoft

Summary of the content on the page No. 7

3 Part Names and Functions Front View Rear View POWER DEGAUSS OFF ON VIDEO 1 VIDEO 2 RGB 1 RGB 2 POSITION/CONTROL PROCEED EXIT SCAN WIDTH HEIGHT SIDE PIN NORMAL NORMAL BRIGHT CONTRAST MUTE VOLUME RD-346E MULTIMEDIA MONITOR 79644641 STANDBY POWER /POWER 32 1 VIDEO 1 VIDEO 2 RGB AUDIO RGB 1 THROUGHPUT REMOTE EXTERNAL CONTROL VIDEO RGB PROCEED 1 1 R L () MONO IN BNC S BNC S IN/OUT EXIT IN IN IN 2 2 THROUGH OUT THROUGH THROUGH OUT THROUGH OUT HIGH 75Ω DIP SW OUT ON RGB 2 L () MONO R G B H/CS

Summary of the content on the page No. 8

5 Terminal Board 6 7 5 VIDEO 1 VIDEO 2 RGB AUDIO RGB 1 REMOTE EXTERNAL CONTROL THROUGHPUT VIDEO RGB PROCEED 1 1 IN R () L MONO BNC S BNC S IN/OUT EXIT IN IN IN 2 2 THROUGH OUT THROUGH THROUGH THROUGH OUT DIP SW OUT HIGH 75Ω OUT ON RGB 2 12345678 R G B H/CS V SPEAKER SELECT () L MONO HIGH 75Ω HIGH 75Ω INT EXT IN AC IN AUDIO AUDIO EXT SPEAKER () R L () MONO R L MONO RIGHT LEFT IN IN SPEAKRES MUST THROUGH HAVE MORE THAN OUT 5WATT RATING INPEDANCE 8 OHM THROUGH THROUGH OUT OUT HIGH 75Ω

Summary of the content on the page No. 9

7 Terminal Board 0 8 A 9 VIDEO 1 VIDEO 2 RGB AUDIO RGB 1 REMOTE EXTERNAL CONTROL THROUGHPUT VIDEO RGB PROCEED 1 1 IN R L () MONO BNC S BNC S IN/OUT EXIT IN IN IN 2 2 THROUGH OUT THROUGH THROUGH OUT THROUGH DIP SW OUT HIGH 75Ω OUT ON RGB 2 12345678 R G B H/CS V SPEAKER SELECT () MONO L HIGH 75Ω HIGH 75Ω INT EXT IN AC IN AUDIO AUDIO EXT SPEAKER L () MONO L () MONO RIGHT LEFT R R IN IN SPEAKRES MUST THROUGH HAVE MORE THAN OUT 5WATT RATING THROUGH THROUGH INPEDANCE 8 OHM OUT OUT HIGH 7

Summary of the content on the page No. 10

9 Terminal Board VIDEO 1 VIDEO 2 RGB AUDIO RGB 1 REMOTE EXTERNAL CONTROL THROUGHPUT VIDEO RGB PROCEED 1 1 IN R L () MONO BNC S BNC S IN/OUT EXIT IN IN IN 2 2 THROUGH OUT THROUGH THROUGH OUT THROUGH OUT HIGH 75Ω DIP SW OUT ON RGB 2 12345678 R G B H/CS V SPEAKER SELECT L () MONO HIGH 75Ω HIGH 75Ω INT EXT IN AC IN AUDIO AUDIO EXT SPEAKER R L () MONO R L () MONO RIGHT LEFT SPEAKRES MUST IN IN THROUGH HAVE MORE THAN OUT 5WATT RATING THROUGH THROUGH INPEDANCE 8 OHM OUT OUT HIGH 75Ω HIGH

Summary of the content on the page No. 11

11 Remote Control Unit NOTE: When not in use the remote control unit is conveniently stowed in the holder on the rear panel. 1 POWER ON/OFF Press POWER ON to turn the monitor on when the STANDBY/POWER indicator is lit red. Press POWER OFF to turn the monitor off and the monitor will go into the standby condition. POWER 2 DEGAUSS DEGAUSS OFF ON 1 2 Press to demagnetize the picture tube in the manual operation. See also VIDEO 1 VIDEO 2 RGB 1 RGB 2 page 27. 3 POSITION/CONTROL PROCEED 3 Input Selec

Summary of the content on the page No. 12

13 Raster Control 7 WIDTH (+ / -) Adjusts the horizontal size of the image. 8 HEIGHT (+ / -) Adjusts the vertical size of the image. 9 SIDE PIN (+ / -) POWER Adjusts the curvature of the edges of the left and right side of the display DEGAUSS OFF ON image either inward or outward. The image should be adjusted to attain a VIDEO 1 VIDEO 2 RGB 1 RGB 2 straight line on the left and right sides. 0 SCAN SELECT POSITION/CONTROL PROCEED Each time this key is pressed, the picture size switches from OVER

Summary of the content on the page No. 13

15 Battery Installation and Replacement The remote control is powered by two 1.5V AA batteries. 2. Install the two new batteries, making 1. Turn the remote control unit upside 3. Close the battery compartment cover. down. Press down on the battery sure that their polarity matches the (+) (-) diagrams inside the battery compartment grip and slide the compartment in the direction of the compartment. Incorrect polarity could damage the remote control unit. arrow. Remote Control Cautions • Do not dr

Summary of the content on the page No. 14

17 Set the No. 1 pin to the ON/SHORT position when sync on green signals are Functions of DIP SW necessary for synchronization with an external component. SHORT ON When a composite signal is present, the picture may be distorted. If this happens, set the No.2 pin to the OFF/OPEN position. 12 3 4 5 6 7 8 OPEN Functions and Settings of DIP SW This DIP switch is used for Sync. Control, Intelligent Power Manager, External control, wireless control, and OSM control. To change a switch setting use a p

Summary of the content on the page No. 15

HIROYUK AIZASUSUSUSUSSWA HIROYUK AIZ 19 Installation Wiring Diagram Macintosh or Compatibles IBM XGA/SuperVGA/VGA or Compatibles EXTERNAL CONTROL IBM/MAC MultiCable IBM/MAC MultiCable To EXTERNAL CONTROL (D-SUB 15 Pin input) To D-SUB 15 Pin input To D-SUB 15 Pin input XP37 Plus/XM37 Plus VIDEO 1 VIDEO 2 RGB AUDIO RGB 1 REMOTE EXTERNAL CONTROL THROUGHPUT VIDEO RGB PROCEED 1 1 IN R L () MONO BNC S BNC S IN/OUT EXIT IN IN IN 2 2 THROUGH OUT To R,G,B,H/CS, V inputs (BNC) THROUGH THROUGH TH

Summary of the content on the page No. 16

21 Connecting Your PC or Macintosh Computer Connecting your PC or Macintosh computer to your MultiSync XP37 Plus/ 3. Use the supplied MultiCable to connect your computer to the monitor. For a XM37 Plus via the MultiCable connection system will enable you to display PC, use the smaller 15-pin connector on the cable to connect to your your computer's screen image. All of these following display standards are computer's video port; use the larger 15-pin connector on the cable to con- supported: nec

Summary of the content on the page No. 17

23 3. Connect the external component stereo right channel audio input to R AU- Daisy-chaining Your monitors DIO. The REMOTE IN/OUT terminals allow you to control monitors by one remote 4. Set the 75Ω/HIGH impedance select switch of the corresponding input signal control. (BNC, S-VIDEO) on all but the last monitor to “HIGH” position. On only the NOTE: The connection of three XP37 Plus/XM37 Plus monitors or more with last monitor is set to the “75Ω” position. THROUGH OUT (VIDEO 1 or 2) terminals

Summary of the content on the page No. 18

25 External Speaker Connections If non-shielded speakers are used, they must be located a minimum of 4 feet away from the monitor. External speakers may be connected to the monitor to reproduce sound from VIDEO 1, VIDEO 2, RGB 1 or RGB 2 signal sources. SPEAKER SELECT INT EXT External speakers may be connected directly to the EXTERNAL SPEAKERS 4 ft. 4 ft. terminals or indirectly by connecting a stereo system amplifier to the audio Right Left 120cm 120cm outputs. VIDEO 1 VIDEO 2 RGB AUDIO THROU

Summary of the content on the page No. 19

27 NOTE 2: Select the over scan mode for VIDEO display. Operation 3. Adjust The Raster or The Picture Control. You can adjust the raster such as the horizontal size, vertical size or side Power pincushion correction, and the brightness and contrast of the image with the This section describes how to select a computer or video source and how to remote control. adjust the picture and sound. 4. Turning Off The monitor. General Controls Press the POWER OFF button on the remote control or press the P

Summary of the content on the page No. 20

29 c. HEIGHT Direct Control Screen Press to adjust the vertical size of the image. You can adjust the raster, visual and sound using the direct key on the remote control. To switch to another control screen, press any one of the other keys. d. SIDE PIN *To end the OSM display, press EXIT. Press to adjust the curvature of the edges of the left and right side of the *If no key operation is made within 3 seconds, the OSM display will disappear. display image either inward or outward. The image shou


Alternative user manuals
# User manual Category Download
1 NEC 175VXM User manual Computer Monitor 20
2 NEC 42VP4 User manual Computer Monitor 6
3 NEC 50XC10 User manual Computer Monitor 5
4 NEC 1850X User manual Computer Monitor 6
5 NEC 2000 Series User manual Computer Monitor 6
6 NEC 42XM3 PX-42XM3A User manual Computer Monitor 4
7 NEC 73V User manual Computer Monitor 15
8 NEC A Series User manual Computer Monitor 0
9 NEC 750F User manual Computer Monitor 0
10 NEC 90M User manual Computer Monitor 1
11 NEC AccuSync 90 User manual Computer Monitor 2
12 NEC AccuSync AS120 User manual Computer Monitor 0
13 NEC AccuSync AS171 User manual Computer Monitor 0
14 NEC AccuSync AS50M User manual Computer Monitor 0
15 NEC 4200W User manual Computer Monitor 0
16 Sony BVM-L170 User manual Computer Monitor 7
17 Sony DDM-2802CNU User manual Computer Monitor 1
18 Sony BVM-D20F1U, BVM-D20F1E, BVM-D20F1A, BVM-D24E1WU, BVM-D24E1WE, BVM-D24E1WA, BVM-D32E1WU, BVM-D32E1WE, BVM-D32E1WA User manual Computer Monitor 15
19 Sony 500A3WE User manual Computer Monitor 8
20 Sony CPD-17SF2 User manual Computer Monitor 10