Summary of the content on the page No. 1
Gas-on-glass cooktop
Installation instructions
CG733 model
and User guide
CG733
SG HK
Summary of the content on the page No. 2
Summary of the content on the page No. 3
1 Contents EN Safety and warnings 2 Installation instructions 6 Introduction 20 Using your cooktop 21 Care and cleaning 26 Troubleshooting 30 Warranty and service 31 Important! SAVE THESE INSTRUCTIONS The models shown in this manual may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please visit our local website listed on the back cover or contact your local Fis
Summary of the content on the page No. 4
2 Safety and warnings EN WARNING! Cut Hazard Take care - some panel edges are sharp. Failure to use caution could result in injury or cuts. WARNING! Electrical Shock Hazard Before carrying out any work on the electrical section of the appliance, it must be disconnected from the mains power supply. Connection to a good earth wiring system is essential and mandatory. Failure to follow this advice may result in death or electrical shock. Important safety precautions Installation Read these in
Summary of the content on the page No. 5
3 Safety and warnings EN This appliance should not be sealed into the bench with silicone or glue. Doing so will make future servicing difficult. Fisher & Paykel will not be liable for costs associated with releasing such a product, nor for repairing damage that may be incurred in doing this. Packing elements (eg plastic bags, polystrene foam, staples, packing straps etc) and tools should not be left around during and after installation, especially if they are within easy reach of children
Summary of the content on the page No. 6
4 Safety and warnings EN WARNING! Hot Surface Hazard This appliance becomes hot during use. Do not touch the cooktop components, burners, trivets/pan supports or the base when hot. Before cleaning, turn the burners off and make sure the whole cooktop is cool. Failure to follow this advice may result in serious injury. WARNING! Explosion Hazard Do not store fl ammable materials such as gasoline near the cooktop. Do not spray aerosols near the cooktop during use. Failure to follow this advice
Summary of the content on the page No. 7
5 Safety and warnings EN Important safety precautions Operation Keep children away from the cooktop when it is in use. Household appliances are not intended to be played with by children. Children, or persons with a disability which limits their ability to use the appliance, should have a responsible person to instruct them in its use. The instructor should be satisfied that they can use the appliance without danger to themselves or their surroundings. If the power supply cable is damaged
Summary of the content on the page No. 8
CG733 6 Installation instructions EN Cooktop and cutout dimensions Electrical connection is made at the left rear A B C E D H G F Cooktop and cutout dimensions (mm) overall width of cooktop 730 A overall depth of cooktop 430 B 53 C height of chassis (below top of bench) 700 D width of chassis depth of chassis 400 E F overall width of cutout 705 405 G overall depth of cutout max. 120 H corner radius of cutout
Summary of the content on the page No. 9
CG733 7 Installation instructions EN Clearances A E B C D Clearances (mm) minimum clearance from rear edge of cutout to: A 60 nearest combustible surface minimum clearance from glass surface to: rangehood 650 B any other overhead exhaust fan 800 downward-facing combustible surface (overhead cabinetry) 650 downwards-facing tiled or fi re resistant surface 500 minimum clearance from side edges of cutout to: C nearest combustible surface 213 minimum clearance below top of bencht
Summary of the content on the page No. 10
8 Installation instructions EN The appliance may be installed in a suitable room in accordance with the current laws in force. The appliance is designed and approved for domestic use only and should not be installed in a commercial, semi-commercial or communal environment. Installing the appliance in any of the above environments will void the warranty and could affect any third-party or public liability insurances you may have. The appliance must be installed in compliance with regul
Summary of the content on the page No. 11
9 Installation instructions EN Ventilation requirements Providing adequate ventilation The installer must refer to the current local regulations. Extractor The room accommodating the gas cooktop must have hood to extract steam adequate natural draught to allow combustion of the gas. The flow of air must come directly from one or more air vents 2 made in the outside walls with a free area of at least 100 cm (or refer to applicable local regulations). The vents must be
Summary of the content on the page No. 12
10 Installation instructions EN Fastening the cooktop to the bench 1 Turn the cooktop upside down and place it on a soft surface. 2 Spread the seal around the edges, with the adhesive side facing down. 3 Mount the supplied front and rear clamps (R) and screws (S) onto the cooktop, as shown (without tightening the screws). 4 Place the cooktop into the cutout, then tighten the screws to clamp the cooktop securely to the bench. 5 Using a sharp cutter or trimmer knife, trim the excess sealing mate
Summary of the content on the page No. 13
11 Installation instructions EN Gas installation requirements Important ! Before installation, make sure that the local distribution conditions (gas type and pressure) and the adjustment of this appliance are compatible. The appliance adjustment conditions are given on the plate or the label. This appliance must be installed and serviced only by a suitably qualified, registered installer with technical knowledge of both gas installation and electricity. The installation or servi
Summary of the content on the page No. 14
12 Installation instructions EN Gas Connection Note: Connection to the gas supply may be made using either a rubber hose (where permitted) or by using a flexible hose or rigid pipe. Gas connection with a rubber hose Important ! A rubber hose connection shall only be made if permitted by the applicable local regulations. The gas connection fitting (Fig. 5a) is made up of: the appliance inlet pipe; the floating nut; the brass elbow; the washers; the appropriate hose holder (for NATURAL
Summary of the content on the page No. 15
13 Installation instructions EN Connecting the appliance to NATURAL or TOWN GAS 1 If not already fitted, fit the NATURAL/TOWN GAS hose holder on the inlet pipe, making sure that you place the sealing washer between them (as shown in Fig. 5a). 2 Connect the appliance to the gas supply using a suitable rubber hose (internal diameter 13 mm). The hose must comply with the applicable local regulations and be of the correct construction for the type of gas being used. 3 Make sure that th
Summary of the content on the page No. 16
14 Installation instructions EN After connecting the appliance to the gas supply, make sure that you check the piping and connections using a soapy solution. The presence of bubbles indicated a leak. Tighten or replace connectons as appropriate, then recheck for leaks. Important! Do not use any naked flame to check for leaks. check whether the injectors are correct for the type of gas being used. If not, follow the instructions under “Converting the cooktop to a different gas type”. repl
Summary of the content on the page No. 17
15 Installation instructions EN the flexible hose is not longer than 2000 mm (or refer to applicable local regulations) and does not come into contact with sharp edges, corners, or moving parts, as these may cause abrasion. Use a single flexible hose only; never connect the appliance with more than one flexible hose. the flexible hose can easily be inspected along its entire length to check its condition; if it has an expiry date, it should be replaced before that date. if usi
Summary of the content on the page No. 18
16 Installation instructions EN Converting the cooktop to a different gas type Important! Only a suitably qualified and registered person may convert the cooktop to a different gas type. To convert from one gas type to another, you need to replace the injectors, and then adjust the minimum gas rate setting. Replacing the injectors 1 Remove the pan supports and burners from the cooktop. 2 Using a spanner, remove the injectors and replace them with ones suitable for the type of gas you are con
Summary of the content on the page No. 19
17 Installation instructions EN Table for the choice of injectors BURNER TYPE Semi-rapid Triple-ring NOMINAL POWER (W) 1750 3500 450 1500 REDUCED POWER (W) Additional Additional marking marking Natural Gas 20mbar 97 Z 135 T INJECTOR (1/100mm LPG 29mbar 65 - 95 - or marking) Town Gas 8mbar 190 2 340 6 Natural Gas 20mbar Adjustable Adjustable By-pass LPG 29mbar 34 - 65 - (1/100mm) Town Gas 8mbar Adjustable Adjustable
Summary of the content on the page No. 20
18 Installation instructions EN Electrical connection Important! This appliance must be earthed. Installation must be carried out according to the manufacturer’s instructions. Incorrect installation may cause harm and damage to people, animals or property, for which the manufacturer accepts no responsibility. If the installation requires alterations to the domestic wiring system, call a qualified electrician. The electrician should also check that the socket cable section is suitable f
