Summary of the content on the page No. 1
Table of Contents
1. IMPORTANT SAFETY INSTRUCTIONS ................................................................................. 4
2. DIMENSIONAL REQUIREMENTS .......................................................................................... 6
2.1 Product dimension .......................................................................................................................................... 7
3. UNPACKING, MOVING AND PLACING THE RANGE ......................................
Summary of the content on the page No. 2
Important Safety Instruction 1. IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS – Your Safety And the Safety of Others Are Very Important. We have provided many important safety messages throughout this manual and on your appliance. Read all instructions before using your appliance and always obey all safety messages. RECOGNIZE SAFETY INFORMATION This is a safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. UNDERSTAND SIGNAL WORDS
Summary of the content on the page No. 3
Important Safety Instruction To reduce the risk of fire, electrical shock, injury to persons, or damage when installing the range, some basic precautions must be followed, WARNING including: - Read all instructions - Proper installation is your responsibility. Have a qualified technician to install and ground this appliance, in accordance with these installation instructions. - It is the responsibility of the installer to comply with the installation clearances specified on the model/serial I.
Summary of the content on the page No. 4
Instructions for the Installer 2. DIMENSIONAL REQUIREMENTS 1 24” (61 cm) min. when bottom of wood or metal cabinet is protected by not less than ¼ “ (0.64 cm) flame retard millboard covered with not less than No. 28 MSG sheet steel, 0.015” (0.4 mm) stainless steel, 0.024” (0.6 mm) aluminium or 0.020” (0.5 mm) copper. When installed in a 24” (61 cm) base cabinet with 25” (63.5 cm) countertop – front of oven door protrudes 1-7/8” (4.8) cm beyond 24” (61 cm) base cabinet. 30” (76.2 cm) min. clearan
Summary of the content on the page No. 5
Instructions for the Installer 2.1 Product dimension Overall dimension: location of electrical connection points. 1 A 12” / - 310 mm 5 B 7” - 180 mm 3 C 6” / - 170 mm 4 Check location where the range will beinstalled. The range should be located for convenient use in the kitchen. NOTE: Observe all governing codes and ordinances. All openings in the wall or floor where range is to be installed must be sealed. Some cabinet and building materials are not designed to withstand the heat produced by t
Summary of the content on the page No. 6
Instructions for the Installer 3. UNPACKING, MOVING AND PLACING THE RANGE CAUTION: This unit is design as a cooking appliance. Based on safety considerations, never use it for warming or heating a room. - It is recommended that the grates, griddle plate and flame, burner caps, front kick panel and oven racks be removed to facilitate handling. This will reduce the weight for moving operations. - Remove the outer carton and packing material from the shipping base. - Remove angle-mounting brackets
Summary of the content on the page No. 7
Instructions for the Installer 4. WALL FIXING AND ANTI-TIP DEVICE - All ranges can tip WARNING - Injury to persons could result - Install anti-tip device packed with the range - See installation instructions FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN DEATH OR SERIOUS BURNS TO CHILDREN OR ADULTS. ELECTRIC SHOCK HAZARD WARNING - Use extreme caution when drilling holes into the wall or floor. There may be concealed electrical wires located behind the wall or under the floor. - Identif
Summary of the content on the page No. 8
Instructions for the Installer 4.3 Mounting the rear top upstand 1 Position the upstand above the top, taking care to align holes A with holes B. 2 Secure the upstand to the top by tightening screws C. 10
Summary of the content on the page No. 9
Instructions for the Installer 5. ELECTRICAL CONNECTION ELECTRIC SHOCK HAZARD - Disconnect power to the junction box before making connection - Electrically ground the appliance with green or green-yellow colored WARNING wire - Do not ground to a gas pipe - Check with a qualified electricial if you are not sure that the range is grounded - Do not have a fuse in the neutral or ground circuit FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN DEATH, FIRE OR SHOCK. Make sure that the power lin
Summary of the content on the page No. 10
Instructions for the Installer NOTE: Use this method only if local codes permit connecting cabinet-ground conductor to neutral wire of power supply cord WARNING ELECTRIC SHOCK HAZARD - Turn power supply off before connecting wires. WARNING - Electrically ground range. - Failure to follow these instructions can results in death, fire, or electrical shock. - Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or s
Summary of the content on the page No. 11
Instructions for the Installer 5.2 US installation and canadian installation / 4-wire branch circuit Refer to picture 2, - The ground wire must be attached first; - Connect the green or yellow-green ground wire from the appliance to the ground in the junction box (green colored wire). Do not connect grounding wire to neutral wire in junction box. - Connect the red leads from the appliance to the corresponding leads in the junctionbox. - Connect the white wire from the appliance to the neutral (w
