Summary of the content on the page No. 1
Acer
Aspire M5910(G)
Service Guide
PRINTED IN TAIWAN
Summary of the content on the page No. 2
Revision History Please refer to the table below for the updates made on this service guide. Date Chapter Updates ii
Summary of the content on the page No. 3
Copyright Copyright © 2010 by Acer Incorporated. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of Acer Incorporated. iii
Summary of the content on the page No. 4
Disclaimer The information in this guide is subject to change without notice. Acer Incorporated makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties of merchantability or fitness for any particular purpose. Any Acer Incorporated software described in this manual is sold or licensed "as is". Should the programs prove defective following their purchase, the buyer (and not Acer Incorporated, its dist
Summary of the content on the page No. 5
Conventions The following conventions are used in this manual: SCREEN Denotes actual messages that appear on screen. MESSAGES NOTE Gives additional information related to the current topic. WARNING Alerts you to any physical risk or system damage that might result from doing or not doing specific actions. CAUTION Gives precautionary measures to avoid possible hardware or software problems. IMPORTANT Reminds you to do specific actions relevant to the accomplishment of procedures. v
Summary of the content on the page No. 6
Service Guide Coverage This Service Guide provides you with all technical information relating to the BASIC CONFIGURATION decided for Acer's "global" product offering. To better fit local market requirements and enhance product competitiveness, your regional office MAY have decided to extend the functionality of a machine (e.g. add-on card, modem, or extra memory capability). These LOCALIZED FEATURES will NOT be covered in this generic service guide. In such cases, please contact your region
Summary of the content on the page No. 7
Table of Contents System Tour 1 Features 1 Block Diagram 4 System Components 5 Front Panel 5 Rear Panel 6 Hardware Specifications and Configurations 7 Power Management Function(ACPI support function) 10 System Utilities 11 CMOS Setup Utility 11 Entering CMOS setup 12 Navigating Through the Setup Utility 12 Setup Utility Menus 13 System Disassembly 26 Disassembly Requirements 26 Pre-disassembly Procedure 27 Removing the Side Panel 28 Removing the Heat Sink Fan Assembly 29 Removing t
Summary of the content on the page No. 8
FRU (Field Replaceable Unit) List 61 Aspire M5910(G) Exploded Diagram(AM551 ASSY) 62 Aspire M5910(G) Exploded Diagram(AM550 ASSY) 63 Aspire M5910(G) FRU List 64 viii
Summary of the content on the page No. 9
Chapter 1 System Tour Features Below is a brief summary of the computer’s many feature: NOTE: The features listed in this section is for your reference only. The exact configuration of the system depends on the model purchased. Operating System • Microsofte Windows 7 Home Premium 64-bit • Microsofte Windows 7 Home Basic 64-bit • Microsofte Windows 7 Home Premium 32-bit • Microsofte Windows 7 Home Basic 32-bit • Linpus X-window mode • FreeDos Processor • Socket Type: Intel Socket T LGA 1156 p
Summary of the content on the page No. 10
• 1GB to 16GB Max memory support • Design Criteria: • Must meet Intel Lynnfield and Clarkdale Chipset platform design guide Hard disk • Support up to two SATA ports • 3.5", 25.4mm • Capacity and models are listed on AVLC Optical disk • Support two SATA 5.25" standard ODD • Support DVD-ROM, DVD-SuperMulti, BD-combo, BD-rewrite • Maximum ODD depth to 185mm with bezel • Models are listed on AVLC Graphics card • No mechanical retriction to support for double slot, full length graphics cards in the s
Summary of the content on the page No. 11
USB ports • Ports Quantity: 12 • 6 back panel ports • On-board: 2 2*5 headers • 4 ports for front daughter board • Connector Pin: standard Intel FPIO pin definition • Data transfer rate support: USB 2.0/1.1 Extension slot • Support one PCIe x 16 slot • Support two PCIe x 1 slots • Support one PCI slot Total I/O ports • 1 PS/2 Keyboard port, • 1 PS/2 Mouse port • 1 D-Sub VGA port • 1 RJ45 LAN port • 6 USB ports • 3 ports Audio jack • One HD headphone output in front bezel • One MIC-IN in fro
Summary of the content on the page No. 12
Block Diagram 4 Chapter 1
Summary of the content on the page No. 13
System Components This section is a virtual tour of the system’s interior and exterior components. Front Panel 9 1 8 7 2 6 3 4 5 No. Component 1 USB 2.0 ports 2Acer logo 3 Optical drive button 4 Optical drive button (Removable HDD bay for AM551 bezel) 5 Removable HDD bay 6 Power button 7 16 in 1 Card Reader 8 Headphone/Speaker-out/line-out jack 9 Microphone-in jack Chapter 1 5
Summary of the content on the page No. 14
Rear Panel 1 13 2 12 11 3 10 4 9 5 8 6 7 No. Component 1 Power connector 2 PS2 keyboard port 3VGA port 4 USB 2.0 ports 5Mic-in 6 Line-out 7 Expansion slot (graphics card and TV tuner card and Mode card) 8 Line-in 9 USB 2.0 ports 10 LAN connector 11 System FAN 12 PS2 mouse port 13 Fan aperture 6 Chapter 1
Summary of the content on the page No. 15
Hardware Specifications and Configurations Processor Item Specification Processor Type CPUs which complaint with Intel FSB 800/1066/1333 MHz CPUs Socket Type Intel Socket T LGA 1156 pin Minimum operating speed 0 MHz (If Stop CPU Clock in Sleep State in BIOS Setup is set to Enabled.) BIOS Item Specification BIOS code programer AMI Kernel with Acer skin BIOS version P01-A0 BIOS ROM type SPI ROM BIOS ROM size 2Mb Support protocol SMBIOS(DMI)2.4/DMI2.0 Device Boot Support Support BBS spec 1st prio
Summary of the content on the page No. 16
Memory Combinations Slot Memory Total Memory Slot 1 1GB,2GB,4G 1G ~4GB Slot 2 1GB,2GB,4G 1G ~4GB Slot 3 1GB,2GB,4G 1G ~4GB Slot 4 1GB,2GB,4G 1G ~4GB Maximum System Memory Supported 1G~16GB System Memory Item Specification Memory slot number 4 slot Support Memory size per socket 1GB/2GB/4GB Support memory type DDRIII Support memory interface DDRIII 1066/1333 Support memory voltage 1.5V Support memory module package 240-pin DDRIII Support to parity check feature Yes Support to error correction co
Summary of the content on the page No. 17
SATA Interface Item Specification SATA controller PCH: Intel H57 SATA controller resident bus PCI bus Number of SATA channel SATA X 6 Support bootable CD-ROM YES USB Port Item Specification Universal HCI USB 2.0/1.1 USB Class Support legacy keyboard for legacy mode USB Connectors Quantity 6 back real ports 4 top bezel ports 2 H5X2 Hedaer Environmental Requirements Item Specification Temperature Operating +5°C ~ +35°C Non-operating -20 ~ +60°C (Storage package) Humidity Operating 15% to 80% RH
Summary of the content on the page No. 18
Power Management Function(ACPI support function) Device Standby Mode • Independent power management timer for hard disk drive devices(0-15 minutes,time step=1minute). • Hard Disk drive goes into Standby mode(for ATA standard interface). • Disable V-sync to control the VESA DPMS monitor. • Resume method:device activated (keyboard for DOS, keyboard &mouse for Windows. • Resume recovery time 3-5sec Global Standby Mode • Global power management timer(2-120minutes,time step=10minute). • Hard di
Summary of the content on the page No. 19
Chapter 2 System Utilities CMOS Setup Utility CMOS setup is a hardware configuration program built into the system ROM, called the complementary metal- oxide semiconductor (CMOS) Setup Utility. Since most systems are already properly configured and optimized, there is no need to run this utility. You will need to run this utility under the following conditions. • When changing the system configuration settings • When redefining the communication ports to prevent any conflicts • When modi
Summary of the content on the page No. 20
Entering CMOS setup 1. Turn on the server and the monitor. If the server is already turned on, close all open applications, then restart the server. 2. During POST, press Delete. If you fail to press Delete before POST is completed, you will need to restart the server. The Setup Main menu will be displayed showing the Setup’s menu bar. Use the left and right arrow keys to move between selections on the menu bar. Navigating Through the Setup Utility Use the following keys to move around t
