Summary of the content on the page No. 1
R R e e ff r r ii g g e e r r a a tt ii o o n n a a tt ii tt s s b b e e s s tt
Blast Chiller Operators Manual
Reach-In Models: VBC-35, VBC-70, VBC-75 & VBC-100
Roll-In Models: VBC-175, VBC-220, VBC-350,VBC-480 & VBC-660
Manual Part No. 50850502
Rev: 00
Print Date: 11/5/04
110 Woodcrest Road, Cherry Hill, NJ 08003
Phone: (856) 428- 4200 Fax: (856) 428-7299 Website: www.victory-refrig.com
E-Mail: parts@victory-refrig.com ● order-entry@victory-refrig.com ● service@victory-refrig.com
PARTOF
Summary of the content on the page No. 2
THANK Y O U Thank you for purchasing a Victory Refrigeration Reach-In or Roll-In Blast Chiller! This unit has passed our strict Quality Control Inspection and meets the high standards set by Victory Refrigeration. You have made a quality investment that with proper maintenance will give you years of service. Please read the following installation and maintenance instructions before installing or using your unit. If you have any questions, please call our Customer Service Department at (856) 4
Summary of the content on the page No. 3
Warranty (Continental USA Only) The Seller warrants to the original purchaser, equipment manufactured by Seller to be free from defects in material and workmanship for which it is responsible. The Seller's obligation under this warranty shall be limited to replacing or repairing at Seller's option, without charge, F.O.B. Sellers factory, any part found to be defective and any labor and material expense incurred by Seller in repairing or replacing such part, such warranty to be limited to a perio
Summary of the content on the page No. 4
Summary of the content on the page No. 5
TABLE OF CONTENTS Page 2 Receiving Shipment Unpacking Installation Electrical Supply Start-Up ● ● Main Control Breakers ● ● Initial Start-Up Error Code & Checks Page 3 Principals of Operation Loading and Packing Food Storage Time Operation of Blast Chillers Page 4 Operation of Blast Chillers (continued) Defrost Roll In Blast Chillers with Storage Pod The Controls Page 5 The Controls (continued) Programming A Blast Chill Cycle Alarm and Warning Levels Page 6 Alarm and Warning Levels (continued) T
Summary of the content on the page No. 6
Proper installation is the first step to operation. We recommend that your refrigerator or freezer be installed by an authorized Victory Certified Installer. RECEIVING SHIPMENT All units are performance tested and thoroughly inspected prior to shipment. Upon leaving the factory, all units are in perfect condition. Upon receipt, examine the exterior of the shipment packaging for any signs of rough handling. If the cabinet is damaged, it should be noted on the delivery slip or bill of lading and
Summary of the content on the page No. 7
PRINCIPLES OF OPERATION Victory blast chillers have been designed to quickly reduce the temperature of food in accordance with Department of Health guidelines on the chilling of cooked foods. All operators should be conversant with Department of Health publication, Chilled and Frozen Guidelines on Cook-Chill and Cook-Freeze Catering Systems. Fast temperature reduction is not brought about by placing the food in a very cold cabinet like a deep freeze. This would only dry the food badly and ta
Summary of the content on the page No. 8
Blast Chill Cycle: All machines have the facility for the operator to use any of the 4 pre-programmed timed cycles and a probe control blast chilling cycle, with the option of soft or hard blast. The probe controlled blast cycle functions via the food core probe supplied. The probe monitors the core temperature of the food and will not permit the blast cycle to stop until the default temperature (37°F\3°C) is reached. When controlling the cycle with the food probe make certain that the probe
Summary of the content on the page No. 9
1. The Cabinet Temp display window can be used: ❖ To show the cabinet wall temperature. ❖ As a count up timer in probe blast. 2. The Probe window can show: ❖ Temperature during a blast cycle, (blank during store). ❖ During a blast if a food probe fails it will display pf in its own window. At the end of a blast cycle it will indicate alarm code in Probe 1 window. 3. For a timed blast, the green row of LEDs show the progress of the blast. Each LED indicates another 1/10 of the total bla
Summary of the content on the page No. 10
7-SEG DISPLAY ALARM CONDITION a0 Air on sensor failure a1 Wall sensor failure a2 Fin sensor failure a3 Food probe 1 failure a4 Food probe 2 failure a5 Food probe 3 failure a6 Spare a7 Power cut detected Note: If a wall sensor fails it will also read -50. For each probe only one audible alarm and alarm printout is allowed to be issued each day. This is to prevent excessive paper use and noise nuisance in the event of an intermittent probe failure. However, repeated probe failures are displayed o
Summary of the content on the page No. 11
PRINTER SET UP (CAUTION!!! : DO NOT CHANGE any other parameters when setting the date & time! If additional parameters are changed, there is a great possibility that the VBC Cabinet will not function properly and will void warranty!) TIME AND DATE SET UP A. Enter the Engineering Switch Mode by doing the following: 1. Turn control panel "off" by pressing the "standby" button. 2. Press and hold the "1" button. 3. While continuing to hold the "1" button, press and release "standby" button. B. P
Summary of the content on the page No. 12
POWER FAILURE A power cut does not cause the loss of any accumulated historical data and no re-programming is necessary. The controllers battery is continually charged and provides emergency back up under normal power failure conditions. MAINTENANCE The cabinets are fully automatic in operation. Cleaning, loading printer paper, and changing out the print cartridge is the only maintenance required. Read the following topics. CLEANING Exterior: The exterior of the cabinet is stainless steel and
Summary of the content on the page No. 13
TECHNICAL SERVICE & REPLACEMENT PARTS Victory Refrigeration strives to provide excellent customer service along with quality equipment. To help us better assist you, a serial number and/or model number must be provided when contacting the technical service or parts department. The data plate is located inside the reach-in cabinet on the right side wall. Roll-in blast chiller data plates are placed on the exterior of the back panel that supports the controller. All serial numbers are recorded an
Summary of the content on the page No. 14
10
Summary of the content on the page No. 15
VBC PARTS LISTS 11
Summary of the content on the page No. 16
12 PARTS LIST FOR VICTORY BLAST CHILLER 35 (VBC-35) Item No Description Part No. 1 Comp CAJ 4492Y R134A 52000101 1a Coil Condenser 3 x 11 x 21 52000201 1b Drier 1/4 x 3/16 Sweat R134A 52000301 1c Sight Glass 1/4 Sweat 52000401 2 Receiver 2.2L 52000501 3 Valve Expansion Body Ten 2 R134A 52000601 3 Valve Adapter Solder 1/4 52000701 3 Orifice No. 00 068-2090 52000801 4 Motor Condenser Fan 16 Watt 52000901 4 Blade Cond Fan 10In 27Dg Pitch 52001001 5 Plate Condenser Fan 52001101 6 Motor Evap Fan 315
Summary of the content on the page No. 17
13 PARTS LIST FOR VICTORY BLAST CHILLER 70 (VBC-70) Item No Description Part No. 1 CONDENSING UNIT CAJ 4511Y HR 52077901 2 EVAPORATOR FAN 16 WATT 208V 60Hz UL 52078001 3 DEFROST HEATER 300W 1BEND 52078101 4 EVAPORATOR 3" x 20" x 20" 52078201 5 EXPANSION VALVE BODY TEN2 R134A 52000601 5 3/8" SOLDER ADAPTOR 068-2060 52010901 5 ORIFICE NO.2 068-2096 52071701 6 KLIXON 14T31 30210 L13C 9651 52004801 7 GASKET, 22" x 24" [560mm X 622mm] 52078301 7a PLUG, TOPHINGE 52078401 8 HINGE:SPRING LOADED 520022
Summary of the content on the page No. 18
14 PARTS LIST FOR VICTORY BLAST CHILLER 75 (VBC-75) Item No Description Part No. 1 Comp 1-1/2 FH4518Y 208/60 52020101 2 Coil Condenser 4 x 17 x 17.5 52010201 3 Motor Evap Fan (4) 200mm Axial 52010301 3 Guard Evap Fan Flat 52010401 3 Capacitor 230V 60Hz 1.5UF 52020201 4 Coil Evaporator 5 x 45 x 16 52020301 5 Sight Glass 3/8 Sweat 52010701 6 Drier 3/8 Suitable For R134A 52010801 7 Valve Expansion Body Tes 2 R134A 52020401 7 Adapter Solder 3/8 068-2060 52010901 7 Valve Orifice No. 3 52011001 8 Hea
Summary of the content on the page No. 19
15 PARTS LIST FOR VICTORY BLAST CHILLER 100 (VBC-100) Item No Description Part No. 1 Comp 2HP TFH 4524 Z 208/60/3 52020101 2 Coil Condenser 4 x 17 x 17.5 52010201 3 Motor Evap Fan (4) 200mm Axial 52010301 3 Guard Evap Fan Flat 52010401 3 Capacitor 230V 60Hz 1.5UF 52020201 4 Coil Evaporator 5 x 45 x 16 52020301 5 Sight Glass 3/8 Sweat 52010701 6 Drier 3/8 Suitable For R134A 52010801 7 Valve Expansion Body Tes 2 R404A 52020401 7 Solder Adapter 3/8 068-2060 52010901 7 Orifice No. 3 52011001 8 Heat
Summary of the content on the page No. 20
16 Victory Blast Chillers 175, 220 & 350 (VBC-175, VBC-220 & VBC-350) Panels Parts
