Summary of the content on the page No. 1
INSTALLATION AND
SERVICING MANUAL
GARLAND
S18-F AND S18-FS SERIES
RESTAURANT FRYERS
NRTL/C
PLEASE READ ALL SECTIONS OF THIS MANUAL
FOR YOUR SAFETY: AND RETAIN FOR FUTURE REFERENCE.
DO NOT STORE OR USE GASOLINE
THIS PRODUCT HAS BEEN CERTIFIED AS
OR OTHER FLAMMABLE VAPORS OR
COMMERCIAL COOKING EQUIPMENT AND
LIQUIDS IN THE VICINITY OF
THIS OR ANY OTHER
MUST BE INSTALLED BY PROFESSIONAL
APPLIANCE
PERSONNEL AS SPECIFIED.
INSTALLATION AND ELECTRICAL CONNECTION
WARNING:
MUST COMPLY WITH CUR
Summary of the content on the page No. 2
IMPORTANT INFORMATION WARNING: This product contains chemicals known to the state of California to cause cancer and/or birth defects or other reproductive harm. Installation and servicing of this product could expose you to airborne particles of glass wool/ceramic fibers. Inhalation of airborne particles of glass wool/ceramic fibers is known to the state of California to cause cancer. Page 2 Part # P156 Rev 1 (12/03/09)
Summary of the content on the page No. 3
TABLE OF CONTENTS IMPORTANT INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 . . . . . . . . . . . . DIMENSIONS AND SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . 4 . . . . . . . . . Exterior Dimensions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 . . . . . . . . . . . . . . . General I
Summary of the content on the page No. 4
DIMENSIONS AND SPECIFICATIONS North American (60 cycle) Electrical Loading: Nominal Amperes Per Line Total Model 208V/3Ø 240V/3Ø 480V/3Ø kW 208v/1Ø 240V/1Ø X Y Z X Y Z X Y Z S18F 12 58 50 34 34 34 28.9 28.9 28.9 15 15 15 S18SF 16 77 66.7 49 38 49 41.8 41.8 32.5 21 17 21 Export (50 cycle) Electrical Loading: Nominal Amperes Per Line Total kW Model 220/380V/ 240/415V/ 220/380/3Ø 240/415V/3Ø 220/380V 240/415V X Y Z X Y Z 1Ø 1Ø S18F 10.1 12 46.2 50 15.4 15.4 15.4 16.7 16.7 16.7 S18SF 13.4 16 61.1
Summary of the content on the page No. 5
DIMENSIONS AND SPECIFICATIONS continued Exterior Dimensions Model Height* Width Depth Weight S18-(F,SF) 37-3/4” (959mm) 18” (457mm) 34-1/2” (876mm) 140Lb/64Kg * Height from front rail to floor NOTE: Height Dimensions specified with 6” (152mm) legs. INTRODUCTION A qualified person must make the installation of these The following instructions should be read carefully as the products in accordance with the local codes of the country of manufacturer can not be held responsible for any damage d
Summary of the content on the page No. 6
INTRODUCTION continued When corresponding with the factory or equipment dealer Rating Plate regarding service problems or replacement parts, be sure For proper operation, the information on the data plate of to refer to the particular unit by the correct model number, the new equipment must match the electrical supply. The including prefix and suffix letters and numbers and serial data plate is readily accessible, located on the inside of the number. The rating plate affixed to the unit c
Summary of the content on the page No. 7
INSTALLATION continued The supply entrance is located at the rear. The supply Appliances Equipped With Legs terminal block is accessible from the front. The electrical All Fryers are shipped from the factory with legs installed supply must be adequate for the voltage, phase & current unless otherwise specified. When the fryer is specified for marked on the rating plate. dais or cove mounting it is shipped less legs. Legs must be NOTE: A means of disconnection from the supply having adjus
Summary of the content on the page No. 8
MAINTENANCE AND CLEANING Regular servicing by a competent person is recommended to 3. Check the temperature reading just when the control ensure the continued safe and efficient performance of the cycles “OFF” as indicated by the cycle pilot lamp. If the appliance. temperature does not read within 15°F (8°C) of the dial setting, recalibrate as follows: Thermostat Calibration 4. Carefully remove the thermostat dial, not disturbing the WARNING: Turn off the electrical mains before commencing d
Summary of the content on the page No. 9
FAULT FINDING FRYER DIAGNOSTICS PROBLEM POSSIBLE CAUSE SOLUTION Power indicator is on. One or more circuit breakers are off. Switch circuit breakers to the “ON” Heating indicator comes on. position. Fryer recovering or heating unevenly. One or more elements are defective. Replace Elements. Red indicator light is on. High temperature limit is tripped Operating thermostat may be defective Fryer is not heating. - Replace. Operating contractor may be defective - Replace Fryer will not start -
Summary of the content on the page No. 10
APPENDIX Wiring diagrams Page 10 Part # P156 Rev 1 (12/03/09)
Summary of the content on the page No. 11
Part # P156 Rev 1 (12/03/09) Page 11 TH2 Z HIGH LIMIT F=4.0kW F=4.0kW F=4.0kW 4kW/4.5kW 15 COM NO NC SF=4.5kW SF=7.0kW SF=4.5kW Y 14 17 18 19 X 16 4kW/7.0kW 30 22 4kW/4.5kW 22 13 20 28 23 AMBER 27 13 RED GREEN 40 43 29 45 41 11 42 44 K2 S1-1 TH2 21 10 TH1 K REGULATING S1-2 LIMIT CONTACTOR CONTACTOR K2 K SCHEMATIC DIAGRAM 1 PHASE 16 17 12 4 25 24 18 19 10 2 Z 14 15 5 Y 3 6 X 40 41 42 43 44 45 1 24 12 G GREEN, POWER ON F=30A 30A 30A SF=40A AMBER, HEATING 3 PHASE 1 5 6 2 3 4 S 4 TH1 26 29 SWITCH 26
Summary of the content on the page No. 12
Page 12 Part # P156 Rev 1 (12/03/09) N TH2 AMBER HIGH LIMIT F=4.0kW F=4.0kW F=4.0kW L3 4kW/4.5kW COM NO NC SF=4.5kW SF=7.0kW SF=4.5kW 12 5 10 7 11 6 L2 4kW/4.5kW 27 28 26 L1 4kW/7.0kW 29 26 RED 42 GREEN 23 13 22 40 41 10 11 4 K2 S1-1 TH2 17 TH1 K REGULATING S1-2 LIMIT CONTACTOR 24 CONTACTOR K2 18 K SCHEMATIC DIAGRAM 7 14 6 1 PHASE 5 14 21 15 15 N 4 19 16 16 20 L3 L2 18 3 41 42 40 L1 2 1 GREEN, POWER ON E AMBER, HEATING F=30A 30A SF=40A 30A 7 6 3 PHASE 5 N 4 S TH1 25 23 SWITCH 3 25 3 L3 THERMOSTA
Summary of the content on the page No. 13
Part # P156 Rev 1 (12/03/09) Page 13 TH2 Z HIGH LIMIT F=4.0kW F=4.0kW F=4.0kW 4kW/4.5kW 15 COM NO NC SF=4.5kW SF=7.0kW SF=4.5kW Y 14 17 18 19 X 16 4kW/7.0kW 30 22 4kW/4.5kW 22 13 20 28 23 27 13 1 RED 2 4 11 32 5 6 3 GREEN 21 31 10 K2 REGULATING LIMIT CONTACTOR S1-1 TH2 CONTACTOR K2 K SCHEMATIC DIAGRAM K TH1 AMBER S1-2 16 17 25 18 19 1 PHASE 10 14 15 4 2 Z 32 33 31 5 Y H3 H2 3 H H4 6 X 1 X4 X GREEN, POWER ON G 27 X2 X3 AMBER, HEATING 33 29 3 PHASE 2 S TH1 26 29 SWITCH 26 Z THERMOSTAT 4 11 5 30 Y
Summary of the content on the page No. 14
Page 14 Part # P156 Rev 1 (12/03/09) TH2 Z HIGH LIMIT F=4.0kW F=4.0kW F=4.0kW 15 4kW/4.5kW COM NO NC SF=4.5kW SF=7.0kW SF=4.5kW Y 14 17 18 19 X 16 4kW/7.0kW 30 22 4kW/4.5kW 22 13 20 28 23 27 13 1 RED 2 4 11 32 5 6 3 GREEN 21 31 10 K2 REGULATING S1-1 LIMIT CONTACTOR TH2 CONTACTOR K2 K SCHEMATIC DIAGRAM K TH1 AMBER S1-2 16 17 25 18 19 1 PHASE 10 14 15 4 2 Z 32 33 31 5 Y H3 H2 3 H H4 6 X 1 X4 X GREEN, POWER ON G 27 X2 X3 AMBER, HEATING 33 29 3 PHASE 2 S TH1 26 29 SWITCH 26 Z THERMOSTAT 4 11 5 30 Y
Summary of the content on the page No. 15
Part # P156 Rev 1 (12/03/09) Page 15
Summary of the content on the page No. 16
