Hoover H-WASH-300-PLUS user manual

The symbols on your Hoover H-WASH-300-PLUS washing machine indicate various wash programs, options, and special features available on your machine. Here are some common symbols that you may find on your machine:
1. Water Temperature: This symbol indicates the recommended water temperature for a specific program. For example, a symbol displaying three dots inside a square denotes a cold wash, whereas a symbol displaying a single dot inside a square represents a maximum temperature of 30°C. The number of dots may vary depending on the machine model.
2. Spin Speed: This symbol indicates the recommended spin speed for a particular program. It typically displays the maximum revolutions per minute (RPM) for the selected program.
3. Program Selection: Symbols representing different washing programs (e.g., cotton, synthetics, delicates, wool, etc.) allow you to choose the desired wash cycle based on the fabric type and level of dirtiness.
4. Rinsing Options: This symbol gives you options for additional rinsing cycles. You may find symbols indicating extra rinsing, reduced rinsing, or no rinsing at all.
5. Delay Start: A symbol with a clock signifies the option to set a delay start time for your washing cycle.
6. Special Features: Symbols representing additional features like quick wash, intensive wash, pre-wash, eco-mode, steam, or stain removal indicate the various options available on your washing machine to enhance your laundry experience.
It's always a good idea to refer to your Hoover H-WASH-300-PLUS washing machine's user manual for a comprehensive list of symbols and their meanings specific to your model.

To get your Hoover H-WASH 300 Plus washing machine out of demo mode, try the following steps:
1. Make sure the washing machine is turned off.
. Press and hold the "Temperature" and "Spin Speed" buttons simultaneously.
3. While holding these buttons, turn the washing machine on.
4. Continue holding the buttons until the display shows a countdown or a series of lines or dashes (this may take around 5-10 seconds).
5. Once the countdown or lines/dashes disappear, the washing machine should be out of demo mode and ready for regular use.
6. Turn off the washing machine and then turn it back on again to ensure the changes have been applied.
If these steps don't work, consult the user manual or contact Hoover customer support for further assistance.