Husqvarna 150BT user manual

There could be several reasons why your Husqvarna 150BT leaf blower dies when you give it gas. Here are a few possible causes to check:
1. Clogged or dirty carburetor: A dirty or clogged carburetor can restrict fuel flow, causing the engine to stall when you give it gas. Remove and clean the carburetor, ensuring that all the jets and passages are clear.
2. Fuel system issues: Check if there is old or stale fuel in the tank, as this can lead to engine problems. Drain old fuel and replace it with fresh, properly mixed fuel. Also, inspect the fuel filter and spark plug for any signs of clogging or damage.
3. Air intake blockage: If the air intake is blocked or restricted, the engine may not be receiving enough air to run properly. Inspect and clean the air filter to ensure proper airflow.
4. Ignition system problems: A faulty ignition system can cause the engine to stall. Check the spark plug for wear or damage, and replace it if necessary. Additionally, make sure the spark plug wire is securely attached to both the plug and the ignition module.
5. Engine overheating: If the engine is overheating, it may shut off when you give it gas. Check the cooling system, including the cylinder fins and cooling vents, for debris or blockages. Ensure that the engine is not running with a lean fuel mixture.
If you have checked these possible causes and are still experiencing problems, it might be best to consult a professional technician for further diagnosis and repair.

Mixing gas and oil for a Husqvarna 150BT leaf blower involves a few steps:
1. Empty your gas can if there's anything in it, but you should preferably use a new gas can.
2. Check your owner's manual for the recommended oil-to-gas ratio. For the Husqvarna 150BT, the recommended ratio is 50:1, meaning you'll mix 50 parts gasoline to 1 part oil.
3. Purchase a 2-cycle engine oil suitable for 50:1 ratio mix.
4. Pour the correct amount of 2-cycle oil into the gas can. If you're filling a 2.5-gallon gas can, you'll need 6.4 ounces of oil (2.5 gallons is approximately 320 ounces, and 320 divided by 50 equals around 6.4).
5. Slowly begin adding the gasoline to the gas can.
6. Stop halfway and slosh the gas can around to make sure the oil and gas mix together.
7. Continue filling the gas can with the gasoline.
8. After filling the can to your desired level, slosh it around some more to ensure a thorough mix.
9. Before every use, you should shake your fuel mixture to keep it well mixed as the oil can separate from the gas if left sitting for a while.
Remember, don't pour the oil directly into the fuel tank of your leaf blower, always mix it in a gas can first. Doing otherwise can damage the blower's engine.

Yes, the Husqvarna 150BT is a commercial-grade backpack leaf blower. It is designed for professional use and offers high performance and durability for demanding tasks.