JBL TUNE-120TWS user manual

Here's how you can pair your JBL Tune 120 earbuds:
1. Take the earbuds out of the charging case.
. Enter pairing mode by pressing and holding the left or right earbud button for 5 seconds until the LED starts to blink white.
3. On your device (smartphone, tablet, computer, etc.), go to the Bluetooth settings.
4. Scan for new devices.
5. Once your device finds the JBL Tune 120, click on it to pair.
6. If your device asks for a passcode, enter '0000' (four zeros).
7. Your JBL Tune 120 earbuds should now be connected.
Please note: If you've been using your earbuds with another device, you might need to reset them before they can be paired with a new device. To do this, put the earbuds back in the charging case, then press and hold the buttons on both earbuds for 5 seconds until the LED turns off. This will reset the earbuds and you can then follow the steps above to pair them with your new device.

The JBL Tune 120TWS takes approximately 2 hours to fully charge.

The JBL Tune 120TWS is equipped with 5.8mm dynamic drivers.