Maytag MHW5630HW user manual

To reset a Maytag washer, you can follow these steps:
1. Unplug the washer from the power outlet for at least one minute.
. After one minute, plug the washer back into the power outlet.
3. Open and close the washer lid or door firmly to ensure it is properly closed.
4. Select a new cycle or program by turning the cycle knob or pressing the appropriate buttons on the control panel.
5. Press the "Start" button to begin the new selected cycle.
6. Wait for the washer to complete the cycle, and it should be reset and ready to use.
Note: The specific reset process may vary depending on the model of your Maytag washer. It is best to consult the user manual or visit the official Maytag website for more accurate instructions tailored to your specific model.

There could be several reasons why your Maytag washer won't start. Here are a few common issues and troubleshooting steps you can try:
1. Power supply: Ensure that the washer is plugged into a functioning power outlet. Check if there is power to the outlet by plugging in another device or appliance.
2. Door or lid switch: If you have a front-loading washer, check if the door is properly closed. If the door or lid switch is faulty, the washer won't start. Inspect the switch for any damage or malfunction.
3. Control panel or electronic control board: Sometimes, the control panel or electronic control board can malfunction. Try resetting the control panel by unplugging the washer for a few minutes, then plugging it back in and trying to start it again.
4. Faulty motor or motor control board: If the motor or motor control board is defective, it can prevent the washer from starting. In this case, professional repair or replacement may be necessary.
5. Safety feature triggered: Some washers have safety features that prevent them from starting if certain conditions are not met, such as an unbalanced load or excessive water level. Check if any of these factors are affecting your washer's ability to start.
If none of these steps resolve the issue, it may be best to contact Maytag customer support or a professional appliance repair service for further assistance.

The capacity of the Maytag MHW5630HW washer is 4.5 cubic feet.

The Maytag MHW5630HW washer may display the following error codes:
1. F01 - This code indicates a primary control board failure.
. F02 - It signifies a drain problem. Make sure the drain hose is not kinked or clogged.
3. F03 - This error code indicates a water temperature sensor error. Ensure the hot and cold water supply valves are fully open.
4. F05 - It indicates a water temperature sensor failure or insufficient water temperature increase during a wash cycle.
5. F06 - This error code suggests a motor control unit failure. It could be caused by a faulty MCU or a wire harness connection issue.
6. F08 - It indicates a dispenser motor error. Check if the dispenser motor is running properly and if there are any obstructions in the dispenser area.
7. F09 - This code suggests a communication error between the main control board and the motor control unit.
8. F20 - It indicates a water inlet problem. Check if the water supply valves are fully open and the inlet screens are not clogged.
9. F21 - This error code suggests a drain pump problem. Ensure the drain pump is not clogged and is functioning correctly.
10. F22 - It indicates a door lock error. Check if the door is properly closed and the latch is not damaged.
11. F23 - This code signifies a door lock issue or a door latch problem.
12. F25 - It indicates a drive motor error. The motor may be overheating or there could be a motor control board failure.
If you encounter any of these error codes on your Maytag MHW5630HW washer, it is recommended to consult the appliance's user manual or contact Maytag customer support for further assistance or service.