Streszczenie treści zawartej na stronie nr. 1
INSTRUCTION MANUAL
3 CCD CAMERA
IK-TF9C
For Customer Use
Enter below the Serial #
which is located on the
bottom of the cabinet. Retain
this information for future
reference.
Model #: IK-TF9C
Serial #:
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class A digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. Th
Streszczenie treści zawartej na stronie nr. 2
SAFETY PRECAUTIONS Safety icons This manual contains safety instructions that must be observed in order to avoid potential hazards that could result in personal injuries, damage to your equipment, or loss of data. These safety cautions have been classified according to the seriousness of the risk, and the icons highlight these instructions as follows: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. Indicates a potentially hazardous situ
Streszczenie treści zawartej na stronie nr. 3
Note the following instructions when installing. • Do not cover the product by any material. • Do not put the product on an Inflammable material such as carpet or blanket. • Do not put the product in a narrow space, since the heat generated from the product may be difficult to emanate. If you do not follow the above, the heat generated by the product may cause fire. Do not put the product in direct sunshine and/or high temperature. The temperature inside the product may cause fire. Avoid setting
Streszczenie treści zawartej na stronie nr. 4
Copyright and Right of Portrait There may be a conflict with the Copyright Law and other laws when a customer uses, displays, distributes, or exhibits an image picked up by the camera without permission from the copyright holder. Please also note that transfer of an image or file covered by copyright is restricted to use within the scope permitted by the Copyright Law. TABLE OF CONTENTS 1. CAUTIONS ON USE AND INSTALLATION ..... 5 (4. 5) Changing the shading correction mode .....................
Streszczenie treści zawartej na stronie nr. 5
This product is 3CCD color camera with digital video output. 1. CAUTIONS ON USE AND INSTALLATION Carefully handle the units. Handling of the protection cap. • • Do not drop, or give a strong shock or vibration to Keep the protection cap away from children. Chil- the camera. This may cause problems. Treat the dren may put them into mouth or swallow them camera cables carefully to prevent cable prob- accidentally. The protection cap protects the im- lems, such as cable breakdown and loosened con-
Streszczenie treści zawartej na stronie nr. 6
3. NAMES AND FUNCTIONS 1 Prism faceplate 8 DC IN 12V terminal 2 DISP button 4 MENU UP button (AWB) DISP 6 DATA UP (AWB) button MENU DATA DC IN 12V PAGE 7 DATA DOWN button 5 MENU DOWN button 9 DIGITAL terminal 3 PAGE button [ Front ] [ Rear ] 12 10 11 [ Bottom ] [ Top ] 1 Prism faceplate The protection cap is attached on the lens mount portion. After removing the cap, mount the lens. Be careful not to scratch or touch the optical area. 2 DISP button Used when switching the display. PAGE button Us
Streszczenie treści zawartej na stronie nr. 7
4. CONNECTION 4. 1 Standard Connection Lens (not included) Cable (not included) IK-TF9C DC IN 12V Frame grabber board, Monitor Less than 4 mm image process DC power equipment etc. supply (not included) 4. 2 Cautions on Connection • When connecting the camera cables, unplug the power source of the camera and the other equipment connected. •We suggest using a C mount lens made for a 3CCD camera. When using another lens, the best camera performance of this camera may not be obtained. (For examp
Streszczenie treści zawartej na stronie nr. 8
5. OPERATION Refer to the item " 4. CONNECTION", connect each equipment correctly. 1 2 Turn on the connected equipment and the power source of the camera. Point the lens at the object, operate the lens iris adjustment, focus adjustment, etc.. 3 Refer to the item "5.1 White Balance", operate the adjustment. 4 5 Refer to the items "7. MODE SETTING BY ON SCREEN DISPLAY", select the necessary items. 5. 1 White Balance For the white balance adjustment for this unit, AWB (Automatic White Balance) and
Streszczenie treści zawartej na stronie nr. 9
Result displayed Meaning AWB NG Automatic white balance adjustment cannot be performed because the NOT AVAILABLE shutter speed mode is E.TRG mode. AWB NG Automatic white balance adjustment cannot be performed for other reasons. Such as no white area is included in an object, etc. MANU (Manual white balance) 2 • Set the MODE to MANU on the WHT BAL menu. (Refer to the item "7.2 (3) WHT BAL (white balance)".) •Shoot a known white object, adjust the white balance adjusting the levels of R GAIN and B
Streszczenie treści zawartej na stronie nr. 10
White Electronic shutter Gain Process Option balance 6. ITEMS CONTROLLED BY USING ON SCREEN DISPLAY Preset value Item Available selections (Factory setting) MODE MANU, SS, E. TRG MANU E. TRG 1P SNR, 1P SR, PW SNR, PW SR 1P SNR MANU speed OFF, 1/100s, 1/250s, 1/500s, 1/1000s, 1/2000s, OFF 1/4000s, 1/10000s, 1/25000s, 1/50000s, 1/1000000s Syncro. Partial read OFF 2H/1592H~1590H/1592H, OFF, 2FRM~512FRM OFF scan. Partial read 30fps 2H/1060H~1058H/1060H, OFF, 2FRM~512FRM Partial read 40fps 2H/774H~77
Streszczenie treści zawartej na stronie nr. 11
7. MODE SETTING BY ON SCREEN DISPLAY Various settings can be controlled on the unit by using the on screen menu displayed on the monitor. The contents once set are memorized even if the power source is turned off, so it is unnecessary to set again when using the unit next time. When the setting is performed, select the menu of the item to be set. 7. 1 Using the Menus When the power is turned on, the normal screen showing only the video signal appears. Change the output to each screen (video sign
Streszczenie treści zawartej na stronie nr. 12
7. 2 Menus • Select the menu to change the setting by referring the item "7.1 Using the Menus".) • When the [MENU UP], [MENU DOWN] buttons are pushed, the "→" on the screen moves up and down. Move the "→" to the item to change. Note: When performing the mode setting in the menu display while selecting ON in "PART" (refer to page 28) and E.TRG in "MODE", the display shows normal mode and then the camera returns the setting mode. ( 1 ) SHUTTER (Electronic shutter) The electronic shutter has thre
Streszczenie treści zawartej na stronie nr. 13
(1. 1) Changing each setting in MANU mode Move up down Set by pushing By pushing DATA UP, DOWN MENU UP, DOWN • Sutter mode MANU, SS, E.TRG -- SHUTTER -- • Sutter speed setting OFF, 100 (1/100s), 250 (1/250s), 500 (1/500s) MODE MANU 1000 (1/1000s), 2000 (1/2000s), 4000 (1/4000s) MANU 100 PART 10000 (1/10000s), 25000 (1/25000s) OFF 50000 (1/50000s)100000 (1/100000s) • Partial scanning switch OFF/30fps/40fps/E.30fps/E.40fps (a) Changing the shutter speed Set the "→" to MA
Streszczenie treści zawartej na stronie nr. 14
(1. 2) Changing each setting in SS (synchro. scan) mode Move up down Set by pushing By pushing DATA UP, DOWN MENU UP, DOWN • Sutter mode MANU, SS, E.TRG -- SHUTTER -- • Synchro. scanning setting OFF : 2H/1592H ∼ 1590H/1592H↔OFF↔2FRM↔512FRM MODE SS 30fps, E.30fps : 2H/1060H ∼ 1058H/1060H↔OFF↔2FRM↔512FRM SS OFF 40fps, E.40fps : 2H/774H↔772H/774H↔OFF↔2FRM↔512FRM PART OFF • Partial scanning switch OFF/30fps/40fps/E.30fps/E.40fps (a) Changing the shutter speed setting Set the "→" t
Streszczenie treści zawartej na stronie nr. 15
(1. 3) Changing each setting in E.TRG mode The E.TRG has four modes; 1P SNR, 1P SR, PW SNR, PW SR. First set the "→" to MODE and select E. TRG, then set the "→" to E.TRG and select the desired E.TRG mode. (1. 3. 1) Changing each setting in 1P SNR mode Move up down Set by pushing By pushing DATA UP, DOWN MENU UP, DOWN • Sutter mode MANU, SS, E.TRG -- SHUTTER -- • E.TRG mode 1P SNR, 1P SR, PW SNR, PW SR MODE E.TRG E.TRG 1P SNR • Input trigger pulse setting at 1P SNR and 1P SR TRG.P Input tri
Streszczenie treści zawartej na stronie nr. 16
(1. 3. 2) Changing each setting in 1P SR mode Move up down Set by pushing By pushing DATA UP, DOWN MENU UP, DOWN • Sutter mode MANU, SS, E.TRG -- SHUTTER -- • E.TRG mode MODE E.TRG 1P SNR, 1P SR, PW SNR, PW SR E.TRG 1P SR • Input trigger pulse setting at 1P SNR and 1P SR TRG.P Input trigger pulse : positive polarity EXP. 50ms Input trigger pulse : negative polarity PART OFF • Exposure time setting at 1P SNR and 1P SR 0.01 ms 0.02 ms 0.4 ms 1 ms 20 ms 50 ms
Streszczenie treści zawartej na stronie nr. 17
(1. 3. 3) Changing each setting in PW SNR mode Move up down Set by pushing By pushing DATA UP, DOWN MENU UP, DOWN • Sutter mode MANU, SS, E.TRG -- SHUTTER -- • E.TRG mode MODE E.TRG 1P SNR, 1P SR, PW SNR, PW SR E.TRG PW SNR TRG.P • Input trigger pulse setting at PW SNR and PW SR PART OFF Input trigger pulse : positive polarity Input trigger pulse : negative polarity • Partial scanning switch OFF/30fps/40fps/E.30fps/E.40fps (a) Changing the polarity of in
Streszczenie treści zawartej na stronie nr. 18
(1. 3. 4) Changing each setting in PW SR mode Move up down Set by pushing By pushing DATA UP, DOWN MENU UP, DOWN • Sutter mode MANU, SS, E.TRG -- SHUTTER -- • E.TRG mode MODE E.TRG 1P SNR, 1P SR, PW SNR, PW SR E.TRG PW SR TRG.P • Input trigger pulse setting at PW SNR and PW SR PART OFF Input trigger pulse : positive polarity Input trigger pulse : negative polarity • Partial scanning switch OFF/30fps/40fps/E.30fps/E.40fps (a) Changing the polarity of input
Streszczenie treści zawartej na stronie nr. 19
( 2 ) GAIN (Video gain) When the image is dark even if the lens iris is open, change the gain (video gain) to get the proper video level. For the gain adjustment of the unit, MANU (Manual) and OFF (0dB) modes are provided. 1 MANU (Manual gain) Gain adjustment is performed on the GAIN menu. The adjustment range is from 0dB to 18dB in 1dB steps. 2 OFF Gain is fixed at 0dB. Set the "→" to MODE, push the [DATA UP], [DATA DOWN], and select mode among MANU, OFF. (2. 1) Changing each setting in GAIN
Streszczenie treści zawartej na stronie nr. 20
( 3 ) WHT BAL (White balance) WHT BAL has two modes; AWB, MANU. Set the "→" to MODE, push the [DATA UP], [DATA DOWN], and select mode among AWB, MANU. (3. 1) Changing each setting in AWB (Automatic White Balance) mode Move up down Set by pushing By pushing DATA UP, DOWN MENU UP, DOWN -- WHT BAL -- MODE AWB • White balance mode setting (AWB, MANU) R GAIN 0 Automatically adjusting value for red gain and blue gain B GAIN 0 are shown on the screen C.TEMP 3200 * These values may not be changed
