Instrukcja obsługi Audiovox 50-0301x-019 SERIES

Streszczenie treści zawartej na stronie nr. 1

FOR
50 - - 002 SERIES 1181334
50 - - 014 SERIES 1181332
50 - - 019 SERIES 1181336
FORD EXPLORER / MERCURY MOUNTAINEER
VCP HOUSING




of product during installat






- 7180 or equiv.)




-
Printed in the U.S.A

0040A INSTALLATION INSTRUCTION # 44
Nov. 8, 1999
5. Audiovox VCP (AVP
4. Razor knife or similar 3. Awl or similar tool
2.

Streszczenie treści zawartej na stronie nr. 2

1 10 1 2 2 2 3 1 4 1 FOAM TAPE, 3/4" X 3/4" X 14" 5 2 - 0040A Nov. 8, 1999 Printed in the U.S.A.

Streszczenie treści zawartej na stronie nr. 3

1. Retract storage cover, remove 2. Fold rear seat forward. - - the floor. Route the power lead to a fused ground to the VCP location. See Figure 2. Connect per n 4. Remove and retain (2) two # 8 X 9/16" screws (item 1 Separate VCP pg 2). Do not overtighten screws.

Streszczenie treści zawartej na stronie nr. 4

7. . 8. ) two # 8 VCP. Do not overtighten screws. 4 FIGURE 6 to side panel. Remove VCP housing. Lightly mark the location where housing mates 9. Place VCP housing (item 4 pg 2) over VCP. FIGURE 5 See Fig. 5. X 3/4" screws (item 2 pg 2) into original holes in Secure VCP to mounting bracket using (2 your

Streszczenie treści zawartej na stronie nr. 5

bottom of VCP bracket. See Figure 7. mounting bracket using (2) two # 8 X 9/16" screws, sure Velcro tape adheres to bottom of VCP housing. 13. 14. 15. 5 FIGURE 9 location. Replace storage cover, if applicable, in original Raise seat into locked upright position. h