Instrukcja obsługi Extron electronic sVN-MATRIX 225

Streszczenie treści zawartej na stronie nr. 1

VNM Recorder • Setup Guide
The Extron VNM Recorder is a network storage device used to digitally record and
play back multiple streams of high resolution video, audio, and data encoded to an
IP network via VN-Matrix encoders and decoders. It can be used with any VN-Matrix
application to document, archive, review, and play back highly sophisticated or demanding AV imagery.
This guide provides basic instructions for an experienced installer to configure and operate a VNM Recorder using a basic

Streszczenie treści zawartej na stronie nr. 2

VNM Recorder • Setup Guide (Continued) Step 7 — Configure the VNM Recorder Network Settings The VNM Recorder is pre-configured with the following network settings: IP address: 192.168.254.254 Subnet mask: 255.255.255.0 NOTE: Using these settings, the VN-Matrix 200 / 225 / 300 / 325 devices must use IP addresses within the range of 192.168.254.1 through 192.168.254.253 and use the same subnet mask. The example in figure 1 uses the default settings of the VNM Recorder. Use the following proc

Streszczenie treści zawartej na stronie nr. 3

g. Near the bottom of this file are two values named st_controlIp and st_localIp0 (see figure 4). Edit these Edit this value to match values as follows: the IP address of the controller device. z If the VNM Recorder is the controller device, edit both values to match the IP address of the recorder. z If the recorder is not the controller device, change the st_controlIp value to match the IP address of the Edit this value to match the IP address of the controller device. Change the st_local

Streszczenie treści zawartej na stronie nr. 4

VNM Recorder • Setup Guide (Continued) Step 2 — Configure the VN-Matrix 200 / 225 / 300 / 325 Devices as Encoders or Decoders For the VNM Recorder to work properly, the VN-Matrix 200 / 225 / 300 / 325 devices must be configured so that at least one device is an encoder and one device is a decoder. For configuration instructions for the VN-Matrix 200 / 225 / 300 / 325 devices, see the setup guides included with these devices. Step 3 — Setup a Stream Storage Location a. From the Device List page