Streszczenie treści zawartej na stronie nr. 1
OWNER’S MANUAL
Read and understand this entire manual before riding!
DO NOT RETURN TO STORE!
NOTE: E100/125 must be traveling
3mph before motor will engage. Kick start to
3mph then twist the throttle to start motor. Item Numbers
E100 13100E-BL
E125 13125E-BK Black
13111110 Red
E200 13200E-SL
E200S 13201S-SL
E225S 13112850
E300 13300E-SL
E300S 13301S-SL
E325S 13116390
E_Series_Manualv10.indd 1 3/10/06 2:10:49 PM
Streszczenie treści zawartej na stronie nr. 2
CONTENTS Safety Warnings ............................................................ 1 Troubleshooting Guide ............................................ 11-12 Before You Begin ........................................................... 2 E100, E200 and E300 Scooter Parts ...................... 13-18 Assembly and Set-Up ................................................. 3-4 Safety Reminders .......................................... Back Cover Repair and Maintenance ............................
Streszczenie treści zawartej na stronie nr. 3
BEFORE YOU BEGIN Remove contents from box. Remove the foam separators that protect the components from damage during WARNING: shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have DO NOT USE NON-RAZOR occurred during shipping. Because the scooter was 95 percent assembled and packed at the factory, there PRODUCTS WITH YOUR should not be any problems, even if the box has a few scars or dents. RAZOR E100, E200 or E300 SCOOTER. The s
Streszczenie treści zawartej na stronie nr. 4
ASSEMBLY AND SET-UP ❑ Charging the Battery WARNING: Always Your electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery disconnect your scooter from prior to use. the charger before cleaning with • Initial charge time: 12 hours • Run time: up to 40 minutes liquid. • Recharge time: up to 8 hours, • Average battery life: 250 charge/discharge cycles Battery should be recharged Note: If your charger does not a minimum of 8 hours
Streszczenie treści zawartej na stronie nr. 5
ASSEMBLY AND SET-UP ❑ Adjusting the Handlebar Height WARNING: Failure to properly engage the quick- release clamp may cause the T-tube to move up or down while riding, which may cause you to lose control and fall. With the quick-release properly adjusted and engaged, the handlebars will not move up or down. Note: Be careful not to over- 1 Pull the quick-release lever 2 Slide the T-tube to the 3 The tension of the quick- tighten. You should be able release clamping mechanism out
Streszczenie treści zawartej na stronie nr. 6
REPAIR AND MAINTENANCE ❑ Infl ating the Tires Tires are infl ated when shipped, but they invariably lose some pressure between the point of manufacturing and your purchase. WARNING: Failure E200/E300 Rear Tire to remove the valve adapter after infl ating will cause the inner tube and/or adapter to be severed by the rear drive sprocket. Note: If you lose the adapter, a valve stem extender can be purchased at almost any auto parts store. 1 Use the special valve 2 Align the access h
Streszczenie treści zawartej na stronie nr. 7
REPAIR AND MAINTENANCE ❑ Adjusting the Chain Tools required: 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches. Note: This system of adjusters is common to motorcycles and BMX bicycles. If you are not familiar with it or do not feel comfortable performing the ad- justment, consult an authorized Razor service center or a quali- fi ed BMX bike or motorcycle mechanic. The chain should be “just taut” 1 Using two 17mm wrenches, 2 Using two 8mm wrenches, 3 Using a 10mm wrench, –
Streszczenie treści zawartej na stronie nr. 8
REPAIR AND MAINTENANCE ❑ Chain and Rear Tire Replacement Tools required: Phillips screwdriver, 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches. 1 With a Phillips screwdriver, 2 With a 10mm wrench, 3 With two 8mm wrenches, loosen the two screws and loosen the brake cable anchor loosen brake housing anchor remove the chain guard. and disconnect the cable. and disconnect. Keep the spacer and washers together. 4 With a 10mm wrench, loosen 5 With two 17mm wrenches, 6 Pull the wh
Streszczenie treści zawartej na stronie nr. 9
REPAIR AND MAINTENANCE 10 Install the axle adjusters 11 Tighten both axle adjust- 12 Tighten the brake housing and axle nuts. Tighten until they ers the same number of turns anchor securely. Test ride and just barely hold the hardware to fi ne-tune the tension on the check. Readjust as needed. in place. chain and to approximately maintain the centering of the wheel. 13 Replace the chain guard. 8 E_Series_Manualv10.indd 9 3/10/06 2:11:07 PM
Streszczenie treści zawartej na stronie nr. 10
REPAIR AND MAINTENANCE ❑ Front Tire Replacement Tools required: 10mm wrench, two (2) 17mm wrenches and a fl athead screwdriver. 1 (E100 Only) Loosen 2 Using two 17mm wrenches, 3 Remove wheel and replace the brake pad bolt and remove loosen the front axle bolts by tire. To reinstall wheel, reverse one brake pad. turning the wrenches counter these steps. Helpful hint: You clockwise. may need to use a fl athead screwdriver to center the axil and the bolts. 9 E_Series_Manualv10.indd 10 3/10/06
Streszczenie treści zawartej na stronie nr. 11
REPAIR AND MAINTENANCE WARNING: If a ❑ Battery Care and Disposal battery leak develops, avoid Do not store the battery in temperatures above 75° or below -10° F. contact with the leaking acid and place the damaged battery CONTAINS SEALED LEAD BATTERY. BATTERY MUST BE RECYCLED. in a plastic bag. Refer to the disposal instructions at left. If Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in acid comes into contact w
Streszczenie treści zawartej na stronie nr. 12
TROUBLESHOOTING GUIDE Problem Possible Cause Solution Scooter does not run Undercharged battery Charge the battery. A new battery should have been charged for at least 12 hours before using the scooter for the fi rst time and up to 8 hours after each subsequent use. Check all connectors. Make sure the charger connector is tightly plugged into the charging port, and that the charger is plugged into the wall. Charger is not working Make sure power fl ow to the wall outlet is on. Loose wires
Streszczenie treści zawartej na stronie nr. 13
TROUBLESHOOTING GUIDE Problem Possible Cause Solution Refer to adjusting the brakes instructions on page 4. Sometimes the scooter Brakes are not adjusted properly doesn’t run, but other Check all wires around the motors and all connectors to make sure times it does Loose wires or connectors they are tight. Charger gets warm Motor or electrical switch Contact your local Razor authorized service center for diagnosis and repair. during use damage No action required. This is normal for some ch
Streszczenie treści zawartej na stronie nr. 14
E100 PARTS Keep your scooter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifi cations subject to change without notice.) 32 Adjusting eye assembly, rear axle 1 Grip, right side no fl ange 2 Anti-friction Spacer, throttle 33 Locknut for axle adjusting eye 34 Washer, rear axle 3 Throttle 35 Washer, clipped for rear axle 4 T-Bar 5 Brake Lever 36 Spacer, rear outside, non-drive side 37 Axle, rear 6 Screw 38 Bearing,
Streszczenie treści zawartej na stronie nr. 15
E100 PARTS 14 E_Series_Manualv10.indd 15 3/10/06 2:11:12 PM
Streszczenie treści zawartej na stronie nr. 16
E200 PARTS Keep your scooter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifi cations subject to change without notice.) 1 Grip, right side no fl ange 35 Nut, axle fi xing rear 36 Axle adjusting eye assembly 2 Anti-friction spacer, throttle 37 Locknut for axle adjusting eye 3 Throttle 38 Washer, rear axle 4 T-bar 5 Brake lever 39 Washer, clipped for rear axle 40 Spacer, rear outside, non-drive side 6 Screw 41 Ax
Streszczenie treści zawartej na stronie nr. 17
E200 PARTS 16 E_Series_Manualv10.indd 17 3/10/06 2:11:13 PM
Streszczenie treści zawartej na stronie nr. 18
E300 PARTS Keep your scooter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifi cations subject to change without notice.) 1 Grip, right side no fl ange 35 Nut, axle fi xing rear 36 Axle adjusting eye assembly 2 Anti-friction spacer, throttle 37 Locknut for axle adjusting eye 3 Throttle 38 Washer, rear axle 4 T-bar 5 Brake lever 39 Washer, clipped for rear axle 40 Washer 6 Screw 41 Spacer, rear outside, non-drive
Streszczenie treści zawartej na stronie nr. 19
E300 PARTS 18 E_Series_Manualv10.indd 19 3/10/06 2:11:14 PM
Streszczenie treści zawartej na stronie nr. 20
SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC VEHICLE. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT. 19 E_Series_Manualv10.indd 20 3/10/06 2:11:14 PM
