Streszczenie treści zawartej na stronie nr. 1
INSTALLATION
R
INSTRUCTIONS
Publicly traded on NASDAQ Symbol: NSSC
HARDWIRE WIRELESS
GEM-P1664
CONTROL PANEL/COMMUNICATOR
For use with "Classic" keypads (GEM-RP1CAe2, GEM-RP2ASe2, GEM-RP3DGTL and GEM-RP4RFC/GEM-RP4C)
and with "K Series" keypads (GEM-K1CA, GEM-K2AS, GEM-K3DGTL, and GEM-K4RF/GEM-K4)
GEMINI
SYSTEM READY
GEMINI
SYSTEM ARMED
09/01/05 12:00 AM
01/01/97 12:00AM AC ON READY
READY
AC ON
NEXT/YES
NEXT/YES
P
R 1 2 3
R A123 E
U PRIOR/NO
PRIOR/NO
Q D
B
Streszczenie treści zawartej na stronie nr. 2
THIS MANUAL INCLUDES FEATURES WHICH ARE ONLY AVAILABLE IN GEM-P1664 CONTROL PANEL FIRMWARE VERSION 1.0 OR LATER. IMPORTANT NOTICE GEM-P1664 panel version 01 requires the use of the following version keypads: • GEM-RP1CAe2 Version 9A, GEM-K1CA Version 9A • GEM-RP2ASe2, Version 7, GEM-K2AS, Version 7 • GEM-RP3DGTL, Version 3, GEM-K3DGTL, Version 3 • GEM-RP4RF, Version 2, GEM-K4/K4RF, Version 2 Upon entering program mode, the keypad display will flash the control panel firmware version,
Streszczenie treści zawartej na stronie nr. 3
WI1424A 1/06 Page 3 TABLE OF CONTENTS BASIC OPERATION ...............................................20 INTRODUCTION ..................................................... 4 User Codes & Zone Descriptions .............................20 General Description ................................................ 4 Arming and Disarming the System ...........................21 Features .................................................................. 4 Bypassing Zones ..........................
Streszczenie treści zawartej na stronie nr. 4
Page 4 WI1424A 1/06 INTRODUCTION GENERAL DESCRIPTION Napco's Gemini GEM-P1664 is a state-of-the-art microcomputer-based burglary and residential fire alarm control panel of modular design. Integrally an 8-zone panel, it will support up to 64 zones with the use of zone doubling, optional zone expansion modules, wireless receiver modules and/or GEM-RP1CAe2/GEM-K1CA Keypads. Each panel includes an integral digital communicator. The control panel features programmable area partitioni
Streszczenie treści zawartej na stronie nr. 5
Features WI1424A 1/06 Page 5 Communicator Features Compatible with all major receiver formats, including 4/2, SIA and Point ID (except Radionics Modem II). TM Rotary dial and TouchTone with Rotary backup. Three 20-digit telephone numbers. Backup Reporting; Double Reporting; Split Reporting. 64 User Codes with Opening/Closing -Reporting by user. AC Failure Reporting with programmable report delay. Supervised telephone line with a fixed 60 second delay. Pager capability. Ke
Streszczenie treści zawartej na stronie nr. 6
Page 6 WI1424A 1/06 SPECIFICATIONS GEM-P1664 Operating Temperature: 0-49°C (32-120°F) Input Power: 16.5-18.0 VAC via CLASS 2 Plug-In 20VA, 40VA or 50VA Transformer Loop Voltage: 10-13Vdc Loop Current: 3mA without Zone Doubling, 2.4mA with Zone Doubling using a 2.2K Ohm end-of-line resistor (Model EOL2.2K); 5mA for 2-wire smoke-detector zones; 1.4 mA using a 3.9K Ohm resistor (Model EOL3.9K) with Zone Doubling; 3mA with Se- ries Zone with Loop Supervision and 3mA with Series Zone Doubl
Streszczenie treści zawartej na stronie nr. 7
Ordering Information WI1424A 1/06 Page 7 VERI-PHONE: Two-Way Voice/Listen-In Module ORDERING INFORMATION PCD-Windows: Downloading Software (for Windows) System Components for IBM PC-Compatible, V5.0 or greater GEM-P1664: Residential UL-Listed Burg and Fire PCI2000/3000: Software Interface for IBM PC- Control Panel. Compatible Computer* GEM-RP1CAe2: 32-Character LCD Burg & Fire Keypad PCI-MINI: Notebook Computer Interface* with 4 EOL Zones. W834-1: Keypad Cable, plug-in (20”) GEM
Streszczenie treści zawartej na stronie nr. 8
Page 8 WI1424A 1/06 Smoke Detectors, 4-Wire: 1. ESL 445AT, 445C, 445CT, 445CR, 445CRT 2. Hochiki America SLG-12 with YBC-RL4-RA Base 3. System Sensor 2312/24T; 1412; 1412TH; 2412TH Subtract total smoke-detector alarm current from available standby current. Note: Any normally-open devices that do not require power from the control panel, such as pull stations and thermostats may be used if acceptable to the Authority having Jurisdiction. UL Compatible Smoke Detectors (Providing UL Reco
Streszczenie treści zawartej na stronie nr. 9
Mounting WI1424A 1/06 Page 9 INSTALLATION CAUTION: This equipment generates and uses radio-frequency energy. If not installed using conventional installation practices for RF devices, it may cause interference to radio and television reception. It has been tested and found to comply with the limits for a Class A computing device pursuant to Subpart B of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference. However, there is no guarantee tha
Streszczenie treści zawartej na stronie nr. 10
Page 10 WI1424A 1/06 Wiring Wire keypad(s), zones, expansion zone modules and output devices as shown on the Wiring Diagram. Note that the Wiring Diagram contains important information not available elsewhere in this manual. CAUTION: Do not run telephone wiring near speaker wires; do not run keypad wiring with loop wiring. Adding Expansion Zones GEM-P1664 control panel can support up to 16 zones as is, however this number may be increased to as many as 64 programmable zones using opti
Streszczenie treści zawartej na stronie nr. 11
Testing the System WI1424A 1/06 Page 11 TESTING THE SYSTEM After installation is completed, test the system as follows. 1. Call the central station to inform them of the test. 2. Initiate an alarm, preferably on a zone that activates a steady siren, and verify proper signalling. 3. Call the central station to confirm their receipt of a good transmission. Note: Be sure to test all enabled keypad panics. Signal Strength Testing/Wireless Systems To test the operation of wireless tr
Streszczenie treści zawartej na stronie nr. 12
Page 12 WI1424A 1/06 WIRING CONNECTIONS BATTERY The RED (+) and BLACK (-) flying leads must be connected to a 12VDC 4-7 AH Rechargeable Battery, to serve as 7 backup power in the event of AC Power Failure. NOTE: To calculate the available standby time refer to the Standby- Battery Calculation Worksheet at the back of this manual. TRANSFORMER (The following applies to installations in the United States of America): Connect a 16.5 VAC Transformer to Terminals 1 and 2, using a wire of
Streszczenie treści zawartej na stronie nr. 13
Wiring Connections: Remote Bus & Earth Ground WI1424A 1/06 Page 13 REMOTE BUS NOTE: Refer to the EZM Installation Instructions for specific wiring information. REMOTE BUS AVAILABLE DEVICES AVAILABLE DEVICES 1. KEYPADS: GEM-RP2AS & GEM-1. R PKEY 1CAeP 2ADS: GEM-RP1CAe2, GEM-RP2ASe2, GEM-RP3DGTL, GEM- 2. X-10 INTERFACE: GEM-X10 RP4 series, GEM-K1CA, GEM-K2AS, GEM-K3DGTL, GEM-K4 series, ADDITIONAL 3. WIRED ZONE EXPANDER: GEM-EZM816 (7 maximum) 4. W
Streszczenie treści zawartej na stronie nr. 14
Page 14 WI1424A 1/06 BASIC ZONE CONFIGURATION The basic zone configuration for the GEM-P1664 is 8 zones. Connect as shown above to terminals 13-24. Normally Closed (N. C.) devices may be wired in series or Normally Open (N.O.) (–) devices may be wired in parallel. Use the 2.2K Ohm end-of-line (E. O.L.) resistor in each zone, if selected in programming (refer to the GEM-P1664 Programming Instructions). Zones 1-8 can be selected for a “Fast Loop Response (50 ms)” or a “Normal Loop Resp
Streszczenie treści zawartej na stronie nr. 15
Wiring Connections: 4-Wire Smoke Detectors & 2-Wire Smoke Detectors WI1424A 1/06 Page 15 4-WIRE SMOKE DETECTORS 4-WIRE SMOKE DETECTOR WIRING The GEM-P1664 can use conventional 12 VDC 4-wire smoke detectors. To use them, select fire zone programming option and do not select 2-wire smoke detector programming option for the desired fire zone (refer to the GEM-P1664 Programming Instructions). Set JP3 to the position as shown, if zones 7 or 8 are to be used. Four wire smoke detectors may
Streszczenie treści zawartej na stronie nr. 16
Page 16 WI1424A 1/06 TELEPHONE LINES RING TIP RING TIP Model 368 Cord RING TIP Connect the Model 368 Cord as follows: 26 (RED = Telco Ring), 27 (GREEN = Telco Tip), 28 (GRAY = Home Ring) and 29 (BROWN = Home Tip). Insert the modular plug into an approved USOCRJ31X jack (or a CA31A jack for Canadian installations). The Telco Line is used by the control panel to dial the central station and for downloading. This line should not be connected to party lines or coin operated telephones. If
Streszczenie treści zawartej na stronie nr. 17
Keypad Configuration Mode WI1424A 1/06 Page 17 KEYPAD CONFIGURATION MODE This section will focus on configuring the GEM-RP1CAe2/GEM-K1CA and GEM-RP2ASe2/GEM-K2AS Keypads. We recommend that either a GEM-RP1CAe2 or a GEM-K1CA keypad be used for programming. KEYPAD INSTALLATION Each keypad must be assigned an address number (1–7) and each requires its own configuration procedure (see CONFIGURING THE KEYPADS, which follows, and DIRECT ADDRESS KEYPAD AREA OPTIONS). At least 1 keypad mu
Streszczenie treści zawartej na stronie nr. 18
Page 18 WI1424A 1/06 Compatibility Number (Not Applicable) New THIS FEATURE IS NOT COMPATIBLE WITH THE GEM-P1664 CON- Compat # 0000 TROL PANEL. DO NOT CHANGE THIS SETTING. Press the A or R button to continue or press the C button to exit. EZM Address EZM Address The keypad's internal EZM (Expansion Zone Module) may be utilized to provide four additional wired zones. Whether used alone or in conjunction 00 with optional GEM-EZM series modules or other keypad EZMs, i
Streszczenie treści zawartej na stronie nr. 19
Keypad Configuration Mode WI1424A 1/06 Page 19 Configuring the GEM-RP2ASe2/GEM-K2AS and GEM-RP3DGTL/GEM-K3DGTL Keypads Up to 7 GEM-RP2ASe2/GEM-K2AS keypads may be connected to the panel (Keypads 1–7). Each must be configured for a keypad address. In addition, the keypad may be configured to disable (a) touchpad backlight; (b) LCD backlight; and (c) entry sounder. Keypads are configured by the proper selection of jumpers. Refer to the label on the circuit board "fishpaper" for jumper
Streszczenie treści zawartej na stronie nr. 20
Page 20 WI1424A 1/06 BASIC OPERATION This section provides a brief overview of system operation. For detailed operation, refer to the User's Guide furnished with the keypad (see page 7 for a listing of User Guides for each keypad) and to the Keypad Programming Modes at the end of this manual. NOTE: Keypad displays shown in this text are for the GEM-RP1CAe2/GEM-K1CA keypads. GEM-RP2ASe2/GEM-K2AS displays will be similar, although abbreviated, and will scroll automatically. USER CODE
