Instrukcja obsługi Chief Manufacturing Single Ceiling Mount PCS Series

Streszczenie treści zawartej na stronie nr. 1

INSTALLATION INSTRUCTIONS
Single Ceiling Mount
PCS SERIES

Streszczenie treści zawartej na stronie nr. 2

PCS SERIES Installation Instructions DISCLAIMER WARNING: Failure to read, thoroughly understand, and Milestone AV Technologies, Inc., and its affiliated corporations follow all instructions can result in serious personal injury, and subsidiaries (collectively, "Milestone"), intend to make this damage to equipment, or voiding of factory warranty! It is the manual accurate and complete. However, Milestone makes no installer’s responsibility to make sure all components are claim that the informati

Streszczenie treści zawartej na stronie nr. 3

Installation Instructions PCS SERIES LEGEND Tighten Fastener Pencil Mark Apretar elemento de fijación Marcar con lápiz Befestigungsteil festziehen Stiftmarkierung Apertar fixador Marcar com lápis Serrare il fissaggio Segno a matita Bevestiging vastdraaien Potloodmerkteken Serrez les fixations Marquage au crayon Loosen Fastener Drill Hole Aflojar elemento de fijación Perforar Befestigungsteil lösen Bohrloch Desapertar fixador Fazer furo Allentare il fissaggio Praticare un foro Bevestiging losdraa

Streszczenie treści zawartej na stronie nr. 4

PCS SERIES Installation Instructions TOOLS REQUIRED FOR INSTALLATION 5/32" (Provided) PARTS A (1) B (1) 5/32" 4

Streszczenie treści zawartej na stronie nr. 5

Installation Instructions PCS SERIES INSTALLATION WARNING: FAILURE TO PROVIDE ADEQUATE 1 STRUCTURAL STRENGTH FOR THIS COMPONENT CAN RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component. (A) Attaching Mount to NPT Pipe CAUTION: Watch for pinch points. Do not place f

Streszczenie treści zawartej na stronie nr. 6

PCS SERIES Installation Instructions Remove bolt 1 or padlock 2 if used To use as a more 4 permanent lock, remove pin and nuts and move to lower holes. Pin in "Closed" 5 position - move to "Open" position to remove display A padlock or bolt may be placed through latch holes 4 Figure 4 Removing Display 1. Disconnect all power/audio/video cables. 2. Remove bolt or padlock from faceplate (if used). (See Figure 5) NOTE: The pin may have been used as a more permanent Pin in locking device. If so, rem

Streszczenie treści zawartej na stronie nr. 7

Installation Instructions PCS SERIES Pitch Adjustment Screw Roll Adjustment Nut Figure 6 7

Streszczenie treści zawartej na stronie nr. 8

PCS SERIES Installation Instructions USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378 P 800.582.6480 / 952.894.6280 F 877.894.6918 / 952.894.6918 Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands Chief Manufacturing, a division of P +31 (0)40 2668620 Milestone AV Technologies F +31 (0)40 2668615 Asia Pacific A Room 24F, Block D, Lily YinDu International Building LuoGang, BuJi Town, Shenzhen, CHINA. 8805-000167 Rev. C 2008 Milestone AV Technologies P +86-755-8996 9226 www.c