Instrukcja obsługi Hans Grohe Uno 38020XX1

Streszczenie treści zawartej na stronie nr. 1

Installation Instructions / Warranty
Uno²
38020XX1
38025XX1
38210XX1
90540401 2/2005

Streszczenie treści zawartej na stronie nr. 2

Uno single control lavatory faucet 38020XX1 Uno tall single control lavatory faucet 38025XX1 Uno single control bidet faucet 38210XX1 Technical Specification Maximum water pressure 145 psi Recommended water pressure 14.5 - 72 psi o Maximum hot water temp. 176 * o o Recommended hot water temp 120 - 140 * Max. flow rate @ 45 psi 2.2 gpm Max. deck thickness 1 3/8” Hole size in deck 1 3/8” *Many municipalities require that the water heater be set o no higher than 120 . Please know and follow all ap

Streszczenie treści zawartej na stronie nr. 3

Installation Instructions • Sit the faucet with black sealing ring in the faucet hole on top of the mounting surface. • From beneath, install the friction washer, metal washer, and mounting nut. Tighten the mounting nut, taking care not to overtighten. sealing ring • Check the position of the faucet. When satisfied, use a slot-headed screwdriver to tighten the tensioning screws. friction washer • Feed the pull rod through the hole in the metal back of the faucet body. washer • Attach the suppl

Streszczenie treści zawartej na stronie nr. 4

Install the pop-up drain • Remove the plunger assembly. • Unscrew the drain outlet flange from the tee. • Unscrew the tailpiece from the tee. Wrap the threads with plumbers’ thread tape and replace. • Install the white, flexible sealing gasket to the flange. Sit it in the sink outlet. • From under the sink, install the black mack gasket, white friction ring , and retainer nut to the flange. Do not tighten the nut against the bottom of the sink at this time. • Thread the tee and tailpiece to t

Streszczenie treści zawartej na stronie nr. 5

User Instructions • Pivot the handle back to turn the water on, and forward to turn the water off. • Pivot the handle to the left to make the water warmer, to the right to make the water cooler. Re-set the high temperature limit stop (optional) This step should be taken if the faucet is to be used by small children or others who should be protected from scalding. • Pull out the screw cover, located on the back of the handle. • Use a 4 mm allen wrench to loosen the set screw. • Pull off the nut c

Streszczenie treści zawartej na stronie nr. 6

Cleaning Recommendation for Hansgrohe Products Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and functionality. To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the Hansgrohe warranty. Cleaning Materials for Faucets and Showers • To remove lime scale, use only products made specifically for that purpose. Always follow the manufacturer’

Streszczenie treści zawartej na stronie nr. 7

THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: A. Conditions, malfunctions or damage not resulting from defects in material or workmanship. B. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any manner contrary to the product instructions. C. Labor or other expenses

Streszczenie treści zawartej na stronie nr. 8

Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 Tel. 770 360-9880 • Fax 770 360 9887 www.hansgrohe-USA.com